اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدKepler-445, Kepler-446 and the Occurrence of Compact Multiples Orbiting Mid-M Dwarf Stars
134
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We confirm and characterize the exoplanetary systems Kepler-445 and Kepler-446: two mid-M dwarf stars, each with multiple, small, short-period transiting planets. Kepler-445 is a metal-rich ([Fe/H]=+0.25 $pm$ 0.10) M4 dwarf with three transiting planets, and Kepler-446 is a metal-poor ([Fe/H]=-0.30 $pm$ 0.10) M4 dwarf also with three transiting planets. Kepler-445c is similar to GJ 1214b: both in planetary radius and the properties of the host star. The Kepler-446 system is similar to the Kepler-42 system: both are metal-poor with large galactic space velocities and three short-period, likely-rocky transiting planets that were initially assigned erroneously large planet-to-star radius ratios. We independently determined stellar parameters from spectroscopy and searched for and fitted the transit light curves for the planets, imposing a strict prior on stellar density in order to remove correlations between the fitted impact parameter and planet-to-star radius ratio for short-duration transits. Combining Kepler-445, Kepler-446 and Kepler-42, and isolating all mid-M dwarf stars observed by Kepler with the precision necessary to detect similar systems, we calculate that 21 $^{+7}_{-5}$ % of mid-M dwarf stars host compact multiples (multiple planets with periods of less than 10 days) for a wide range of metallicities. We suggest that the inferred planet masses for these systems support highly efficient accretion of protoplanetary disk metals by mid-M dwarf protoplanets.
قيم البحث
اقرأ أيضاً
Bow shocks can be formed around planets due to their interaction with the coronal medium of the host stars. The net velocity of the particles impacting on the planet determines the orientation of the shock. At the Earths orbit, the (mainly radial) so
lar wind is primarily responsible for the formation of a shock facing towards the Sun. However, for close-in planets that possess high Keplerian velocities and are frequently located at regions where the host stars wind is still accelerating, a shock may develop ahead of the planet. If the compressed material is able to absorb stellar radiation, then the signature of bow shocks may be observed during transits. Bow-shock models have been investigated in a series of papers (Vidotto et al. 2010, 2011,a,b; Llama et al. 2011) for known transiting systems. Once the signature of a bow-shock is observed, one can infer the magnetic field intensity of the transiting planet. Here, we investigate the potential to use this model to detect magnetic fields of (hypothetical) planets orbiting inside the habitable zone of M-dwarf stars. For these cases, we show, by means of radiative transfer simulations, that the detection of bow-shocks of planets surrounding M-dwarf stars may be more difficult than for the case of close-in giant planets orbiting solar-type stars.
The stellar magnetic field plays a crucial role in the star internal mechanisms, as in the interactions with its environment. The study of starspots provides information about the stellar magnetic field, and can characterise the cycle. Moreover, the
analysis of solar-type stars is also useful to shed light onto the origin of the solar magnetic field. The objective of this work is to characterise the magnetic activity of stars. Here, we studied two solar-type stars Kepler-17 and Kepler-63 using two methods to estimate the magnetic cycle length. The first one characterises the spots (radius, intensity, and location) by fitting the small variations in the light curve of a star caused by the occultation of a spot during a planetary transit. This approach yields the number of spots present in the stellar surface and the flux deficit subtracted from the star by their presence during each transit. The second method estimates the activity from the excess in the residuals of the transit lightcurves. This excess is obtained by subtracting a spotless model transit from the lightcurve, and then integrating all the residuals during the transit. The presence of long term periodicity is estimated in both time series. With the first method, we obtained $P_{rm cycle}$ = 1.12 $pm$ 0.16 yr (Kepler-17) and $P_{rm cycle}$ = 1.27 $pm$ 0.16 yr (Kepler-63), and for the second approach the values are 1.35 $pm$ 0.27 yr and 1.27 $pm$ 0.12 yr, respectively. The results of both methods agree with each other and confirm their robustness.
