اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDimensional enhancements in quantum battery with imperfections
105
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Power storage devices are shown to increase their efficiency if they are designed by using quantum systems. We show that the average power output of a quantum battery based on a quantum interacting spin model, charged via a local magnetic field, can be enhanced with the increase of spin quantum number. In particular, we demonstrate such increment in the power output when the initial state of the battery is prepared as the ground or canonical equilibrium state of the spin-j XY model and the bilinear-biquadratic spin-j Heisenberg chain (BBH) in presence of the transverse magnetic field. Interestingly, we observe that in the case of the XY model, a trade-off relation exists between the range of interactions in which the power increases and the dimension while for the BBH model, the improvements depend on the phase in which the initial state is prepared. Moreover, we exhibit that such dimensional advantages persist even when the battery-Hamiltonian has some defects or when the initial battery-state is prepared at finite temperature.
قيم البحث
اقرأ أيضاً
Previous research on nonlinear oscillator networks has shown that chaos synchronization is attainable for identical oscillators but deteriorates in the presence of parameter mismatches. Here, we identify regimes for which the opposite occurs and show
that oscillator heterogeneity can synchronize chaos for conditions under which identical oscillators cannot. This effect is not limited to small mismatches and is observed for random oscillator heterogeneity on both homogeneous and heterogeneous network structures. The results are demonstrated experimentally using networks of Chuas oscillators and are further supported by numerical simulations and theoretical analysis. In particular, we propose a general mechanism based on heterogeneity-induced mode mixing that provides insights into the observed phenomenon. Since individual differences are ubiquitous and often unavoidable in real systems, it follows that such imperfections can be an unexpected source of synchronization stability.
Current quantum devices execute specific tasks that are hard for classical computers and have the potential to solve problems such as quantum simulation of material science and chemistry, even without error correction. For practical applications it i
s highly desirable to reconfigure the connectivity of the device, which for superconducting quantum processors is determined at fabrication. In addition, we require a careful design of control lines and couplings to resonators for measurements. Therefore, it is a cumbersome and slow undertaking to fabricate a new device for each problem we want to solve. Here we periodically drive a one-dimensional chain to engineer effective Hamiltonians that simulate arbitrary connectivities. We demonstrate the capability of our method by engineering driving sequences to simulate star, all-to-all, and ring connectivities. We also simulate a minimal example of the 3-SAT problem including three-body interactions, which are difficult to realize experimentally. Our results open a new paradigm to perform quantum simulation in near term quantum devices by enabling us to stroboscopically simulate arbitrary Hamiltonians with a single device and optimized driving sequences
We design a quantum battery made up of bosons or fermions in an ultracold atom setup, described by Fermi-Hubbard (FH) and Bose-Hubbard (BH) models respectively. We compare the performance of bosons as well as fermions and check which can act more eff
iciently as a quantum battery for a given on-site interaction and temperature of the initial state. The performance of a quantum battery is quantified by the maximum power generated over the time evolution under an on-site charging Hamiltonian. We report that when the initial battery state is in the ground state, fermions outperform bosons in a certain configuration over a large range of on-site interactions which are shown analytically for a smaller number of lattice sites and numerically for a considerable number of sites. Bosons take the lead when the temperature is comparatively high in the initial state for a longer range of on-site interaction. We perform the study of a number of up and down fermions as well as the number of bosons per site to find the optimal filling factor for maximizing the power of the battery. We also introduce disorder in both on-site and hopping parameters and demonstrate that the maximum power is robust against impurities. Moreover, we identify a range of tuning parameters in the fermionic as well as bosonic systems where the disorder-enhanced power is observed.
The time evolution of one- and two-dimensional discrete-time quantum walk with increase in disorder is studied. We use spatial, temporal and spatio-temporal broken periodicity of the unitary evolution as disorder to mimic the effect of disordered/ran
dom medium in our study. Disorder induces a dramatic change in the interference pattern leading to localization of the quantum walks in one- and two-dimensions. Spatial disorder results in the decreases of the particle and position entanglement in one-dimension and counter intuitively, an enhancement in entanglement with temporal and spatio-temporal disorder is seen. The study signifies that the Anderson localization of quantum state without compromising on the degree of entanglement could be implement in a large variety of physical settings where quantum walks has been realized. The study presented here could make it feasible to explore, theoretically and experimentally the interplay between disorder and entanglement. This also brings up a variety of intriguing questions relating to the negative and positive implications on algorithmic and other applications.
Tomography of a quantum state is usually based on positive operator-valued measure (POVM) and on their experimental statistics. Among the available reconstructions, the maximum-likelihood (MaxLike) technique is an efficient one. We propose an extensi
on of this technique when the measurement process cannot be simply described by an instantaneous POVM. Instead, the tomography relies on a set of quantum trajectories and their measurement records. This model includes the fact that, in practice, each measurement could be corrupted by imperfections and decoherence, and could also be associated with the record of continuous-time signals over a finite amount of time. The goal is then to retrieve the quantum state that was present at the start of this measurement process. The proposed extension relies on an explicit expression of the likelihood function via the effective matrices appearing in quantum smoothing and solutions of the adjoint quantum filter. It allows to retrieve the initial quantum state as in standard MaxLike tomography, but where the traditional POVM operators are replaced by more general ones that depend on the measurement record of each trajectory. It also provides, aside the MaxLike estimate of the quantum state, confidence intervals for any observable. Such confidence intervals are derived, as the MaxLike estimate, from an asymptotic expansion of multi-dimensional Laplace integrals appearing in Bayesian Mean estimation. A validation is performed on two sets of experimental data: photon(s) trapped in a microwave cavity subject to quantum non-demolition measurements relying on Rydberg atoms; heterodyne fluorescence measurements of a superconducting qubit.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
