اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAdjustable coupling and in-situ variable frequency EPR probe with loop-gap resonators for spectroscopy up to X-band
63
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In standard electron paramagnetic resonance (EPR) spectroscopy, the frequency of an experiment is set and the spectrum is acquired using magnetic field as the independent variable. There are cases in which it is desirable instead to fix the field and tune the frequency such as when studying avoided level crossings. We have designed and tested an adjustable frequency and variable coupling EPR probe with loop-gap resonators (LGRs) that works at a temperature down to 1.8 K. The frequency is tuned by adjusting the height of a dielectric piece of sapphire inserted into the gap of an LGR; coupling of the microwave antenna is varied with the height of antenna above the LGR. Both coupling antenna and dielectric are located within the cryogenic sample chamber, but their motion is controlled with external micrometers located outside the cryostat. The frequency of the LGR can be adjusted by more than 1 GHz. To cover a wide range of frequencies, different LGRs can be designed to cover frequencies up to X-band. We demonstrate the operation of our probe by mapping out avoided crossings for the Ni$_4$ single-molecule magnet to determine the tunnel splittings with high precision.
قيم البحث
اقرأ أيضاً
In this article we discuss the design and implementation of a novel microstrip resonator which allows for the absolute control of the microwaves polarization degree for frequencies up to 30 GHz. The sensor is composed of two half-wavelength microstri
p line resonators, designed to match the 50 Ohms impedance of the lines on a high dielectric constant GaAs substrate. The line resonators cross each other perpendicularly through their centers, forming a cross. Microstrip feed lines are coupled through small gaps to three arms of the cross to connect the resonator to the excitation ports. The control of the relative magnitude and phase between the two microwave stimuli at the input ports of each line allows for tuning the degree and type of polarization of the microwave excitation at the center of the cross resonator. The third (output) port is used to measure the transmitted signal, which is crucial to work at low temperatures, where reflections along lengthy coaxial lines mask the signal reflected by the resonator. EPR spectra recorded at low temperature in an S= 5/2 molecular magnet system show that 82%-fidelity circular polarization of the microwaves is achieved over the central area of the resonator.
Beta gallium oxide (beta-Ga2O3) is an emerging ultrawide band gap (4.5 - 4.9 eV) semiconductor with attractive properties for future power electronics, optoelectronics, and sensors for detecting gases and ultraviolet radiation. beta-Ga2O3 thin films
made by various methods are being actively studied toward such devices. Here, we report on the experimental demonstration of single-crystal beta-Ga2O3 nanomechanical resonators using beta-Ga2O3 nanoflakes grown via low-pressure chemical vapor deposition (LPCVD). By investigating beta-Ga2O3 circular drumhead structures, we demonstrate multimode nanoresonators up to the 6th mode in high and very high frequency (HF / VHF) bands, and also realize spatial mapping and visualization of the multimode motion. These measurements reveal a Youngs modulus of E_Y = 261 GPa and anisotropic biaxial built-in tension of 37.5 MPa and 107.5 MPa. We find that thermal annealing can considerably improve the resonance characteristics, including ~40% upshift in frequency and ~90% enhancement in quality (Q) factor. This study lays a foundation for future exploration and development of mechanically coupled and tunable beta-Ga2O3 electronic, optoelectronic, and physical sensing devices.
We fabricated NiFe$_textrm{2}$O$_textrm{x}$ thin films on MgAl$_2$O$_4$(001) substrates by reactive dc magnetron co-sputtering varying the oxygen partial pressure during deposition. The fabrication of a variable material with oxygen deficiency leads
to controllable electrical and optical properties which would be beneficial for the investigations of the transport phenomena and would, therefore, promote the use of such materials in spintronic and spin caloritronic applications. We used several characterization techniques in order to investigate the film properties, focusing on their structural, magnetic, electrical, and optical properties. From the electrical resistivity measurements we obtained the conduction mechanisms that govern the systems in high and low temperature regimes, extracting low thermal activation energies which unveil extrinsic transport mechanisms. The thermal activation energy decreases in the less oxidized samples revealing the pronounced contribution of a large amount of electronic states localized in the band gap to the electrical conductivity. Hall effect measurements showed the mixed-type semiconducting character of our films. The optical band gaps were determined via ultraviolet-visible spectroscopy. They follow a similar trend as the thermal activation energy, with lower band gap values in the less oxidized samples.
The rising need for hybrid physical platforms has triggered a renewed interest for the development of agile radio-frequency phononic circuits with complex functionalities. The combination of travelling waves with resonant mechanical elements appears
as an appealing means of harnessing elastic vibration. In this work, we demonstrate that this combination can be further enriched by the occurrence of elastic non-linearities induced travelling surface acoustic waves (SAW) interacting with a pair of otherwise linear micron-scale mechanical resonators. Reducing the resonator gap distance and increasing the SAW amplitude results in a frequency softening of the resonator pair response that lies outside the usual picture of geometrical Duffing non-linearities. The dynamics of the SAW excitation scheme allows further control of the resonator motion, notably leading to circular polarization states. These results paves the way towards versatile high-frequency phononic-MEMS/NEMS circuits fitting both classical and quantum technologies.
Coplanar microwave resonators made of 330 nm-thick superconducting YBCO have been realized and characterized in a wide temperature ($T$, 2-100 K) and magnetic field ($B$, 0-7 T) range. The quality factor $Q_L$ exceeds 10$^4$ below 55 K and it slightl
y decreases for increasing fields, remaining 90$%$ of $Q_L(B=0)$ for $B=7$ T and $T=2$ K. These features allow the coherent coupling of resonant photons with a spin ensemble at finite temperature and magnetic field. To demonstrate this, collective strong coupling was achieved by using DPPH organic radical placed at the magnetic antinode of the fundamental mode: the in-plane magnetic field is used to tune the spin frequency gap splitting across the single-mode cavity resonance at 7.75 GHz, where clear anticrossings are observed with a splitting as large as $sim 82$ MHz at $T=2$ K. The spin-cavity collective coupling rate is shown to scale as the square root of the number of active spins in the ensemble.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
