ترغب بنشر مسار تعليمي؟ اضغط هنا

The morphology of the Milky Way - I. Reconstructing CO maps from simulations in fixed potentials

161   0   0.0 ( 0 )
 نشر من قبل Alex Pettitt
 تاريخ النشر 2014
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We present an investigation into the morphological features of the Milky Way. We use smoothed particle hydrodynamics (SPH) to simulate the interstellar medium (ISM) in the Milky Way under the effect of a number of different gravitational potentials representing spiral arms and bars, assuming the Milky Way is grand design in nature. The gas is subject to ISM cooling and chemistry, enabling us to track the evolution of molecular gas. We use a 3D radiative transfer code to simulate the emission from the SPH output, allowing for the construction of synthetic longitude-velocity (l-v) emission maps as viewed from the Earth. By comparing these maps with the observed emission in CO from the Milky Way, we infer the arm/bar geometry that provides a best fit to our Galaxy. We find that it is possible to reproduce nearly all features of the l-v diagram in CO emission. There is no model, however, that satisfactorily reproduces all of the features simultaneously. Models with 2 arms cannot reproduce all the observed arm features, while 4 armed models produce too bright local emission in the inner Galaxy. Our best fitting models favour a bar pattern speed within 50-60km/s/kpc and an arm pattern speed of approximately 20km/s/kpc, with a bar orientation of approximately 45 degrees and arm pitch angle between 10-15 degrees.



