اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAbove-room-temperature giant thermal conductivity switching in spintronic multilayer
80
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Thermal switching provides an effective way for active heat flow control, which has recently attracted increasing attention in terms of nanoscale thermal management technologies. In magnetic and spintronic materials, the thermal conductivity depends on the magnetization configuration: this is the magneto-thermal resistance effect. Here we show that an epitaxial Cu/Co$_{50}$Fe$_{50}$ multilayer film exhibits giant magnetic-field-induced modulation of the cross-plane thermal conductivity. The magneto-thermal resistance ratio for the Cu/Co$_{50}$Fe$_{50}$ multilayer reaches 150% at room temperature, which is much larger than the previous record high. Although the ratio decreases with increasing the temperature, the giant magneto-thermal resistance effect of ~100% still appears up to 400 K. The magnetic field dependence of the thermal conductivity of the Cu/Co$_{50}$Fe$_{50}$ multilayer was observed to be about twice greater than that of the cross-plane electrical conductivity. The observation of the giant magneto-thermal resistance effect clarifies a potential of spintronic multilayers as thermal switching devices.
قيم البحث
اقرأ أيضاً
Multilayer MoS2 possesses highly anisotropic thermal conductivities along in-plane and cross-plane directions that could hamper heat dissipation in electronics. With about 9% cross-plane compressive strain created by hydrostatic pressure in a diamond
anvil cell, we observed about 12 times increase in the cross-plane thermal conductivity of multilayer MoS2. Our experimental and theoretical studies reveal that this drastic change arises from the greatly strengthened interlayer interaction and heavily modified phonon dispersions along cross-plane direction, with negligible contribution from electronic thermal conductivity, despite its enhancement of 4 orders of magnitude. The anisotropic thermal conductivity in the multilayer MoS2 at ambient environment becomes almost isotropic under highly compressive strain, effectively transitioning from 2D to 3D heat dissipation. This strain tuning approach also makes possible parallel tuning of structural, thermal and electrical properties, and can be extended to the whole family of 2D Van der Waals solids, down to two layer systems.
Allotropes of carbon, such as diamond and graphene, are among the best conductors of heat. We monitored the evolution of thermal conductivity in thin graphite as a function of temperature and thickness and found an intimate link between high conducti
vity, thickness, and phonon hydrodynamics. The room temperature in-plane thermal conductivity of 8.5-micrometer-thick graphite was 4300 watts per meter-kelvin-a value well above that for diamond and slightly larger than in isotopically purified graphene. Warming enhances thermal diffusivity across a wide temperature range, supporting partially hydrodynamic phonon flow. The enhancement of thermal conductivity that we observed with decreasing thickness points to a correlation between the out-of-plane momentum of phonons and the fraction of momentum relaxing collisions. We argue that this is due to the extreme phonon dispersion anisotropy in graphite.
Materials with negative thermal expansion (NTE), which contract upon heating, are of great interest both technically and fundamentally. Here, we report giant NTE covering room temperature in mechanically milled antiperovksite GaNxMn3 compounds. The m
icrograin GaNxMn3 exhibits a large volume contraction at the antiferromagnetic (AFM) to paramagnetic (PM) (AFM-PM) transition within a temperature window ({Delta}T) of only a few kelvins. The grain size reduces to ~ 30 nm after slight milling, while {Delta}T is broadened to 50K. The corresponding coefficient of linear thermal expansion ({alpha}) reaches ~ -70 ppm/K, which is almost two times larger than those obtained in chemically doped antiperovskite compounds. Further reducing grain size to ~ 10 nm, {Delta}T exceeds 100 K and {alpha} remains as large as -30 ppm/K (-21 ppm/K) for x = 1.0 (x = 0.9). Excess atomic displacements together with the reduced structural coherence, revealed by high-energy X-ray pair distribution functions, are suggested to delay the AFM-PM transition. By controlling the grain size via mechanically alloying or grinding, giant NTE may also be achievable in other materials with large lattice contraction due to electronic or magnetic phase transitions.
Digital alloys of GaSb/Mn have been fabricated by molecular beam epitaxy. Transmission electron micrographs showed good crystal quality with individual Mn-containing layers well resolved; no evidence of 3D MnSb precipitates was seen in as-grown sampl
es. All samples studied exhibited ferromagnetism with temperature dependent hysteresis loops in the magnetization accompanied by metallic p-type conductivity with a strong anomalous Hall effect (AHE) up to 400 K (limited by the experimental setup). The anomalous Hall effect shows hysteresis loops at low temperatures and above room temperature very similar to those seen in the magnetization. The strong AHE with hysteresis indicates that the holes interact with the Mn spins above room temperature. All samples are metallic, which is important for spintronics applications. * To whom correspondence should be addressed. E-mail: [email protected]
We present a theoretical proposal for the design of a thermal switch based on the anisotropy of the thermal conductivity of PbTiO3 and of the possibility to rotate the ferroelectric polarization with an external electric field. Our calculations are b
ased on an iterative solution of the phonon Boltzmann Transport Equation and rely on interatomic force constants computed within an efficient second-principles density functional theory scheme. We also characterize the hysteresis cycle of the thermal conductivity in presence of an applied electric field and show that the response time would be limited by speed of the ferroelectric switch itself and thus can operate in the high-frequency regime.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
