اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدReconstruction of sub-threshold events of cosmic-ray radio detectors using an autoencoder
65
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Radio detection of air showers produced by ultra-high energy cosmic rays is a cost-effective technique for the next generation of sparse arrays. The performance of this technique strongly depends on the environmental background, which has different constituents, namely anthropogenic radio frequency interference, synchrotron galactic radiation and others. These components have recognizable features, which can help for background suppression. A powerful method for handling this is the application of convolution neural networks with a specific architecture called autoencoder. By suppressing unwanted signatures, the autoencoder keeps the signal-like ones. We have successfully developed and trained an autoencoder, which is now applied to the data from Tunka-Rex. We show the procedures of the training and optimization of the network including benchmarks of different architectures. Using the autoencoder, we improved the standard analysis of Tunka-Rex in order to lower the threshold of the detection. This enables the reconstructing of sub-threshold events with energies lower than 0.1 EeV with satisfactory angular and energy resolutions.
قيم البحث
اقرأ أيضاً
We present an improved method for the precise reconstruction of cosmic ray air showers above $10^{17}$ eV with sparse radio arrays. The method is based on the comparison of predictions for radio pulse shapes by CoREAS simulations to measured pulses.
We applied our method to the data of Tunka-Rex, a 1 km$^2$ radio array in Siberia operating in the frequency band of 30-80 MHz. Tunka-Rex is triggered by the air-Cherenkov detector Tunka-133 and by scintillators (Tunka-Grande). The instrument collects air-shower data since 2012. The present paper describes updated data and signal analyses of Tunka-Rex and details of a new method applied. After efficiency cuts, when Tunka-Rex reaches its full efficiency, the energy resolution of about 10% given by the new method has reached the limit of systematic uncertainties due to the calibration uncertainty and shower-to-shower fluctuations. At the same time the shower maximum reconstruction is significantly improved up to an accuracy of 35 g/cm$^2$ compared to the previous method based on the slope of the lateral distribution. We also define and now achieved conditions of the measurements, at which the shower maximum resolution of Tunka-Rex reaches a value of 25 g/cm$^2$ and becomes competitive to optical detectors. To check and validate our reconstruction and efficiency cuts we compare individual events to the reconstruction of Tunka-133. Furthermore, we compare the mean of shower maximum as a function of primary energy to the measurements of other experiments.
While the radio detection of cosmic rays has advanced to a standard method in astroparticle physics, the radio detection of neutrinos is just about to start its full bloom. The successes of pilot-arrays have to be accompanied by the development of mo
dern and flexible software tools to ensure rapid progress in reconstruction algorithms and data processing. We present NuRadioReco as such a modern Python-based data analysis tool. It includes a suitable data-structure, a database-implementation of a time-dependent detector, modern browser-based data visualization tools, and fully separated analysis modules. We describe the framework and examples, as well as new reconstruction algorithms to obtain the full three-dimensional electric field from distributed antennas which is needed for high-precision energy reconstruction of particle showers.
Due to fundamental limitations of accelerators, only cosmic rays can give access to centre-of- mass energies more than one order of magnitude above those reached at the LHC. In fact, extreme energy cosmic rays (1018 eV - 1020 eV) are the only possibi
lity to explore the 100 TeV energy scale in the years to come. This leap by one order of magnitude gives a unique way to open new horizons: new families of particles, new physics scales, in-depth investigations of the Lorentz symmetries. However, the flux of cosmic rays decreases rapidly, being less than one particle per square kilometer per year above 1019 eV: one needs to sample large surfaces. A way to develop large-effective area, low cost, detectors, is to build a solar panel-based device which can be used in parallel for power generation and Cherenkov light detection. Using solar panels for Cherenkov light detection would combine power generation and a non-standard detection device.
Arrays of imaging atmospheric Cherenkov telescopes (IACT) are superb instruments to probe the very-high-energy gamma-ray sky. This type of telescope focuses the Cherenkov light emitted from air showers, initiated by very-high-energy gamma rays and co
smic rays, onto the camera plane. Then, a fast camera digitizes the longitudinal development of the air shower, recording its spatial, temporal, and calorimetric information. The properties of the primary very-high-energy particle initiating the air shower can then be inferred from those images: the primary particle can be classified as a gamma ray or a cosmic ray and its energy and incoming direction can be estimated. This so-called full-event reconstruction, crucial to the sensitivity of the array to gamma rays, can be assisted by machine learning techniques. We present a deep-learning driven, full-event reconstruction applied to simulated IACT events using CTLearn. CTLearn is a Python package that includes modules for loading and manipulating IACT data and for running deep learning models with TensorFlow, using pixel-wise camera data as input.
Aimed at progress in MeV gamma-ray astronomy which has not yet been well-explored, Compton telescope missions with a variety of detector concepts have been proposed so far. One of the key techniques for these future missions is an event reconstructio
n algorithm that is able to determine the scattering orders of multiple Compton scattering events and to identify events in which gamma rays escape from the detectors before they deposit all of their energies. We propose a new algorithm that can identify whether the gamma rays escape from the detectors or not, in addition to the scattering order determination. This algorithm also corrects incoming gamma-ray energies for escape events. The developed algorithm is based on the maximum likelihood method, and we present a general formalism of likelihood functions describing physical interactions inside the detector. We also introduce several approximations in the calculation of the likelihood functions for efficient computation. For validation, we have applied the algorithm to simulation data of a Compton telescope using a liquid argon time projection chamber, which is a new type of Compton telescope proposed for the GRAMS mission, and have confirmed that it works successfully for up to 8-hit events. The proposed algorithm can be used for next-generation MeV gamma-ray missions featured by large-volume detectors, e.g., GRAMS and AMEGO.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