قيم البحث

اقرأ أيضاً

The arm structure of the Milky Way remains somewhat of an unknown, with observational studies hindered by our location within the Galactic disc. In the work presented here we use smoothed particle hydrodynamics (SPH) and radiative transfer to create synthetic longitude-velocity observations. Our aim is to reverse-engineer a top down map of the Galaxy by comparing synthetic longitude-velocity maps to those observed. We set up a system of N-body particles to represent the disc and bulge, allowing for dynamic creation of spiral features. Interstellar gas, and the molecular content, is evolved alongside the stellar system. A 3D-radiative transfer code is then used to compare the models to observational data. The resulting models display arm features that are a good reproduction of many of the observed emission structures of the Milky Way. These arms however are dynamic and transient, allowing for a wide range of morphologies not possible with standard density wave theory. The best fitting models are a much better match than previous work using fixed potentials. They favour a 4-armed model with a pitch angle of approximately 20 degrees, though with a pattern speed that decreases with increasing Galactic radius. Inner bars are lacking however, which appear required to fully reproduce the central molecular zone.
We develop a chemical evolution model in order to study the star formation history of the Milky Way. Our model assumes that the Milky Way is formed from a closed box-like system in the inner regions, while the outer parts of the disc experience some accretion. Unlike the usual procedure, we do not fix the star formation prescription (e.g. Kennicutt law) in order to reproduce the chemical abundance trends. Instead, we fit the abundance trends with age in order to recover the star formation history of the Galaxy. Our method enables one to recover with unprecedented accuracy the star formation history of the Milky Way in the first Gyrs, in both the inner (R<7-8kpc) and outer (R>9-10kpc) discs as sampled in the solar vicinity. We show that, in the inner disc, half of the stellar mass formed during the thick disc phase, in the first 4-5 Gyr. This phase was followed by a significant dip in the star formation activity (at 8-9 Gyr) and a period of roughly constant lower level star formation for the remaining 8 Gyr. The thick disc phase has produced as many metals in 4 Gyr as the thin disc in the remaining 8 Gyr. Our results suggest that a closed box model is able to fit all the available constraints in the inner disc. A closed box system is qualitatively equivalent to a regime where the accretion rate, at high redshift, maintains a high gas fraction in the inner disc. In such conditions, the SFR is mainly governed by the high turbulence of the ISM. By z~1 it is possible that most of the accretion takes place in the outer disc, while the star formation activity in the inner disc is mostly sustained by the gas not consumed during the thick disc phase, and the continuous ejecta from earlier generations of stars. The outer disc follows a star formation history very similar to that of the inner disc, although initiated at z~2, about 2 Gyr before the onset of the thin disc formation in the inner disc.
We apply a semi-analytic galaxy formation model to two high resolution cosmological N-body simulations to investigate analogues of the Milky Way system. We select these according to observed properties of the Milky Way rather than by halo mass as in most previous work. For disk-dominated central galaxies with stellar mass (5--7) x 10d10Msun, the median host halo mass is 1.4 x 10d12Msun, with 1 sigma dispersion in the range [0.86, 3.1] x 10d12Msun, consistent with dynamical measurements of the Milky Way halo mass. For any given halo mass, the probability of hosting a Milky Way system is low, with a maximum of ~20% in haloes of mass ~10d12Msun. The model reproduces the V-band luminosity function and radial profile of the bright (MV < -9) Milky Way satellites. Galaxy formation in low mass haloes is found to be highly stochastic, resulting in an extremely large scatter in the relation between MV (or stellar mass) for satellites and the depth of the subhalo potential well in which they live, as measured by the maximum of the rotation curve, Vmax. We conclude that the too big to fail problem is an artifact of selecting satellites in N-body simulations according to subhalo properties: in 10% of cases we find that three or fewer of the brightest (or most massive) satellites have Vmax > 30 km/s. Our model predicts that around half of the dark matter subhaloes with Vmax > 20 km/s host satellites fainter than MV = -9 and so may be missing from existing surveys.
We use N-body chemo-dynamic simulations to study the coupling between morphology, kinematics and metallicity of the bar/bulge region of our Galaxy. We make qualitative comparisons of our results with available observations and find very good agreemen t. We conclude that this region is complex, since it comprises several stellar components with different properties -- i.e. a boxy/peanut bulge, thin and thick disc components, and, to lesser extents, a disky pseudobulge, a stellar halo and a small classical bulge -- all cohabiting in dynamical equilibrium. Our models show strong links between kinematics and metallicity, or morphology and metallicity, as already suggested by a number of recent observations. We discuss and explain these links.
Several lines of evidence suggest the Milky Way underwent a major merger at z~2 with a galaxy known as Gaia-Sausage-Enceladus (GSE). Here we use H3 Survey data to argue that GSE entered the Galaxy on a retrograde orbit based on a population of highly retrograde stars with chemistry similar to the largely radial GSE debris. We present the first tailored, high-resolution N-body simulations of the merger. From a grid of ~500 simulations we find a GSE with $M_{*}=5times10^{8} M_{odot}, M_{rm{DM}}=2times10^{11} M_{odot}$ (a 2.5:1 total mass merger) best matches the H3 data. This simulation shows the retrograde GSE stars are stripped from its outer disk early in the merger before the orbit loses significant angular momentum. Despite being selected purely on angular momenta and radial distributions, this simulation reproduces and explains the following empirical phenomena: (i) the elongated, triaxial shape of the inner halo (axis ratios $10:7.9:4.5$), whose major axis is at ~35{deg} to the plane and connects GSEs apocenters, (ii) the Hercules-Aquila Cloud & the Virgo Overdensity, which arise due to apocenter pile-up, (iii) the 2 Gyr lag between the quenching of GSE and the truncation of the age distribution of the in-situ halo, which tracks the 2 Gyr gap between the first and final GSE pericenters. We make the following predictions: (i) the inner halo has a double-break density profile with breaks at both ~15-18 kpc and 30 kpc, coincident with the GSE apocenters, (ii) the outer halo has retrograde streams containing ~10% of GSE stars awaiting discovery at >30 kpc. The retrograde (radial) GSE debris originates from its outer (inner) disk -- exploiting this trend we reconstruct the stellar metallicity gradient of GSE ($-0.04pm0.01$ dex $r_{rm{50}}^{-1}$). These simulations imply GSE delivered ~20% of the Milky Ways present-day dark matter and ~50% of its stellar halo. (ABRIDGED)
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا