اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدExperimental Assessment of Real-time PDCP-RLC V-RAN Split Transmission with 20 Gbit/s PAM4 Optical Access
56
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We experimentally demonstrate real-time, end-to-end transmission of 3GPPs option 2 functional split RAN interface with virtualized central units through up to 20km using a 20Gbit/s PAM4 link and 10GHz bandwidth optics.
قيم البحث
اقرأ أيضاً
In this work, we experimentally assess the transmission of a PDCP-RLC virtualised RAN split interface through a commercial XGS-PON system. We investigate the impacts of DBA on the uplink and packet jitter on the downlink.
The challenge of next generation datacom and telecom communication is to increase the available bandwidth while reducing the size, cost and power consumption of photonic integrated circuits. Silicon (Si) photonics has emerged as a viable solution to
reach these objectives. Graphene, a single-atom thick layer of carbon5, has been recently proposed to be integrated with Si photonics because of its very high mobility, fast carrier dynamics and ultra-broadband optical properties. Here, we focus on graphene photodetectors for high speed datacom and telecom applications. High speed graphene photodetectors have been demonstrated so far, however the most are based on the photo-bolometric (PB) or photo-conductive (PC) effect. These devices are characterized by large dark current, in the order of milli-Amperes , which is an impairment in photo-receivers design, Photo-thermo-electric (PTE) effect has been identified as an alternative phenomenon for light detection. The main advantages of PTE-based photodetectors are the optical power to voltage conversion, zero-bias operation and ultra-fast response. Graphene PTE-based photodetectors have been reported in literature, however high-speed optical signal detection has not been shown. Here, we report on an optimized graphene PTE-based photodetector with flat frequency response up to 65 GHz. Thanks to the optimized design we demonstrate a system test leading to direct detection of 105 Gbit s-1 non-return to zero (NRZ) and 120 Gbit s-1 4-level pulse amplitude modulation (PAM) optical signals
We review three solutions for low-cost data center interconnects with a target reach of up to 80 km. Directly detected DMT, PAM-4 and multi-band CAP are promising modulation schemes, enabling 400 Gbit/s by combining eight channels of 56 Gbit/s.
We review some currently discussed solutions for 400 Gbit/s inter-data center WDM transmission for up to 100 km. We focus on direct detected solutions, namely PAM4 and DMT, and present two WDM systems based on these formats.
Real-Time Applications (RTA) are among the most important use cases for future Wi-Fi 7, defined by the IEEE 802.11be standard. This paper studies two backward-compatible channel access approaches to satisfy the strict quality of service (QoS) require
ments of RTA on the transmission latency and packet loss rate that have been considered in the 802.11be Task Group. The first approach is based on limiting the transmission duration of non-RTA frames in the network. The second approach is based on preliminary channel access to ensure the timely delivery of RTA frames. With the developed mathematical model of these approaches, it is shown that both of them can satisfy the RTA QoS requirements. At the same time, the preliminary channel access provides up to 60% higher efficiency of the channel usage by the non-RTA traffic in scenarios with very strict RTA QoS requirements or with low intensity of the RTA traffic.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
