اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNew models for PIXE simulation with Geant4
465
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Particle induced X-ray emission (PIXE) is a physical effect that is not yet adequately modelled in Geant4. The current status as in Geant4 9.2 release is reviewed and new developments are described. The capabilities of the software prototype are illustrated in application to the shielding of the X-ray detectors of the eROSITA telescope on the upcoming Spectrum-X-Gamma space mission.
قيم البحث
اقرأ أيضاً
Particle induced X-ray emission (PIXE) is an important physical effect that is not yet adequately modelled in Geant4. This paper provides a critical analysis of the problem domain associated with PIXE simulation and describes a set of software develo
pments to improve PIXE simulation with Geant4. The capabilities of the developed software prototype are illustrated and applied to a study of the passive shielding of the X-ray detectors of the German eROSITA telescope on the upcoming Russian Spectrum-X-Gamma space mission.
Radioactive decays are of concern in a wide variety of applications using Monte-Carlo simulations. In order to properly estimate the quality of such simulations, knowledge of the accuracy of the decay simulation is required. We present a validation o
f the original Geant4 Radioactive Decay Module, which uses a per-decay sampling approach, and of an extended package for Geant4-based simulation of radioactive decays, which, in addition to being able to use a refactored per-decay sampling, is capable of using a statistical sampling approach. The validation is based on measurements of calibration isotope sources using a high purity Germanium (HPGe) detector; no calibration of the simulation is performed. For the considered validation experiment equivalent simulation accuracy can be achieved with per-decay and statistical sampling.
A test of Geant4 simulation of electron backscattering recently published in this journal prompted further investigation into the causes of the observed behaviour. An interplay between features of geometry and physics algorithms implemented in Geant4
is found to significantly affect the accuracy of backscattering simulation in some physics configurations.
The probability and intensity of nuclear reactions involving neutrons are characterized by the corresponding reaction cross-sections which are known to depend strongly on the incident neutron energy. In real applications the neutrons are seldom or ne
ver monoenergetic, and are usually characterized by certain continuous energy spectrum. The detailed knowledge of the neutron spectrum is crucial for numerous applications such as the nuclear reactor operation, the traveling wave reactor (TWR) development, including the search of the neutron energy ranges suitable for the wave nuclear burning, the search and prediction of the so-called blowup modes in neutron-multiplying media, the verification of neutron moderation theories and so on. In this paper we describe a method of GEANT4-based Monte Carlo calculation of the neutron spectrum evolution as well as the steady-state neutron spectrum in a system containing a persistent neutron source.
An investigation is in progress to evaluate extensively and quantitatively the possible benefits and drawbacks of new programming paradigms in a Monte Carlo simulation environment, namely in the domain of physics modeling. The prototype design and ex
tensive benchmarks, including a variety of rigorous quantitative metrics, are presented. The results of this research project allow the evaluation of new software techniques for their possible adoption in Monte Carlo simulation on objective, quantitative ground.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
