اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLocalized Triggering of the Insulator-Metal Transition in VO2 using a Single Carbon Nanotube
468
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Vanadium dioxide (VO2) has been widely studied for its rich physics and potential applications, undergoing a prominent insulator-metal transition (IMT) near room temperature. The transition mechanism remains highly debated, and little is known about the IMT at nanoscale dimensions. To shed light on this problem, here we use ~1 nm wide carbon nanotube (CNT) heaters to trigger the IMT in VO2. Single metallic CNTs switch the adjacent VO2 at less than half the voltage and power required by control devices without a CNT, with switching power as low as ~85 ${mu}W$ at 300 nm device lengths. We also obtain potential and temperature maps of devices during operation using Kelvin Probe Microscopy (KPM) and Scanning Thermal Microscopy (SThM). Comparing these with three-dimensional electrothermal simulations, we find that the local heating of the VO2 by the CNT play a key role in the IMT. These results demonstrate the ability to trigger IMT in VO2 using nanoscale heaters, and highlight the significance of thermal engineering to improve device behaviour.
قيم البحث
اقرأ أيضاً
Assembling transition metal dichalcogenides (TMDCs) at the two-dimensional (2D) limit is a promising approach for tailoring emerging states of matter such as superconductivity or charge density waves (CDWs). Single-layer (SL) VSe$_2$ stands out in th
is regard because it exhibits a strongly enhanced CDW transition with a higher transition temperature compared to the bulk in addition to an insulating phase with an anisotropic gap at the Fermi level, causing a suppression of anticipated 2D ferromagnetism in the material. Here, we investigate the interplay of electronic and lattice degrees of freedom that underpin these electronic phases in SL VSe$_2$ using ultrafast pump-probe photoemission spectroscopy. In the insulating state, we observe a light-induced closure of the energy gap on a timescale of 480 fs, which we disentangle from the ensuing hot carrier dynamics. Our work thereby reveals that the phase transition in SL VSe$_2$ is driven by electron-lattice coupling and demonstrates the potential for controlling electronic phases in 2D materials with light.
Synchrotron X-ray total scattering studies of structural changes in rutile VO2 at the metal-insulator transition temperature of 340 K reveal that monoclinic and tetragonal phases of VO2 coexist in equilibrium, as expected for a first-order phase tran
sition. No evidence for any distinct intermediate phase is seen. Unbiased local structure studies of the changes in V--V distances through the phase transition, using reverse Monte Carlo methods, support the idea of phase coexistence and point to the high degree of correlation in the dimerized low-temperature structure. No evidence for short range V--V correlations that would be suggestive of local dimers is found in the metallic phase.
The recent surge of interest in brain-inspired computing and power-efficient electronics has dramatically bolstered development of computation and communication using neuron-like spiking signals. Devices that can produce rapid and energy-efficient sp
iking could significantly advance these applications. Here we demonstrate DC-current or voltage-driven periodic spiking with sub-20 ns pulse widths from a single device composed of a thin VO2 film with a metallic carbon nanotube as a nanoscale heater. Compared with VO2-only devices, adding the nanotube heater dramatically decreases the transient duration and pulse energy, and increases the spiking frequency, by up to three orders of magnitude. This is caused by heating and cooling of the VO2 across its insulator-metal transition being localized to a nanoscale conduction channel in an otherwise bulk medium. This result provides an important component of energy-efficient neuromorphic computing systems, and a lithography-free technique for power-scaling of electronic devices that operate via bulk mechanisms.
In this paper, the effect of Ar+ bombardment of SrTiO3:Nb surface layers is investigated on the macro- and nanoscale using surface-sensitive methods. After bombardment, the stoichiometry and electronic structure are changed distinctly leading to an i
nsulator-to-metal transition related to the change of the Ti d electron from d0 to d1 and d2. During bombardment, conducting islands are formed on the surface. The induced metallic state is not stable and can be reversed due to a redox process by external oxidation and even by self-reoxidation upon heating the sample to temperatures of 300{deg}C.
The Metal-Insulator transition (MIT) in VO2 is characterized by the complex interplay among lattice, electronic and orbital degrees of freedom. In this contribution we investigated the strain-modulation of the orbital hierarchy and the influence over
macroscopic properties of the metallic phase of VO2 such as Fermi Level (FL) population and metallicity, i.e., the material ability to screen an electric field, by means of temperature-dependent X-ray Absorption Near Edge Structure (XANES) and Resonant Photoemission spectroscopy (ResPES). We demonstrate that the MIT in strained VO2 is of the Filling Control type, hence it is generated by electron correlation effects. In addition, we show that the MIT in Nanostructured (NS) disordered VO2, where the structural phase transition is quenched, is driven by electron correlation. Therefore a fine tuning of the correlation could lead to a precise control and tuning of the transition features.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
