اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDetermination of the stretch tensor for structural transformations
233
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The transformation stretch tensor plays an essential role in the evaluation of conditions of compatibility between phases and the use of the Cauchy-Born rule. This tensor is difficult to measure directly from experiment. We give an algorithm for the determination of the transformation stretch tensor from x-ray measurements of structure and lattice parameters. When evaluated on some traditional and emerging phase transformations the algorithm gives unexpected results.
قيم البحث
اقرأ أيضاً
Structural transformations at interfaces are of profound fundamental interest as complex examples of phase transitions in low-dimensional systems. Despite decades of extensive research, no compelling evidence exists for structural transformations in
high-angle grain boundaries in elemental systems. Here we show that the critical impediment to observations of such phase transformations in atomistic modeling has been rooted in inadequate simulation methodology. The proposed new methodology allows variations in atomic density inside the grain boundary and reveals multiple grain boundary phases with different atomic structures. Reversible first-order transformations between such phases are observed by varying temperature or injecting point defects into the boundary region. Due to the presence of multiple metastable phases, grain boundaries can absorb significant amounts of point defects created inside the material by processes such as irradiation. We propose a novel mechanism of radiation damage healing in metals which may guide further improvements in radiation resistance of metallic materials through grain boundary engineering.
Nanocrystals can exist in multiply twinned structures like the icosahedron, or single crystalline structures like the cuboctahedron or Wulff-polyhedron. Structural transformation between these polymorphic structures can proceed through diffusion or d
isplacive motion. Experimental studies on nanocrystal structural transformations have focused on high temperature diffusion mediated processes. Thus, there is limited experimental evidence of displacive motion mediated structural transformations. Here, we report the high-pressure structural transformation of 6 nm Au nanocrystals under nonhydrostatic pressure in a diamond anvil cell that is driven by displacive motion. In-situ X-ray diffraction and transmission electron microscopy were used to detect the transformation of multiply twinned nanocrystals into single crystalline nanocrystals. High-pressure single crystalline nanocrystals were recovered after unloading, however, the nanocrystals quickly reverted back to multiply twinned state after redispersion in toluene solvent. The dynamics of recovery was captured using transmission electron microscopy which showed that the recovery was governed by surface recrystallization and rapid twin boundary motion. We show that this transformation is energetically favorable by calculating the pressure-induced change in strain energy. Molecular dynamics simulations showed that defects nucleated from a region of high stress region in the interior of the nanocrystal, which make twin boundaries unstable. Deviatoric stress driven Mackay transformation and dislocation/disclination mediated detwinning are hypothesized as possible mechanisms of high-pressure structural transformation.
For multi-stage, displacive structural transitions we present a general framework that accounts for various intermediate modulated phases, elastic constant, phonon and related thermodynamic anomalies. Based on the presence or absence of modulated pha
ses we classify these transformations in four categories and apply this approach to four different representative materials: Ni-Mn-Ga, NiTi(Fe),Ni-Al, Cu-Zn-Al and alpha-U. We suggest that the anomalous increase in elastic constant(s) and phonon frequency observed when approaching the martensitic transition from above is a signature of the conmensurate modulated phase.
Two-dimensional (2D) transition metal dichalcogenides (TMDCs) have been the subject of sustained research interest due to their extraordinary electronic and optical properties. They also exhibit a wide range of structural phases because of the differ
ent orientations that the atoms can have within a single layer, or due to the ways that different layers can stack. Here we report the first study of direct-visualization of structural transformations in atomically-thin layers under highly non-equilibrium thermodynamic conditions. We probe these transformations at the atomic scale using real-time, aberration corrected scanning transmission electron microscopy and observe strong dependence of the resulting structures and phases on both heating rate and temperature. A fast heating rate (25 C/sec) yields highly ordered crystalline hexagonal islands of sizes of less than 20 nm which are composed of a mixture of 2H and 3R phases. However, a slow heating rate (25 C/min) yields nanocrystalline and sub-stoichiometric amorphous regions. These differences are explained by different rates of sulfur evaporation and redeposition. The use of non-equilibrium heating rates to achieve highly crystalline and quantum-confined features from 2D atomic layers present a new route to synthesize atomically-thin, laterally confined nanostrucutres and opens new avenues for investigating fundamental electronic phenomena in confined dimensions.
We develop parameters for the interlayer Kolmogorov-Crespi (KC) potential to study structural features of four transition metal dichalcogenides (TMDs): MoS$_2$, WS$_2$, MoSe$_2$ and WSe$_2$. We also propose a mixing rule to extend the parameters to t
heir heterostructures. Moire superlattices of twisted bilayer TMDs have been recently shown to host shear solitons, topological point defects and ultraflatbands close to the valence band edge. Performing structural relaxations at the DFT level is a major bottleneck in the study of these systems. We show that the parametrized KC potential can be used to obtain atomic relaxations in good agreement with DFT relaxations. Furthermore, the moire superlattices relaxed using DFT and the proposed forcefield yield very similar electronic band structures.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
