اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدProperties of MoO2 and MoO3 Films Prepared from the Chemically Driven Isothermal Close Space Vapor Transport Technique
63
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Chemically _ driven isothermal close space vapour transport was used to prepare pure MoO2 films which were eventually converted to MoO3 by annealing in air. According to temperature_dependent Raman measurements, the MoO2/MoO3 phase transformation was found to occur in the 225 _ 350 oC range; no other phases were detected during the transition. A clear change in composition and Raman spectra, as well as noticeable modifications of the band gap and the absorption coefficient confirmed the conversion from MoO2 to MoO3. An extensive characterization of films of both pure phases was carried out. In particular, a procedure was developed to determine the dispersion relation of the refractive index of MoO2 from the shift of the interference fringes the used SiO2/Si substrate. The obtained refractive index was corrected taking into account the porosity calculated from elastic backscattering spectrometry. The Debye temperature and the residual resistivity were extracted from the electrical resistivity temperature dependence using the Bloch _ Gruneisen equation. MoO3 converted samples presented very high resistivity and a typical semiconducting behaviour. They also showed intense and broad luminescence spectra, which were deconvoluted considering several contributions; and its behaviour with temperature was examined. Furthermore, surface photovoltage spectra were taken and the relation of these spectra with the photoluminescence is discussed.
قيم البحث
اقرأ أيضاً
A novel procedure, based in a closed space vapor transport (CSVT) configuration, has been devised to grow films or flakes of pure MoO2 in a reductive atmosphere, at relatively low temperature and using MoO3 as the source. In contrast with conventiona
l CSVT technique, in the proposed method a temperature gradient is not required for the growth to take place, which occurs through an intermediate volatile transport species that is produced in the complex reduction reaction of MoO3. An added value of this simple method is the possibility of transforming the MoO2 into MoTe2, one of the most interesting members of the transition metal dichalcogenide family. This is achieved in a sequential process that includes the growth of Mo oxide and its (in-situ) tellurization in two consecutive steps.
The electronic transport in polypyrrole thin films synthesized chemically from the vapor phase is studied as a function of temperature as well as of electric and magnetic fields. We find distinct differences in comparison to the behavior of both poly
pyrrole films prepared by electrochemical growth as well as of the bulk films obtained from conventional chemical synthesis. For small electric fields F, a transition from Efros-Shklovskii variable range hopping to Arrhenius activated transport is observed at 30 K. High electric fields induce short range hopping. The characteristic hopping distance is found to be proportional to F^(-1/2). The magnetoresistance R(B) is independent of F below a critical magnetic field, above which F counteracts the magnetic field induced localization.
Isothermal Close Space Sublimation (ICSS) technique was used for embedding porous silicon (PS) films with ZnTe. It was studied the influence of the preparation conditions and in particular of a chemical etching step before the ZnTe growth, on the com
position profile and final porosity of ZnTe embedded PS. The structure of the embedded material was determined by x-ray diffraction analysis while the thickness of the samples was determined by scanning electron microscopy (SEM). Rutherford backscattering (RBS) and Energy Dispersive (EDS) spectrometries allowed determining the composition profiles. We conclude that the etching of the PS surface before the ZnTe growth has two main effects: the increase of the porosity and enhancing the reactivity of the inner surface. It was observed that both effects benefit the filling process of the pores. Since RBS and EDS cannot detect the porosity in the present system, we explore the evolution of porosity by the fitting of the UV-VIS reflectance spectra. The atomic percent determined with this method was in relatively good agreement with that obtained from the RBS and EDS measurements.
Er-doped aluminum nitride films, containing different Er concentrations, were obtained at room temperature by reactive radio frequency magnetron sputtering. The prepared samples show a nano-columnar microstructure and the size of the columns is depen
dent on the magnetron power. The Er-related photoluminescence (PL) was studied in relation with the temperature, the Er content and the microstructure. Steady-state PL, PL excitation spectroscopy and time-resolved PL were performed. Both visible and near infrared PL were obtained at room temperature for the as-deposited samples. It is demonstrated that the PL intensity reaches a maximum for an Er concentration equal to 1 at. % and that the PL efficiency is an increasing function of the magnetron power. Decay time measurements show the important role of defect related non radiative recombination, assumed to be correlated to the presence of grain boundaries. Moreover PL excitation results demonstrate that an indirect excitation of Er 3+ ions occurs for excitation wavelengths lower than 600 nm. It is also suggested that Er ions occupy at least two different sites in the AlN host matrix.
Uniform single layer graphene was grown on single-crystal Ir films a few nanometers thick which were prepared by pulsed laser deposition on sapphire wafers. These graphene layers have a single crystallographic orientation and a very low density of de
fects, as shown by diffraction, scanning tunnelling microscopy, and Raman spectroscopy. Their structural quality is as high as that of graphene produced on Ir bulk single crystals, i.e. much higher than on metal thin films used so far.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
