اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe Eruption from a Sigmoidal Solar Active Region on 2005 May 13
278
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This paper presents a multiwavelength study of the M8.0 flare and its associated fast halo CME that originated from a bipolar active region NOAA 10759 on 2005 May 13. The source active region has a conspicuous sigmoid structure at TRACE 171 A channel as well as in the SXI soft X-ray images, and we mainly concern ourselves with the detailed process of the sigmoid eruption as evidenced by the multiwavelength data ranging from Halpha, WL, EUV/UV, radio, and hard X-rays (HXRs). The most important finding is that the flare brightening starts in the core of the active region earlier than that of the rising motion of the flux rope. This timing clearly addresses one of the main issues in the magnetic eruption onset of sigmoid, namely, whether the eruption is initiated by an internal tether-cutting to allow the flux rope to rise upward or a flux rope rises due to a loss of equilibrium to later induce tether cutting below it. Our high time cadence SXI and Halpha data shows that the first scenario is relevant to this eruption. As other major findings, we have the RHESSI HXR images showing a change of the HXR source from a confined footpoint structure to an elongated ribbon-like structure after the flare maximum, which we relate to the sigmoid-to-arcade evolution. Radio dynamic spectrum shows a type II precursor that occurred at the time of expansion of the sigmoid and a drifting pulsating structure in the flare rising phase in HXR. Finally type II and III bursts are seen at the time of maximum HXR emission, simultaneous with the maximum reconnection rate derived from the flare ribbon motion in UV. We interpret these various observed properties with the runaway tether-cutting model proposed by Moore et al. in 2001.
قيم البحث
اقرأ أيضاً
On 2005 September 13 a filament eruption accompanied by a halo CME occurred in the most flare-productive active region NOAA 10808 in Solar Cycle 23. Using multi-wavelength observations before the filament eruption on Sep. 13th, we investigate the pro
cesses leading to the catastrophic eruption. We find that the filament slowly ascended at a speed of 0.1km/s over two days before the eruption. During slow ascending, many small flares were observed close to the footpoints of the filament, where new magnetic elements were emerging. On the basis of the observational facts we discuss the triggering mechanism leading to the filament eruption. We suggest the process toward the eruption as follows: First, a series of small flares played a role in changing the topology of the loops overlying the filament. Second, the small flares gradually changed the equilibrium state of the filament and caused the filament to ascend slowly over two days. Finally, a C2.9 flare that occurred when the filament was close to the critical point for loss of equilibrium directly led to the catastrophic filament eruption right after itself.
Using spectra obtained by the EIS instrument onboard Hinode, we present a detailed spatially resolved abundance map of an active region (AR)-coronal hole (CH) complex that covers an area of 359 arcsec x 485 arcsec. The abundance map provides first io
nization potential (FIP) bias levels in various coronal structures within the large EIS field of view. Overall, FIP bias in the small, relatively young AR is 2-3. This modest FIP bias is a consequence of the AR age, its weak heating, and its partial reconnection with the surrounding CH. Plasma with a coronal composition is concentrated at AR loop footpoints, close to where fractionation is believed to take place in the chromosphere. In the AR, we found a moderate positive correlation of FIP bias with nonthermal velocity and magnetic flux density, both of which are also strongest at the AR loop footpoints. Pathways of slightly enhanced FIP bias are traced along some of the loops connecting opposite polarities within the AR. We interpret the traces of enhanced FIP bias along these loops to be the beginning of fractionated plasma mixing in the loops. Low FIP bias in a sigmoidal channel above the ARs main polarity inversion line where ongoing flux cancellation is taking place, provides new evidence of a bald patch magnetic topology of a sigmoid/flux rope configfiuration.
In this paper, we address the formation of a magnetic flux rope (MFR) that erupted on 2012 July 12 and caused a strong geomagnetic storm event on July 15. Through analyzing the long-term evolution of the associated active region observed by the Atmos
pheric Imaging Assembly and the Helioseismic and Magnetic Imager on board the Solar Dynamics Observatory, it is found that the twisted field of an MFR, indicated by a continuous S-shaped sigmoid, is built up from two groups of sheared arcades near the main polarity inversion line half day before the eruption. The temperature within the twisted field and sheared arcades is higher than that of the ambient volume, suggesting that magnetic reconnection most likely works there. The driver behind the reconnection is attributed to shearing and converging motions at magnetic footpoints with velocities in the range of 0.1--0.6 km s$^{-1}$. The rotation of the preceding sunspot also contributes to the MFR buildup. Extrapolated three-dimensional non-linear force-free field structures further reveal the locations of the reconnection to be in a bald-patch region and in a hyperbolic flux tube. About two hours before the eruption, indications for a second MFR in the form of an S-shaped hot channel are seen. It lies above the original MFR that continuously exists and includes a filament. The whole structure thus makes up a stable double-decker MFR system for hours prior to the eruption. Eventually, after entering the domain of instability, the high-lying MFR impulsively erupts to generate a fast coronal mass ejection and X-class flare; while the low-lying MFR remains behind and continuously maintains the sigmoidicity of the active region.
Active regions often show S-shaped structures in the corona called sigmoids. These are highly sheared and twisted loops formed along the polarity inversion line. They are considered to be one of the best pre-eruption signatures for CMEs. Here, we inv
estigate the thermodynamic evolution of an on-disk sigmoid observed during December 24-28, 2015. For this purpose, we have employed Emission Measure (EM) and filter-ratio techniques on the observations recorded by the Atmospheric Imaging Assembly (AIA) onboard the Solar Dynamics Observatory (SDO) and X-ray Telescope (XRT) onboard Hinode. The EM analysis showed multi-thermal plasma along the sigmoid and provided a peak temperature of 10-12.5 MK for all observed flares. The sigmoidal structure showed emission from Fe XVIII (93.93 {AA}) and Fe XXI 128.75 {AA}) lines in the AIA 94 and 131 {AA} channels, respectively. Our results show that the hot plasma is often confined to very hot strands. The temperature obtained from the EM analysis was found to be in good agreement with that obtained using the XRT, AIA, and GOES filter-ratio methods. These results provide important constraints for the thermodynamic modeling of sigmoidal structures in the core of active regions. Moreover, this study also benchmarks different techniques available for temperature estimation in solar coronal structures.
On SOL2017-09-06 solar active region 12673 produced an X9.3 flare which is regarded as largest to occur in solar cycle 24. In this work we have preformed a magnetohydrodynamic (MHD) simulation in order to reveal the three-dimensional (3D) dynamics of
the magnetic fields associated with the X9.3 solar flare. We first performed an extrapolation of the 3D magnetic field based on the observed photospheric magnetic field prior to the flare and then used it as the initial condition for an MHD simulation. Consequently, the simulation showed a dramatic eruption. In particular, we found that a large coherent flux rope composed of highly twisted magnetic field lines is formed during the eruption. A series of small flux ropes are found to lie along a magnetic polarity inversion line prior to the flare. Reconnection occurring between each small flux rope during the early stages of the eruption forms the large and highly twisted flux rope.Furthermore, we found a writhing motion of the erupting flux rope. The understanding of these dynamics is important in increasing the accuracy of space weather forecasting. We report on the detailed dynamics of the 3D eruptive flux rope and discuss the possible mechanisms of the writhing motion.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
