اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHalf Heusler Alloys for Efficient Thermoelectric Power Conversion
231
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Half-Heusler (HH) phases (space group F43m, Clb) are increasingly gaining attention as promising thermoelectric materials in view of their thermal stability, scalability, and environmental benignity as well as efficient power output. Until recently, the verifiable dimensionless figure of merit (ZT) of HH phases has remained moderate near 1, which limits the power conversion efficiency of these materials. We report herein ZT~1.3 in n-type (Hf,Zr)NiSn alloys near 850 K developed through elemental substitution and simultaneously embedment of nanoparticles in the HH matrix, obtained by annealing the samples close to their melting temperatures. Introduction of mass fluctuation and scattering centers play a key role in the high ZT measured, as shown by the reduction of thermal conductivity and increase of thermopower. Based on computation, the power conversion efficiency of a n-p couple module based on the new n-type (Hf,Zr,Ti)NiSn particles-in-matrix composite and recently reported high-ZT p-type HH phases is expected to reach 13%, comparable to that of state-of-the-art materials, but with the mentioned additional materials and environmental attributes. Since the high efficiency is obtained without tuning the microstructure of the Half-Heusler phases, it leaves room for further optimization.
قيم البحث
اقرأ أيضاً
The thermoelectric properties of 54 different group 4 half-Heusler (HH) alloys have been studied from first principles. Electronic transport was studied with density functional theory using hybrid functionals facilitated by the $mathbf{k} cdot mathbf
{p}$ method, while the temperature dependent effective potential method was used for the phonon contributions to the figure of merit $ZT$. The phonon thermal conductivity was calculated including anharmonic phonon-phonon, isotope, alloy and grain-boundary scattering. HH alloys have an ${it XYZ}$ composition and those studied here are in the group 4-9-15 (Ti,Zr,Hf)(Co,Rh,Ir)(As,Sb,Bi) and group 4-10-14 (Ti,Zr,Hf)(Ni,Pd,Pt)(Ge,Sn,Pb). The electronic part of the thermal conductivity was found to significantly impact $ZT$ and thus the optimal doping level. Furthermore, the choice of functional was found to significantly affect thermoelectric properties, particularly for structures exhibiting band alignment features. The intrinsic thermal conductivity was significantly reduced when alloy and grain boundary scattering were accounted for, which also reduced the spread in thermal conductivity. It was found that sub-lattice disorder on the ${it Z}$-site, i.e. the site occupied by group 14 or 15 elements, was more effective than ${it X}$-site substitution, occupied by group 4 elements. The calculations confirmed that ZrNiSn, ZrCoSb and ZrCoBi based alloys display promising thermoelectric properties. A few other n-type and p-type compounds were also predicted to be potentially excellent thermoelectric materials, given that sufficiently high charge carrier concentrations can be achieved. This study provides insight into the thermoelectric potential of HH alloys and casts light on strategies to optimize thermoelectric performance of multicomponent alloys.
We have investigated the electronic and thermoelectric properties of half-Heusler alloys NiTZ (T = Sc, and Ti; Z = P, As, Sn, and Sb) having 18 valence electron. Calculations are performed by means of density functional theory and Boltzmann transport
equation with constant relaxation time approximation, validated by NiTiSn. The chosen half-Heuslers are found to be an indirect band gap semiconductor, and the lattice thermal conductivity is comparable with the state-of-the-art thermoelectric materials. The estimated power factor for NiScP, NiScAs, and NiScSb reveals that their thermoelectric performance can be enhanced by appropriate doping rate. The value of ZT found for NiScP, NiScAs, and NiScSb are 0.46, 0.35, and 0.29, respectively at 1200 K.
Half-Heusler alloys (MgAgSb structure) are promising thermoelectric materials. RNiSn half-Heusler phases (R=Hf, Zr, Ti) are the most studied in view of their thermal stability. The highest dimensionless figure of merit (ZT) obtained is ~1 in the temp
erature range ~450-900oC, primarily achieved in nanostructured alloys. Through proper annealing, ZT~1.2 has been obtained in a previous ZT~1 n-type (Hf,Zr)NiSn phase without the nanostructure. There is an appreciable increase in the power factor, decrease in charge carrier density, and increase in carrier mobility. The findings are attributed to the improvement of structural order. Present approach may be applied to optimize the functional properties of Heusler-type alloys.
We report $^{59}$Co, $^{93}$Nb, and $^{121}$Sb nuclear magnetic resonance (NMR) measurements combined with density functional theory (DFT) calculations on a series of half-Heusler semiconductors, including NbCoSn, ZrCoSb, TaFeSb and NbFeSb, to better
understand their electronic properties and general composition-dependent trends. These materials are of interest as potentially high efficiency thermoelectric materials. Compared to the other materials, we find that ZrCoSb tends to have a relatively large amount of local disorder, apparently antisite defects. This contributes to a small excitation gap corresponding to an impurity band near the band edge. In NbCoSn and TaFeSb, Curie-Weiss-type behavior is revealed, which indicates a small density of interacting paramagnetic defects. Very large paramagnetic chemical shifts are observed associated with a Van Vleck mechanism due to closely spaced $d$ bands splitting between the conduction and valence bands. Meanwhile, DFT methods were generally successful in reproducing the chemical shift trend for these half-Heusler materials, and we identify an enhancement of the larger-magnitude shifts, which we connect to electron interaction effects. The general trend is connected to changes in $d$-electron hybridization across the series.
A half-Heusler material FeNb$_{0.8}$Ti$_{0.2}$Sb has been identified as a promising thermoelectric material due to its excellent thermoelectric performance at high temperatures. The origins of the efficient thermoelectric performance are investigated
through a series of low-temperature (2 - 400 K) measurements. The high data coherence of the low and high temperatures is observed. An optimal and nearly temperature-independent carrier concentration is identified, which is ideal for the power factor. The obtained single type of hole carrier is also beneficial to the large Seebeck coefficient. The electronic thermal conductivity is found to be comparable to the lattice thermal conductivity and becomes the dominant component above 200 K. These findings again indicate that electron scattering plays a key role in the electrical and thermal transport properties. The dimensionless figure of merit is thus mainly governed by the electronic properties. These effects obtained at low temperatures with the avoidance of possible thermal fluctuations together offer the physical origin for the excellent thermoelectric performance in this material.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
