اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMeasurement of the Velocity of the Neutrino with MINOS
84
0
0.0
(
0
)
تأليف
P. Adamson
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The MINOS experiment uses a beam of predominantly muon-type neutrinos generated using protons from the Main Injector at Fermilab in Batavia, IL, and travelling 735 km through the Earth to a disused iron mine in Soudan, MN. The 10{mu}s-long beam pulse contains fine time structure which allows a precise measurement of the neutrino time of flight to be made. The time structure of the parent proton pulse is measured in the beamline after extraction from the Main Injector, and neutrino interactions are timestamped at the Fermilab site in the Near Detector (ND), and at the Soudan site in the Far Detector (FD). Small, transportable auxiliary detectors, consisting of scintillator planes and associated readout electronics, are used to measure the relative latency between the two large detectors. Time at each location is measured with respect to HP5071A Cesium clocks, and time is transferred using GPS Precise Point Positioning (PPP) solutions for the clock offset at each location. We describe the timing calibration of the detectors and derive a measurement of the neutrino velocity, based on data from March and April 2012. We discuss the prospects for further improvements that would yield a still more accurate result.
قيم البحث
اقرأ أيضاً
The CERN-SPS accelerator has been briefly operated in a new, lower intensity neutrino mode with ~10^12 p.o.t. /pulse and with a beam structure made of four LHC-like extractions, each with a narrow width of 3 ns, separated by 524 ns. This very tightly
bunched beam structure represents a substantial progress with respect to the ordinary operation of the CNGS beam, since it allows a very accurate time-of-flight measurement of neutrinos from CERN to LNGS on an event-to-event basis. The ICARUS T600 detector has collected 7 beam-associated events, consistent with the CNGS delivered neutrino flux of 2.2 10^16 p.o.t. and in agreement with the well known characteristics of neutrino events in the LAr-TPC. The time of flight difference between the speed of light and the arriving neutrino LAr-TPC events has been analysed. The result is compatible with the simultaneous arrival of all events with equal speed, the one of light. This is in a striking difference with the reported result of OPERA that claimed that high energy neutrinos from CERN should arrive at LNGS about 60 ns earlier than expected from luminal speed.
In spring 2012 CERN provided two weeks of a short bunch proton beam dedicated to the neutrino velocity measurement over a distance of 730 km. The OPERA neutrino experiment at the underground Gran Sasso Laboratory used an upgraded setup compared to th
e 2011 measurements, improving the measurement time accuracy. An independent timing system based on the Resistive Plate Chambers was exploited providing a time accuracy of $sim$1 ns. Neutrino and anti-neutrino contributions were separated using the information provided by the OPERA magnetic spectrometers. The new analysis profited from the precision geodesy measurements of the neutrino baseline and of the CNGS/LNGS clock synchronization. The neutrino arrival time with respect to the one computed assuming the speed of light in vacuum is found to be $delta t_ u equiv TOF_c - TOF_ u= (0.6 pm 0.4 (stat.) pm 3.0 (syst.))$ ns and $delta t_{bar{ u}} equiv TOF_c - TOF_{bar{ u}} = (1.7 pm 1.4 (stat.) pm 3.1 (syst.))$ ns for $ u_{mu}$ and $bar{ u}_{mu}$, respectively. This corresponds to a limit on the muon neutrino velocity with respect to the speed of light of $-1.8 times 10^{-6} < (v_{ u}-c)/c < 2.3 times 10^{-6}$ at 90% C.L. This new measurement confirms with higher accuracy the revised OPERA result.
We report a two-detector measurement of the propagation speed of neutrinos over a baseline of 734 km. The measurement was made with the NuMI beam at Fermilab between the near and far MINOS detectors. The fractional difference between the neutrino spe
ed and the speed of light is determined to be $(v/c-1) = (1.0 pm 1.1) times 10^{-6}$, consistent with relativistic neutrinos.
The charge ratio, $R_mu = N_{mu^+}/N_{mu^-}$, for cosmogenic multiple-muon events observed at an under- ground depth of 2070 mwe has been measured using the magnetized MINOS Far Detector. The multiple-muon events, recorded nearly continuously from Au
gust 2003 until April 2012, comprise two independent data sets imaged with opposite magnetic field polarities, the comparison of which allows the systematic uncertainties of the measurement to be minimized. The multiple-muon charge ratio is determined to be $R_mu = 1.104 pm 0.006 {rm ,(stat.)} ^{+0.009}_{-0.010} {rm ,(syst.)} $. This measurement complements previous determinations of single-muon and multiple-muon charge ratios at underground sites and serves to constrain models of cosmic ray interactions at TeV energies.
The stability of high-current superconductors is challenging in the design of superconducting magnets. When the stability requirements are fulfilled, the protection against a quench must still be considered. A main factor in the design of quench prot
ection systems is the resistance growth rate in the magnet following a quench. The usual method for determining the resistance growth in impregnated coils is to calculate the longitudinal velocity with which the normal zone propagates in the conductor along the coil windings. Here, we present a 2D numerical model for predicting the normal zone propagation velocity in Al stabilized Rutherford NbTi cables with large cross section. By solving two coupled differential equations under adiabatic conditions, the model takes into account the thermal diffusion and the current redistribution process following a quench. Both the temperature and magnetic field dependencies of the superconductor and the metal cladding materials properties are included. Unlike common normal zone propagation analyses, we study the influence of the thickness of the cladding on the propagation velocity for varying operating current and magnetic field. To assist in the comprehension of the numerical results, we also introduce an analytical formula for the longitudinal normal zone propagation. The analysis distinguishes between low-current and high-current regimes of normal zone propagation, depending on the ratio between the characteristic times of thermal and magnetic diffusion. We show that above a certain thickness, the cladding acts as a heat sink with a limited contribution to the acceleration of the propagation velocity with respect to the cladding geometry. Both numerical and analytical results show good agreement with experimental data.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
