اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectronic structure and phase transition in polar ScFeO3 from First Principles Calculations
91
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The properties of newly discovered polar ScFeO3 with magnetic ordering are examined using Ab initio calculations and symmetry mode analysis. The GGA+U calculation confirms the stability of polar R3c Phase in ScFeO3 and the pressure induced phase transition to non-polar Pnma phase. Octahedron tilting and structural properties as a function of applied pressure have been analyzed. The origin of polar phase is associated with instability of non-polar R-3c phase and group theory using the symmetry mode analysis has been applied to understand this instability as well as the spontaneous polarization of polar R3c phase. The magnetic phase transition shows G-type AFM ordering of Fe3+ ion within Goodenough-Kanamori theory and the possibility of magnetic spin structure has been analyzed by using energy analysis including spin canting possibility.
قيم البحث
اقرأ أيضاً
We present results of electronic band structure, Fermi surface and electron transport properties calculations in orthorhombic $n$- and $p$-type SnSe, applying Korringa-Kohn-Rostoker method and Boltzmann transport approach. The analysis accounted for
temperature effect on crystallographic parameters in $Pnma$ structure as well as the phase transition to $CmCm$ structure at $T_csim 807 $K. Remarkable modifications of conduction and valence bands were notified upon varying crystallographic parameters within the structure before $T_c$, while the phase transition mostly leads to jump in the band gap value. The diagonal components of kinetic parameter tensors (velocity, effective mass) and resulting transport quantity tensors (electrical conductivity $sigma$, thermopower $S$ and power factor PF) were computed in wide range of temperature ($15-900 $K) and, hole ($p-$type) and electron ($n-$type) concentration ($10^{17}-10^{21}$ cm$^{-3}$). SnSe is shown to have strong anisotropy of the electron transport properties for both types of charge conductivity, as expected for the layered structure. In general, $p$-type effective masses are larger than $n$-type ones. Interestingly, $p$-type SnSe has strongly non-parabolic dispersion relations, with the pudding-mold-like shape of the highest valence band. The analysis of $sigma$, $S$ and PF tensors indicates, that the inter-layer electron transport is beneficial for thermoelectric performance in $n$-type SnSe, while this direction is blocked in $p$-type SnSe, where in-plane transport is preferred. Our results predict, that $n$-type SnSe is potentially even better thermoelectric material than $p$-type one. Theoretical results are compared with single crystal $p$-SnSe measurements, and good agreement is found.
The ground state electronic structures of the actinide oxides AO, A2O3 and AO2 (A=U, Np, Pu, Am, Cm, Bk, Cf) are determined from first-principles calculations, using the self-interaction corrected local spin-density (SIC-LSD) approximation. Emphasis
is put on the degree of f-electron localization, which for AO2 and A2O3 is found to follow the stoichiometry, namely corresponding to A(4+) ions in the dioxide and A(3+) ions in the sesquioxides. In contrast, the A(2+) ionic configuration is not favorable in the monoxides, which therefore become metallic. The energetics of the oxidation and reduction of the actinide dioxides is discussed, and it is found that the dioxide is the most stable oxide for the actinides from Np onwards. Our study reveals a strong link between preferred oxidation number and degree of localization which is confirmed by comparing to the ground state configurations of the corresponding lanthanide oxides. The ionic nature of the actinide oxides emerges from the fact that only those compounds will form where the calculated ground state valency agrees with the nominal valency expected from a simple charge counting.
Based on first-principles calculations, the ground state configuration (Cmma-CH) of hydrogenated Biphenylene sheet (Science, 372, 852, 2021) is carefully identified from hundreds of possible candidates generated by RG2 code (Phys. Rev. B., 97, 014104
, 2018). Cmma-CH contains four benzene molecules in its crystalline cell and all of them are inequivalent due to its Cmma symmetry. The hydrogen atoms in Cmma-CH bond to carbon atoms in each benzene with a boat-like (boat-1:DDUDDU) up/down sequence and reversed boat-1 (UUDUUD) sequence in adjacent benzene rings. It is energetically less stable than the previously proposed allotropes (chair, tricycle, stirrup, boat-1, boat-2 and twist-boat) of hydrogenated graphene, but its formation energy from hydrogenating Biphenylene sheet is remarkably lower than those for hydrogenating graphene to graphane. Our results confirm that Cmma-CH is mechanically and dynamically stable 2D hydrocarbon phase which is expectable to be experimentally realized by hydrogenating the synthesized Biphenylene sheet. The HSE06 based band structures show that Cmma-CH is an indirect band gap insulators with a gap of 4.645 eV.
We report an ab-initio study of the stability and electronic properties of transition metal silicides in order to study their potential for high temperature thermoelectric applications. We focus on the family M5Si3 (M = Ta, W) which is stable up to a
bout 2000 {deg}C. We first investigate the structural stability of the two compounds and then determine the thermopower of the equilibrium structure using the electronic density of states and Motts law. We find that W5Si3 has a relatively large thermopower but probably not sufficient enough for thermoelectric applications.
First-principles calculations through a FLAPW-GGA method for six possible polymorphs of ruthenium mononitride RuN with various atomic coordination numbers CNs: cubic zinc blende (ZB) and cooperite PtS-like structures with CNs = 4; cubic rock-salt (RS
), hexagonal WC-like and NiAs-like structures with CNs = 6 and cubic CsCl-like structure with CN = 8 indicate that the most stable is ZB structure, which is much more preferable for RuN than the recently reported RS structure for synthesized RuN samples. The elastic and electronic properties of ZB-RuN were investigated and discussed in comparison with those for RS-RuN polymorph.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
