اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدIntrinsic Electronic Defect States of Anatase using Density Functional Theory
95
0
0.0
(
0
)
تأليف
Abhishek Raghav
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this work an overall electronic structure including the position and formation energies of various intrinsic defects are computed for anatase using Density Functional Theory aided by Hubbard correction (DFT+U). The intrinsic point defects considered here are, oxygen vacancy ($V_O$), oxygen interstitial ($O_i$), titanium vacancy ($V_{Ti}$) and titanium interstitial ($Ti_i$). Out of all the intrinsic defects considered here, $V_{Ti}$ and $Ti_i$ are found to be most stable under equilibrium condition. Whereas, conduction band in anatase is consisted of mainly Ti 3d with a minor component of O 2p states, valence band is found to be mainly composed of O 2p with a minor contribution from Ti 3d states. $V_O$ and $Ti_i$ are found to form localized states in the band gap. Moreover, anisotropy in the effective mass is seen. Finally, an alignment of band diagrams for all the intrinsic defect states is performed using vacuum potential from slab-supercell calculation as reference. This first principle study would help in the understanding of defect-induced insulating to conducting transition in anatase, which would have significant impact in the photocatalytic and optoelectronic area.
قيم البحث
اقرأ أيضاً
Ab initio calculations using the local spin density approximation and also including the Hubbard $U$ have been performed for three low energy configurations of the interface between LaAlO$_3$ and TiO$_2$-anatase. Two types of interfaces have been con
sidered: LaO/TiO$_2$ and AlO$_2$/TiO, the latter with Ti-termination and therefore a missing oxygen. A slab-geometry calculation was carried out and all the atoms were allowed to relax in the direction normal to the interface. In all the cases considered, the interfacial Ti atom acquires a local magnetic moment and its formal valence is less than +4. When there are oxygen vacancies, this valence decreases abruptly inside the anatase slab while in the LaO/TiO$_2$ interface the changes are more gradual.
We perform first principles simulations for the structural, elastic and electronic properties of orthorhombic samarium orthoferrite $SmFeO_3$ within the framework of density functional theory. A number of different density functionals, such as local
density approximation, generalized gradient approximation, Hubbard interaction modified functional, modified Becke$-$Johnson approximation and Heyd$-$Scuseria$-$Ernzerhof hybrid functional have been used to model the exact electron exchange-correlation. We estimate the energy of the ground state for different magnetic configurations of $SmFeO_3$. The crystal structure of $SmFeO_3$ is characterized in terms of the lattice parameters, atomic positions, relevant ionic radii, bond lengths and bond angles. The stability of the $SmFeO_3$ orthorhombic structure is simulated in terms of its elastic properties. For the electronic structure simulations, we provide estimates based on density functionals with varying degrees of computational complexities in the Jacobs ladder.
We carried out Heyd-Scuseria-Ernzerhof hybrid density functional theory plane wave supercell calculations in wurtzite aluminum nitride in order to characterize the geometry, formation energies, transition levels and hyperfine tensors of the nitrogen
split interstitial defect. The calculated hyperfine tensors may provide useful fingerprint of this defect for electron paramagnetic resonance measurement.
The success of descriptor-based material design relies on eliminating bad candidates and keeping good candidates for further investigation. While DFT has been widely successfully for the former, often times good candidates are lost due to the uncerta
inty associated with the DFT-predicted material properties. Uncertainty associated with DFT predictions has gained prominence and has led to the development of exchange correlation functionals that have built-in error estimation capability. In this work, we demonstrate the use of built-in error estimation capabilities within the BEEF-vdW exchange correlation functional for quantifying the uncertainty associated with the magnetic ground state of solids. We demonstrate this approach by calculating the uncertainty estimate for the energy difference between the different magnetic states of solids and compare them against a range of GGA exchange correlation functionals as is done in many first principles calculations of materials. We show that this estimate reasonably bounds the range of values obtained with the different GGA functionals. The estimate is determined as a post-processing step and thus provides a computationally robust and systematic approach to estimating uncertainty associated with predictions of magnetic ground states. We define a confidence value (c-value) that incorporates all calculated magnetic states in order to quantify the concurrence of the prediction at the GGA level and argue that predictions of magnetic ground states from GGA level DFT is incomplete without an accompanying c-value. We demonstrate the utility of this method using a case study of Li and Na-ion cathode materials and the c-value metric correctly identifies that GGA level DFT will have low predictability for NaFePO$_4$F.
We develop numerical methods to calculate electron dynamics in crystalline solids in real-time time-dependent density functional theory employing exchange-correlation potentials which reproduce band gap energies of dielectrics; a meta generalized gra
dient approximation (meta-GGA) proposed by Tran and Blaha [Phys. Rev. Lett. 102, 226401 (2009)] (TBm-BJ) and a hybrid functional proposed by Heyd, Scuseria, and Ernzerhof [J. Chem. Phys. 118, 8207 (2003)] (HSE). In time evolution calculations employing the TB-mBJ potential, we have found it necessary to adopt a predictor-corrector step for stable time-evolution. Since energy functional is not known for the TB-mBJ potential, we propose a method to evaluate electronic excitation energy without referring to the energy functional. Calculations using the HSE hybrid functional is computationally expensive due to the nonlocal Fock-like term. We develop a computational method for the operation of the Fock-like term in Fourier space, for which we employ massively parallel computers equipped with graphic processing units. To demonstrate significances of utilizing potentials providing correct band gap energies, we compare electronic excitations induced by femtosecond laser pulses using the TB-mBJ, HSE, and a simple local density approximation (LDA). At low laser intensities, electronic excitations are found to be sensitive to the band gap energy: results using TB-mBJ and HSE are close to each other, while the excitation of the LDA calculation is more intensive than the others. At high laser intensities close to a damage threshold, we have found that electronic excitation energies are similar among the three cases.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