We report the first detailed chemical abundance analysis of the exoplanet-hosting M-dwarf stars Kepler-138 and Kepler-186 from the analysis of high-resolution ($R$ $sim$ 22,500) $H$-band spectra from the SDSS IV - APOGEE survey. Chemical abundances o
f thirteen elements - C, O, Na, Mg, Al, Si, K, Ca, Ti, V, Cr, Mn, and Fe - are extracted from the APOGEE spectra of these early M-dwarfs via spectrum syntheses computed with an improved line list that takes into account H$_{2}$O and FeH lines. This paper demonstrates that APOGEE spectra can be analyzed to determine detailed chemical compositions of M-dwarfs. Both exoplanet-hosting M-dwarfs display modest sub-solar metallicities: [Fe/H]$_{Kepler-138}$ = -0.09 $pm$ 0.09 dex and [Fe/H]$_{Kepler-186}$ = -0.08 $pm$ 0.10 dex. The measured metallicities resulting from this high-resolution analysis are found to be higher by $sim$0.1-0.2 dex than previous estimates from lower-resolution spectra. The C/O ratios obtained for the two planet-hosting stars are near-solar, with values of 0.55 $pm$ 0.10 for Kepler-138 and 0.52 $pm$ 0.12 for Kepler-186. Kepler-186 exhibits a marginally enhanced [Si/Fe] ratio.
The occurrence rate of hot Jupiters from the Kepler transit survey is roughly half that of radial velocity surveys targeting solar neighborhood stars. One hypothesis to explain this difference is that the two surveys target stars with different stell
ar metallicity distributions. To test this hypothesis, we measure the metallicity distribution of the Kepler targets using the Hectochelle multi-fiber, high-resolution spectrograph. Limiting our spectroscopic analysis to 610 dwarf stars in our sample with log(g)>3.5, we measure a metallicity distribution characterized by a mean of [M/H]_{mean} = -0.045 +/- 0.00, in agreement with previous studies of the Kepler field target stars. In comparison, the metallicity distribution of the California Planet Search radial velocity sample has a mean of [M/H]_{CPS, mean} = -0.005 +/- 0.006, and the samples come from different parent populations according to a Kolmogorov-Smirnov test. We refit the exponential relation between the fraction of stars hosting a close-in giant planet and the host star metallicity using a sample of dwarf stars from the California Planet Search with updated metallicities. The best-fit relation tells us that the difference in metallicity between the two samples is insufficient to explain the discrepant Hot Jupiter occurrence rates; the metallicity difference would need to be $simeq$0.2-0.3 dex for perfect agreement. We also show that (sub)giant contamination in the Kepler sample cannot reconcile the two occurrence calculations. We conclude that other factors, such as binary contamination and imperfect stellar properties, must also be at play.
(Abridged) We present the first APOKASC catalog of spectroscopic and asteroseismic data for 415 dwarfs and subgiants. Asteroseismic data have been obtained by Kepler in short cadence. The spectroscopic parameters are based on spectra taken as part of
APOGEE and correspond to DR13 of SDSS. We analyze our data using two Teff scales, the spectroscopic values from DR13 and those derived from SDSS griz photometry. We use the differences in our results arising from these choices as a test of systematic Teff, and find that they can lead to significant differences in the derived stellar properties. Determinations of surface gravity ($log{g}$), mean density ($rho$), radius ($R$), mass ($M$), and age ($tau$) for the whole sample have been carried out with stellar grid-based modeling. We have assessed random and systematic error sources in the spectroscopic and seismic data, as well as in the grid-based modeling determination of the stellar quantities in the catalog. We provide stellar properties for both Teff scales. The median combined (random and systematic) uncertainties are 2% (0.01 dex; $log{g}$), 3.4% ($rho$), 2.6% ($R$), 5.1% ($M$), and 19% ($tau$) for the photometric Teff scale and 2% ($log{g}$), 3.5% ($rho$), 2.7% ($R$), 6.3% ($M$), and 23% ($tau$) for the spectroscopic scale. Comparisons with stellar quantities in the catalog by Chaplin et al.(2014) highlight the importance of metallicity measurements for determining stellar parameters accurately. We compare our results with those from other sources, including stellar radii determined from TGAS parallaxes and asteroseismic analyses based on individual frequencies. We find a very good agreement in all cases. Comparisons give strong support to the determination of stellar quantities based on global seismology, a relevant result for future missions such as TESS and PLATO. Table 5 corrected (wrongly listed SDSS Teff before).
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
