اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDependence of Dripping on the Orifice Diameter in a Leaky Faucet
61
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report the results of experiments that examined the dependence of the dripping dynamics of a leaky faucet on the orifice diameter. The transition of the dripping frequency between periodic and chaotic states was found to depend on the orifice diameter. We suggest a theoretical explanation for these transitions based on drop formation time scales. In addition, short-range anti-correlations were measured in the chaotic region. These too showed a dependence on the faucet diameter. Finally, a comparison was done between the experimental results with a one-dimensional model for drop formation. Quantitative agreement was found between the simulations and the experimental results.
قيم البحث
اقرأ أيضاً
The formation of a single bubble from an orifice in a solid surface, submerged in an in- compressible, viscous Newtonian liquid, is simulated. The finite element method is used to capture the multiscale physics associated with the problem and to trac
k the evolution of the free surface explicitly. The results are compared to a recent experimental analysis and then used to obtain the global characteristics of the process, the formation time and volume of the bubble, for a range of orifice radii; Ohnesorge numbers, which combine the material parameters of the liquid; and volumetric gas flow rates. These benchmark calculations, for the parameter space of interest, are then utilised to validate a selection of scaling laws found in the literature for two regimes of bubble formation, the regimes of low and high gas flow rates.
Dripping water from a faucet is a typical example exhibiting rich nonlinear phenomena. For such a system, the time stamps at which water drops separate from the faucet can be directly observed in real experiments, and the time series of intervals tau
_n between drop separations becomes a subject of analysis. Even if the mass m_n of a drop at the onset of the n-th separation, which cannot be observed directly, exhibits perfectly deterministic dynamics, it sometimes fails to obtain important information from time series of tau_n. This is because the return plot tau_n-1 vs. tau_n may become a multi-valued function, i.e., not a deterministic dynamical system. In this paper, we propose a method to construct a nonlinear coordinate which provides a surrogate of the internal state m_n from the time series of tau_n. Here, a key of the proposed approach is to use ISOMAP, which is a well-known method of manifold learning. We first apply it to the time series of $tau_n$ generated from the numerical simulation of a phenomenological mass-spring model for the dripping faucet system. It is shown that a clear one-dimensional map is obtained by the proposed approach, whose characteristic quantities such as the Lyapunov exponent, the topological entropy, and the time correlation function coincide with the original dripping faucet system. Furthermore, we also analyze data obtained from real dripping faucet experiments which also provides promising results.
We study a liquid jet that breaks up into drops in an external co-flowing liquid inside a confining microfluidic geometry. The jet breakup can occur right after the nozzle in a phenomenon named dripping or through the generation of a liquid jet that
breaks up a long distance from the nozzle, which is called jetting. Traditionally, these two regimes have been considered to reflect the existence of two kinds of spatiotemporal instabilities of a fluid jet, the dripping regime corresponding to an absolutely unstable jet and the jetting regime to a convectively unstable jet. Here, we present quantitative measurements of the dripping and jetting regimes, both in an unforced and a forced state, and compare these measurements with recent theoretical studies of spatiotemporal instability of a confined liquid jet in a co-flowing liquid. In the unforced state, the frequency of oscillation and breakup of the liquid jet is measured and compared to the theoretical predictions. The dominant frequency of the jet oscillations as a function of the inner flow rate agrees qualitatively with the theoretical predictions in the jetting regime but not in the dripping regime. In the forced state, achieved with periodic laser heating, the dripping regime is found to be insensitive to the perturbation and the frequency of drop formation remains unaltered. The jetting regime, on the contrary, amplifies the externally imposed frequency, which translates in the formation of drops at the frequency imposed by the external forcing. In conclusion, the dripping and jetting regimes are found to exhibit the main features of absolutely and convectively unstable flows respectively, but the frequency selection in the dripping regime is not ruled by the absolute frequency predicted by the stability analysis.
The short-term transient falling dynamics of a dripping water drop in quiescent air has been investigated through both simulation and experiment. The focus is on the short term behavior and the time range considered covers about eight dominant second
-mode oscillations of the drop after it is formed. Due to the small fluid inertia the growth of the drop is quasi-static and is well captured by the static pendant drop theory. Nevertheless, the pinching dynamics and the resulting post-formation state of the drop trigger a nonlinear oscillation when the drop falls. The initial shape of the drop when it is just formed is decomposed into spherical harmonic modes. The pinching dynamics such as interface overturning introduces small-scale variation on the drop contour, which in turn contributes to the finite amplitudes of the higher-order modes. Furthermore, the initial kinetic energy when the droplet is just formed is as important as the initial surface energy contained in the drop shape, and is found to amplify the initial oscillation amplitude and to induce a phase shift in the oscillation of all the modes. By incorporating both the initial surface and kinetic energy, the linear model for a free drop oscillation yields very good predictions for the second and third modes. The mode amplitude spectra show both the primary frequencies that are consistent with the Lambs theory and the secondary frequencies arising from different modes due to nonlinear inter-mode coupling. The complex transient flow inside and outside the drop is induced by the interaction between the falling motion and the nonlinear oscillation. The streamlines indicate that the internal flow is substantially different from the Hill vortex for a falling drop without oscillation. The temporal evolutions of both the internal flow and the wake morphology follow the dominant second oscillation mode.
Drop impact causes severe surface erosion, dictating many important natural, environmental and engineering processes and calling for tremendous prevention and preservation efforts. Nevertheless, despite extensive studies on various kinematic features
of impacting drops over the last two decades, the dynamic process that leads to the drop-impact erosion is still far from clear. Here, we develop a method of high-speed stress microscopy, which measures the key dynamic properties of drop impact responsible for erosion, i.e., the shear stress and pressure distributions of impacting drops, with unprecedented spatiotemporal resolutions. Our experiments reveal the fast propagation of self-similar noncentral stress maxima underneath impacting drops and quantify the shear force on impacted substrates. Moreover, we examine the deformation of elastic substrates under impact and uncover impact-induced surface shock waves. Our study opens the door for quantitative measurements of the impact stress of liquid drops and sheds light on the mysterious origin of drop-impact erosion.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
