اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStudy of magnetic iron nitride thin films deposited by high power impulse magnetron sputtering
150
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this work, we studied phase formation, structural and magnetic properties of iron-nitride (Fe-N) thin films deposited using high power impulse magnetron sputtering (HiPIMS) and direct current magnetron sputtering (dc-MS). The nitrogen partial pressure during deposition was systematically varied both in HiPIMS and dc-MS. Resulting Fe-N films were characterized for their microstructure, magnetic properties and nitrogen concentration. We found that HiPIMS deposited Fe-N films show a globular nanocrystalline microstructure and improved soft magnetic properties. In addition, it was found that the nitrogen reactivity impedes in HiPIMS as compared to dc-MS. Obtained results can be understood in terms of distinct plasma properties of HiPIMS.
قيم البحث
اقرأ أيضاً
The effect of magnetron power on the room temperature 1.54 $mu$m infra-red photoluminescence intensity of erbium doped AlN films grown by r. f. magnetron sputtering, has been studied. The AlN:Er thin films were deposited on (001) Silicon substrates.
The study presents relative photoluminescence intensities of nanocrystallized samples prepared with identical sputtering parameters for two erbium doping levels (0.5 and 1.5 atomic %). The structural evolution of the crystallites as a function of the power is followed by transmission electron microscopy. Copyright line will be provided by the publisher 1 Introduction For some time now, rare-earth (RE)-doped semiconductors represent significant potential applications in the field of opto-electronic technology. Part of this technological interest relies on the shielded 4f levels of the RE ions as they give rise to sharp and strong luminescence peaks [1-5]. Among the RE elements, Er is preferred to its counterparts since the Er ions can produce both visible light at 558 nm (green, one of the primary colours) and IR light at 1.54 $mu$m whose spectrum region coincides with the main low-loss region in the absorption spectrum of silica-based optical fibres, combining so potential applications towards photonic devices and towards optical communication devices operating in the infrared domain. These interesting emissions can however only be exploited when placed into host matrixes. On one side, the shielding of the intra 4f levels prevents the shifting of the RE 3+ energy levels and ensures the frequency emission stability. Moreover the intra 4f transitions are parity forbidden for the isolated ions. Matrixes can render the Er 3+ ions optically active, via a relaxation of selection rules due to crystal field effects. As silicon based materials were tested in the 1960s to the 90s with no clear industrial success it was found that the
Rare-earth (R) nickelates (such as perovskite RNiO3, trilayer R4Ni3O10, and infinite layer RNiO2) have attracted tremendous interest very recently. However, unlike widely studied RNiO3 and RNiO2 films, the synthesis of trilayer nickelate R4Ni3O10 fil
ms is rarely reported. Here, single-crystalline (Nd0.8Sr0.2)4Ni3O10 epitaxial films were coherently grown on SrTiO3 substrates by high-pressure magnetron sputtering. The crystal and electronic structures of (Nd0.8Sr0.2)4Ni3O10 films were characterized by high-resolution X-ray diffraction and X-ray photoemission spectroscopy, respectively. The electrical transport measurements reveal a metal-insulator transition near 82 K and negative magnetoresistance in (Nd0.8Sr0.2)4Ni3O10 films. Our work provides a novel route to synthesize high-quality trilayer nickelate R4Ni3O10 films.
In the prospect of understanding the photoluminescence mechanisms of AlN films doped with erbium and targeting photonic applications we have synthesized non doped and Er-doped AlN films with different crystallized nanostructures by using PVD magnetro
n sputtering. Their crystalline morphology and their visible photoluminescence properties were precisely measured.Due to the weak cross-section absorption of rare earths like erbium, it is necessary to obtain an efficient energy transfer mechanism between the host matrix and the rare earth to obtain high luminescence efficiency. Our strategy is then to elaborate some nanostructures that could introduce additional intermediate electronic levels within the gap thanks to the presence of structural defects (point defects, grain boundaries{ldots}) and could lead to energy transfer from the AlN matrix to the rare earth.Doped and non-doped AlN films were prepared by radio frequency magnetron sputtering by using different experimental conditions that will be detailed. It will notably be shown how a negative polarization of samples during deposition allows obtaining crystalline morphologies ranging from the classical columnar structure to a highly disordered polycrystalline structure with grains of several nanometers (nearly amorphous). The nanostructures of the films could be categorized in three types: 1) type 1 was nanocolumnar (width of column ~ 15 nm), 2) type 2 was made of short columns (width of column ~ 10 nm) and 3) the last type was made of equiaxed nanocrystallites (size of grains ~3-4 nm).High-resolution photoluminescence spectroscopy was performed to characterize their optical behaviour. The samples were excited by the laser wavelengths at 458, 488 or 514 nm. A broad photoluminescence band was observed centred around 520 nm in columnar samples. In the same energy range, the highly resolved spectra also showed several sharp emission peaks. This fine structure could be attributed to erbium transitions. This fine structure tended to disappear going from type 1 to type 3 samples. Indeed, the relative intensity of the peaks decreased and their full width at half maximum increased. This change could be related to the density of defects that increased when the size of the grains decreased. The photoluminescence properties of the films in the visible range will be discussed in relation with their structure.
Nanocrystalline n-AlN:Er thin films were deposited on (001) Silicon substrates by r. f. magnetron sputtering at room temperature to study the correlation between 1.54 $mu$m IR photoluminescence (PL) intensity, AlN crystalline structure and Er concent
ration rate. This study first presents how Energy-Dispersive Spectroscopy of X-rays (EDSX) Er Cliff Lorimer sensitivity factor alpha = 5 is obtained by combining EDSX and electron probe micro analysis (EPMA) results on reference samples. It secondly presents the relative PL intensities of nanocrystallized samples prepared with identical sputtering parameters as a function of the Er concentration. The structure of crystallites in AlN films is observed by transmission electron microscopy.
As a unique perovskite transparent oxide semiconductor, high-mobility La-doped BaSnO3 films have been successfully synthesized by molecular beam epitaxy and pulsed laser deposition. However, it remains a big challenge for magnetron sputtering, a wide
ly applied technique suitable for large-scale fabrication, to grow high-mobility La-doped BaSnO3 films. Here, we developed a method to synthesize high-mobility epitaxial La-doped BaSnO3 films (mobility up to 121 cm2V-1s-1 at the carrier density ~ 4.0 x 10^20 cm-3 at room temperature) directly on SrTiO3 single crystal substrates using high-pressure magnetron sputtering. The structural and electrical properties of the La-doped BaSnO3 films were characterized by combined high-resolution X-ray diffraction, X-ray photoemission spectroscopy, and temperature-dependent electrical transport measurements. The room temperature electron mobility of La-doped BaSnO3 films in this work is 2 to 4 times higher than the reported values of the films grown by magnetron sputtering. Moreover, in the high carrier density range (n > 3 x 10^20 cm-3), the electron mobility value of 121 cm2V-1s-1 in our work is among the highest values for all reported doped BaSnO3 films. It is revealed that high argon pressure during sputtering plays a vital role in stabilizing the fully relaxed films and inducing oxygen vacancies, which benefit the high mobility at room temperature. Our work provides an easy and economical way to massively synthesize high-mobility transparent conducting films for transparent electronics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
