اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTheory of ground state cooling of a mechanical oscillator using dynamical back-action
88
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A quantum theory of cooling of a mechanical oscillator by radiation pressure-induced dynamical back-action is developed, which is analogous to sideband cooling of trapped ions. We find that final occupancies well below unity can be attained when the mechanical oscillation frequency is larger than the cavity linewidth. It is shown that the final average occupancy can be retrieved directly from the optical output spectrum.
قيم البحث
اقرأ أيضاً
Cooling of a 58 MHz micro-mechanical resonator from room temperature to 11 K is demonstrated using cavity enhanced radiation pressure. Detuned pumping of an optical resonance allows enhancement of the blue shifted motional sideband (caused by the osc
illators Brownian motion) with respect to the red-shifted sideband leading to cooling of the mechanical oscillator mode. The reported cooling mechanism is a manifestation of the effect of radiation pressure induced dynamical backaction. These results constitute an important step towards achieving ground state cooling of a mechanical oscillator.
The standard quantum limit constrains the precision of an oscillator position measurement. It arises from a balance between the imprecision and the quantum back-action of the measurement. However, a measurement of only a single quadrature of the osci
llator can evade the back-action and be made with arbitrary precision. Here we demonstrate quantum back-action evading measurements of a collective quadrature of two mechanical oscillators, both coupled to a common microwave cavity. The work allows for quantum state tomography of two mechanical oscillators, and provides a foundation for macroscopic mechanical entanglement and force sensing beyond conventional quantum limits.
We address the interaction between two quantum systems (A and B) that is mediated by their common linear environment. If the environment is out of equilibrium the resulting interaction violates Onsager relations and cannot be described by a Hamiltoni
an. In simple terms the action of system A on system B does not necessarily produce a back-action. We derive general quantum equations describing the situation and analyze in details their classical correspondence. Changing the properties of the environment one can easily change and engineer the resulting interaction. It is tempting to use this for quantum manipulation of the systems. However the resulting quantum gate is not always unitary and may induce a loss of quantum coherence. For a relevant example we consider systems A and B to be spins of arbitrary values and arrange the interaction to realize an analogue of the two-qubit CNOT gate. The direction of spin A controls the rotation of spin B while spin A is not rotated experiencing no back-action from spin B. We solve the quantum dynamics equations and analyze the purity of the resulting density matrix. The resulting purity essentially depends on the initial states of the systems. We attempt to find a universal characteristics of the purity optimizing it for the worst choice of initial states. For both spins $s_A=s_B=1/2$, the optimized purity is bounded by 1/2 irrespective of the details of the gate. We also study in detail the semiclassical limit of large spins. In this case the optimized purity is bounded by $(1+pi/2)^{-1}approx0.39$. This is much better than the typical purity of a large spin state $sim s^{-1}$. We conclude that although the quantum manipulation without back-action inevitably causes decoherence of the quantum states the actual purity of the resulting state can be optimized and made relatively high.
We propose an optimization scheme for ground-state cooling of a mechanical mode by coupling to a general three-level system. We formulate the optimization scheme, using the master equation approach, over a broad range of system parameters including d
etunings, decay rates, coupling strengths, and pumping rate. We implement the optimization scheme on three physical systems: a colloidal quantum dot coupled to its confined phonon mode, a polariton coupled to a mechanical resonator mode, and a coupled-cavity system coupled to a mechanical resonator mode. These three physical systems span a broad range of mechanical mode frequencies, coupling rates, and decay rates. Our optimization scheme lowers the stead-state phonon number in all three cases by orders of magnitude. We also calculate the net cooling rate by estimating the phonon decay rate and show that the optimized system parameters also result in efficient cooling. The proposed optimization scheme can be readily extended to any generic driven three-level system coupled to a mechanical mode.
We study the back-action of a nearby measurement device on electrons undergoing coherent transfer via adiabatic passage (CTAP) in a triple-well system. The measurement is provided by a quantum point contact capacitively coupled to the middle well, th
us acting as a detector sensitive to the charge configuration of the triple-well system. We account for this continuous measurement by treating the whole {triple-well + detector} as a closed quantum system. This leads to a set of coupled differential equations for the density matrix of the enlarged system which we solve numerically. This approach allows to study a single realization of the measurement process while keeping track of the detector output, which is especially relevant for experiments. In particular, we find the emergence of a new peak in the distribution of electrons that passed through the point contact. As one increases the coupling between the middle potential well and the detector, this feature becomes more prominent and is accompanied by a substantial drop in the fidelity of the CTAP scheme.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
