اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThickness-dependent quantum transport of Weyl fermions in ultra-high-quality SrRuO3 films
113
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The recent observation of Weyl fermions in the itinerant 4d ferromagnetic perovskite SrRuO3 points to this material being a good platform for exploring novel physics related to a pair of Weyl nodes in epitaxial heterostructures. In this letter, we report the thickness-dependent magnetotransport properties of ultra-high-quality epitaxial SrRuO3 films grown under optimized conditions on SrTiO3 substrates. Signatures of Weyl fermion transport, i.e., unsaturated linear positive magnetoresistance accompanied by a quantum oscillation having a {pi} Berry phase, were observed in films with thicknesses as small as 10 nm. Residual resistivity increased with decreasing film thickness, indicating disorder near the interface between SrRuO3 and the SrTiO3 substrate. Since this disorder affects the magnetic and electrical properties of the films, the Curie temperature decreases and the coercive field increases with decreasing thickness. Thickness-dependent magnetotransport measurements revealed that the threshold residual resistivity ratio (RRR) to observe Weyl fermion transport is 21. These results provide guidelines for realizing quantum transport of Weyl fermions in SrRuO3 near heterointerfaces.
قيم البحث
اقرأ أيضاً
Epitaxial strain in 4d ferromagnet SrRuO3 films is directly linked to the physical properties through the strong coupling between lattices, electrons, and spins. It provides an excellent opportunity to tune the functionalities of SrRuO3 in electronic
and spintronic devices. However, a thorough understanding of the epitaxial strain effect in SrRuO3 has remained elusive due to the lack of systematic studies. This study demonstrates wide-range epitaxial strain control of electrical and magnetic properties in high-quality SrRuO3 films. The epitaxial strain was imposed by cubic or pseudocubic perovskite substrates having a lattice mismatch of -1.6 to 2.3% with reference to bulk SrRuO3. The Poisson ratio, which describes the two orthogonal distortions due to the substrate clamping effect, is estimated to be 0.33. The Curie temperature (TC) and residual resistivity ratios of the series of films are higher than or comparable to the highest reported values for SrRuO3 on each substrate, confirming the high crystalline quality of the films. A TC of 169 K is achieved in a tensile-strained SrRuO3 film on the DyScO3 (110) substrate, which is the highest value ever reported for SrRuO3. The TC (146-169 K), magnetic anisotropy (perpendicular or in-plane magnetic easy axis), and metallic conduction (residual resistivity at 2 K of 2.10 - 373 {mu}{Omega}cm) of SrRuO3 are widely controlled by epitaxial strain. These results provide guidelines to design SrRuO3-based heterostructures for device applications.
Magnetic Weyl fermions, which occur in magnets, have novel transport phenomena related to pairs of Weyl nodes, and they are, of both, scientific and technological interest, with the potential for use in high-performance electronics, spintronics and q
uantum computing. Although magnetic Weyl fermions have been predicted to exist in various oxides, evidence for their existence in oxide materials remains elusive. SrRuO3, a 4d ferromagnetic metal often used as an epitaxial conducting layer in oxide heterostructures, provides a promising opportunity to seek for the existence of magnetic Weyl fermions. Advanced oxide thin film preparation techniques, driven by machine learning technologies, may allow access to such topological matter. Here we show direct quantum transport evidence of magnetic Weyl fermions in an epitaxial ferromagnetic oxide SrRuO3: unsaturated linear positive magnetoresistance (MR), chiral-anomaly-induced negative MR, Pi Berry phase accumulated along cyclotron orbits, light cyclotron masses and high quantum mobility of about 10000 cm2/Vs. We employed machine-learning-assisted molecular beam epitaxy (MBE) to synthesize SrRuO3 films whose quality is sufficiently high to probe their intrinsic quantum transport properties. We also clarified the disorder dependence of the transport of the magnetic Weyl fermions, and provided a brand-new diagram for the Weyl transport, which gives a clear guideline for accessing the topologically nontrivial transport phenomena. Our results establish SrRuO3 as a magnetic Weyl semimetal and topological oxide electronics as a new research field.
Lattice structure can dictate electronic and magnetic properties of a material. Especially, reconstruction at a surface or heterointerface can create properties that are fundamentally different from those of the corresponding bulk material. We have i
nvestigated the lattice structure on the surface and in the thin films of epitaxial SrRuO3 with the film thickness up to 22 pseudo-cubic unit cells (u.c.), using the combination of surface sensitive low energy electron diffraction and bulk sensitive scanning transmission electron microscopy. Our analysis indicates that, in contrast to many perovskite oxides, the RuO6 tilt and rotational distortions appear even in single unit cell SrRuO3 thin films on cubic SrTiO3, while the full relaxation to the bulk-like orthorhombic structure takes 3-4 u.c. from the interface for thicker films. Yet the TiO6 octahedra of the substrate near the interface with SrRuO3 films show no sign of distortion, unlike those near the interface with CaRuO3 films. Two orthogonal in-plane rotated structural domains are identified. These structural distortions are essential for the nature of the thickness dependent transport and magnetism in ultrathin films.
Terahertz time-domain conductivity measurements in 2 to 100 nm thick iron films resolve the femtosecond time delay between applied electric fields and resulting currents. This current response time decreases from 29 fs for thickest films to 7 fs for
the thinnest films. The macroscopic response time is not strictly proportional to the conductivity. This excludes the existence of a single relaxation time universal for all conduction electrons. We must assume a distribution of microscopic momentum relaxation times. The macroscopic response time depends on average and variation of this distribution; the observed deviation between response time and conductivity scaling corresponds to the scaling of the variation. The variation of microscopic relaxation times depends on film thickness because electrons with different relaxation times are affected differently by the confinement since they have different mean free paths.
Thin films of the ferromagnetic metal SrRuO3 (SRO) show a varying easy magnetization axis depending on the epitaxial strain and undergo a metal-to-insulator transition with decreasing film thickness. We have investigated the magnetic properties of SR
O thin films with varying thicknesses fabricated on SrTiO3(001) substrates by soft x-ray magnetic circular dichroism (XMCD) at the Ru M2,3 edge. Results have shown that, with decreasing film thickness, the film changes from ferromagnetic to non-magnetic around 3monolayer thickness, consistent with previous magnetization and magneto-optical Kerr effect measurements. The orbital magnetic moment perpendicular to the film was found to be ~ 0.1{mu}B/Ru atom, and remained nearly unchanged with decreasing film thickness while the spin magnetic moment decreases. Mechanism for the formation of the orbital magnetic moment is discussed based on the electronic structure of the compressively strained SRO film.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
