اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMulti-Objective Genetic Algorithm Optimisation for an Array of Cherenkov Telescopes
71
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have conceived and implemented a multi-objective genetic algorithm (GA) code for the optimisation of an array of Imaging Atmospheric Cherenkov Telescopes (IACTs). The algorithm takes as input a series of cost functions (metrics) each describing a different objetive of the optimisation (such as effective area, angular resolution, etc.), all of which are expressed in terms of the relative position of the telescopes in the plane. The output of the algorithm is a family of geometrical arrangements which correspond to the complete set of solutions to the array optimisation problem, and differ from each other according to the relative weight given to each of the (maybe conflicting) objetives of the optimisation. Since the algorithm works with parallel optimisation it admits as many cost functions as desired, and can incorporate constraints such as budget (cost cap) for the array and topological limitations of the terrain, like geographical accidents where telescopes cannot be installed. It also admits different types of telescopes (hybrid arrays) and the number of telescopes of each type can be treated as a parameter to be optimised - constrained, for example, by the cost of each type or the energy range of interest. The purpose of the algorithm, which converges fast to optimised solutions (if compared to the time for a complete Monte Carlo Simulation of a single configuration), is to provide a tool to investigate the full parameter space of possible geometries, and help in designing complex arrays. It does not substitute a detailed Monte Carlo study, but aims to guide it. In the examples of arrays shown here we have used as metrics simple heuristic expressions describing the fundamentals of the IAC technique, but these input functions can be made as detailed or complex as desired for a given experiment.
قيم البحث
اقرأ أيضاً
This paper is concerned with the performance optimisation of an stereoscopic array of imaging atmospheric Cherenkov telescopes (IACTs) as a function of their positioning on the ground. In this first work we are concerned primarily with the study of t
he optimisation method and its test on toy arrays of few (3-6) telescopes. The ideas presented here were developed to investigate alternative ways of studying IACT array geometries. The proposal is an attempt to cover more exhaustively and systematically the parameter space involved in the design of a stereoscopic IACT array, aiming to develop a support tool for directing the computationally expensive Monte Carlo simulations commonly used in the field. The methodology presented here involves a modelling step (in our case a simplified, heuristic IACT array model) and the implementation of an evolutionary algorithm for the geometric optimisation. In this initial work, the heuristic model and the optimisation algorithm are presented, but no detailed Monte Carlo validation is presented yet. The techniques used here may have potential applications in other optimization problems in the field of Gamma Ray Astronomy.
The Cherenkov Telescope Array (CTA) is the major next-generation observatory for ground-based very-high-energy gamma-ray astronomy. It will improve the sensitivity of current ground-based instruments by a factor of five to twenty, depending on the en
ergy, greatly improving both their angular and energy resolutions over four decades in energy (from 20 GeV to 300 TeV). This achievement will be possible by using tens of imaging Cherenkov telescopes of three successive sizes. They will be arranged into two arrays, one per hemisphere, located on the La Palma island (Spain) and in Paranal (Chile). We present here the optimised and final telescope arrays for both CTA sites, as well as their foreseen performance, resulting from the analysis of three different large-scale Monte Carlo productions.
The IceCube Neutrino Observatory has revealed the existence of sources of high-energy astrophysical neutrinos. However, identification of the sources is challenging because astrophysical neutrinos are difficult to separate from the background of atmo
spheric neutrinos produced in cosmic-ray-induced particle cascades in the atmosphere. The efficient detection of air showers in coincidence with detected neutrinos can greatly reduce those backgrounds and increase the sensitivity of neutrino telescopes. Imaging Air Cherenkov Telescopes (IACTs) are sensitive to gamma-ray-induced (and cosmic-ray-induced) air showers in the 50 GeV to 50 TeV range, and can therefore be used as background-identifiers for neutrino observatories. This paper describes the feasibility of an array of small scale, wide field-of-view, cost-effective IACTs as an air shower veto for neutrino astronomy. A surface array of 250 to 750 telescopes would significantly improve the performance of a cubic kilometer-scale detector like IceCube, at a cost of a few percent of the original investment. The number of telescopes in the array can be optimized based on astronomical and geometrical considerations.
Arrays of Cherenkov telescopes typically use multi-level trigger schemes to keep the rate of random triggers from the night sky background low. At a first stage, individual telescopes produce a trigger signal from the pixel information in the telesco
pe camera. The final event trigger is then formed by combining trigger signals from several telescopes. In this poster, we present a possible scheme for the Cherenkov Telescope Array telescope trigger, which is based on the analog pulse information of the pixels in a telescope camera. Advanc
The pointing system of the prototype of the Large Size Telescope (LST-1) for the Cherenkov Telescope Array observatory, should ensure mapping of the gamma-ray image of a point-like source in the Cherenkov camera to the sky coordinates with a precisio
n better than 14 arcseconds. Detailed studies of the telescope deformations are performed in order to disentangle different deformations and quantify their contributions to the miss-pointing, to learn how to correct for them, and finally how to design the system for offline and online pointing corrections. The LST-1 pointing precision system consist of several devices mounted at the center of the dish: Starguider Camera (SG), Camera Displacement Monitor (CDM), two inclinometers, four distance meters, and an Optical Axis Reference Laser (OARL), working together with the LEDs mounted in a circle around the Cherenkov camera. The online pointing corrections are based on a bending model as currently done by existing IACTs. The offline corrections will be performed combining measurements done by the SG and CDM cameras. SG will provide the position of the Cherenkov camera center with respect to the sky coordinates with a precision of 5 arcseconds, while CDM will provide the deviation of the telescope optical axis defined by the OARL spots with respect to the Cherenkov camera center with a precision better than 5 arcseconds. Laboratory measurements on dedicated test benches showed that the required pointing precision can be achieved for SG, CDM and inclinometer.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
