اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOptical and Luminescence Properties of Zinc Oxide
249
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We generalize and systematize basic experimental data on optical and luminescence properties of ZnO single crystals, thin films, powders, ceramics, and nanocrystals. We consider and study mechanisms by which two main emission bands occur, a short-wavelength band near the fundamental absorption edge and a broad long-wavelength band, the maximum of which usually lies in the green spectral range. We determine a relationship between the two luminescence bands and study in detail the possibility of controlling the characteristics of ZnO by varying the maximum position of the short-wavelength band. We show that the optical and luminescence characteristics of ZnO largely depend on the choice of the corresponding impurity and the parameters of the synthesis and subsequent treatment of the sample. Prospects for using zinc oxide as a scintillator material are discussed. Additionally, we consider experimental results that are of principal interest for practice.
قيم البحث
اقرأ أيضاً
Ceramics ZnO:Zn of 20mm diameter and 1.6mm thickness with an optical transparency up to 0.33 in the visible region have been prepared by hot pressing technique. Scintillating and luminescent characteristics such as emission spectra, decay time, yield
, and TSL glow curve have been measured under X-ray excitation. Two emission bands peaking at 500 and 380 nm were detected, the light output was about 80% of that for standard BGO scintillator, main decay constant was 10.4 +/- 0.1 ns. The obtained data allow us to consider the ZnO:Zn ceramics as a perspective scintillator. Finally, the investigation shows that other ZnO-based fast scintillators can be fabricated in the form of optical ceramics.
Uniaxial hot pressing has been used to obtain ceramics based on zinc oxide, and their optical, x-ray-structure, luminescence, and scintillation characteristics have been studied. It is shown that, by changing the concentration of the dopant (Ga) and
the codopant (N), it is possible to change the intensities of the edge band (397.5 nm) and the intraband luminescence (510 nm) of the ZnO luminescence, as well as their ratio. Undoped ZnO ceramic has good transparency in the visible region and fairly high luminous yield: 9050 photons per MeV. Ceramic ZnO:Ga possesses intense edge luminescence with a falloff time of about 1 ns.
The paper presents results for zinc oxide films grown at low temperature regime by Atomic Layer Deposition (ALD). We discuss electrical properties of such films and show that low temperature deposition results in oxygen-rich ZnO layers in which free
carrier concentration is very low. For optimized ALD process it can reach the level of 10^15 cm-3, while mobility of electrons is between 20 and 50 cm2/Vs. Electrical parameters of ZnO films deposited by ALD at low temperature regime are appropriate for constructing of the ZnO-based p-n and Schottky junctions. We demonstrate that such junctions are characterized by the rectification ratio high enough to fulfill requirements of 3D memories and are deposited at temperature 100degC which makes them appropriate for deposition on organic substrates.
In this paper results of scintillation properties measurements of pure and Ce3+-doped strontium fluoride crystals are presented. We measure light output, scintillation decay time profile and temperature stability of light output. X-ray excited lumine
scence outputs corrected for spectral response of monochromator and photomultiplier for pure SrF2 and SrF2-0.3 mol.% Ce3+ are approximately 95% and 115% of NaI-Tl emission output, respectively. A photopeak with a 10% full width at half maximum is observed at approximately 84% the light output of a NaI-Tl crystal after correction for spectral response of photomultiplier, when sample 10x10 mm of pure SrF2 crystal is excited with 662 KeV photons. Corrected light output of SrF2-0.3 mol.% Ce3+ under 662 KeV photon excitation is found at approximately 64% the light output of the NaI-Tl crystal.
Flexible and transparent electronics presents a new era of electronic technologies. Ubiquitous applications involve wearable electronics, biosensors, flexible transparent displays, radio-frequency identifications (RFIDs), etc.Zinc oxide (ZnO) and rel
ated materials are the most commonly used inorganic semiconductors in flexible and transparent devices, owing to their high electrical performance, together with low processing temperature and good optical transparency.In this paper, we review recent advances in flexible and transparent thin-film transistors (TFTs) based on ZnO and related materials.After a brief introduction, the main progresses on the preparation of each component (substrate, electrodes, channel and dielectrics) are summarized and discussed. Then, the effect of mechanical bending on electrical performance was highlighted. Finally, we suggest the challenges and opportunities in future investigations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
