اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدKinetic study of the oxide-assisted catalyst-free synthesis of silicon nitride nanowires
114
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The synthesis of Si3N4 nanowires from the reaction of silicon nanoparticles with N2 in the 1200-1440 C temperature range is reported. The nitridation conditions are such that the reaction with nitrogen is favoured by the presence of silicon oxide in the particles and by the active oxidation of silicon without a catalyst. It is shown that the Si to Si3N4 conversion rate depends on the amount of silicon particles used in the experiments and that, in general, the reaction slows down for greater amounts. This trend is explained by particle stacking, which restricts the exchange of gases between the furnace atmosphere and the atmosphere around the inner particles. In a first stage, local oxygen partial pressure increases around the inner particles and inhibits nitridation locally. If the amount of reactant Si nanoparticles is small enough, this extrinsic effect is avoided and the intrinsic nitridation kinetics can be measured. Experiments show that intrinsic kinetics does not depend on temperature.
قيم البحث
اقرأ أيضاً
Growth of GaAs and InGaAs nanowires by the group-III assisted Molecular Beam Epitaxy growth method is studied in dependence of growth temperature, with the objective of maximizing the indium incorporation. Nanowire growth was achieved for growth temp
eratures as low as 550{deg}C. The incorporation of indium was studied by low temperature micro-photoluminescence spectroscopy, Raman spectroscopy and electron energy loss spectroscopy. The results show that the incorporation of indium lowering the growth temperature does not have an effect in increasing the indium concentration in the bulk of the nanowire, which is limited to 3-5%. For growth temperatures below 575{deg}C, indium rich regions form at the surface of the nanowires as a consequence of the radial growth. This results in the formation of quantum dots, which exhibit extremely sharp luminescence.
We report on the heterogeneous nucleation of catalyst-free InAs nanowires on Si (111) substrates by chemical beam epitaxy. We show that nanowire nucleation is enhanced by sputtering the silicon substrate with energetic particles. We argue that partic
le bombardment introduces lattice defects on the silicon surface that serve as preferential nucleation sites. The formation of these nucleation sites can be controlled by the sputtering parameters, allowing the control of nanowire density in a wide range. Nanowire nucleation is accompanied by unwanted parasitic islands, but by careful choice of annealing and growth temperature allows to strongly reduce the relative density of these islands and to realize samples with high nanowire yield.
Metallic contamination was key to the discovery of semiconductor nanowires, but today it stands in the way of their adoption by the semiconductor industry. This is because many of the metallic catalysts required for nanowire growth are not compatible
with standard CMOS (complementary metal oxide semiconductor) fabrication processes. Nanowire synthesis with those metals which are CMOS compatible, such as aluminium and copper, necessitate temperatures higher than 450 C, which is the maximum temperature allowed in CMOS processing. Here, we demonstrate that the synthesis temperature of silicon nanowires using copper based catalysts is limited by catalyst preparation. We show that the appropriate catalyst can be produced by chemical means at temperatures as low as 400 C. This is achieved by oxidizing the catalyst precursor, contradicting the accepted wisdom that oxygen prevents metal-catalyzed nanowire growth. By simultaneously solving material compatibility and temperature issues, this catalyst synthesis could represent an important step towards real-world applications of semiconductor nanowires.
The incorporation paths of Be in GaAs nanowires grown by the Ga-assisted method in molecular beam epitaxy has been investigated by electrical measurements of nanowires with different doping profiles. We find that Be atoms incorporate preferentially v
ia the nanowire side facets, while the incorporation path through the Ga droplet is negligible. We also demonstrate that Be can diffuse into the volume of the nanowire giving an alternative incorporation path. This work is an important step towards controlled doping of nanowires and will serve as a help for designing future devices based on nanowires.
We report on simulations and measurements of the optical absorption of silicon nanowires (NWs) versus their diameter. We first address the simulation of the optical absorption based on two different theoretical methods : the first one, based on the G
reen function formalism, is useful to calculate the scattering and absorption properties of a single or a finite set of NWs. The second one, based on the Finite Difference Time Domain (FDTD) method is well-adapted to deal with a periodic set of NWs. In both cases, an increase of the onset energy for the absorption is found with increasing diameter. Such effect is experimentally illustrated, when photoconductivity measurements are performed on single tapered Si nanowires connected between a set of several electrodes. An increase of the nanowire diameter reveals a spectral shift of the photocurrent intensity peak towards lower photon energies, that allows to tune the absorption onset from the ultraviolet radiations to the visible light spectrum.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
