The paper presents a comprehensive analysis of elastic properties of polystyrene-based nanocomposites filled with different types of inclusions: small spherical particles (SiO2 and Al2O3), alumosilicates (montmorillonite, halloysite natural tubules and Mica) and carbon nanofillers (carbon black and multi-walled carbon nanotubes). Composites were fabricated by melt technology. The analysis of composite melts showed that the introduction of Montmorillonite, Multi-walled carbon nanotubes, and Al2O3 particles provided an increase in melt viscosity by an average of 2 to 5 orders of magnitude over the pure polystyrene. Block samples of composites with different filler concentrations were prepared, and their linear and nonlinear elastic properties were studied. The introduction of more rigid particles led to a more profound increase in the elastic modulus of the composite, with the highest rise of about 80% obtained with carbon fillers. Carbon black particles provided also an enhanced strength at break of about 20% higher than that of pure polystyrene. The nonlinear elastic moduli of composites were shown to be more sensitive to addition of filler particles to the polymer matrix than the linear ones. The nonlinearity coefficient $beta$ comprising the combination of linear and nonlinear elastic moduli of a material demonstrated considerable changes correlating with changes of the Youngs modulus. The absolute value of $beta$ showed rise in 1.5-1.6 times in the CB- and HNT-containing composites as compared to that of pure PS. The changes in nonlinear elasticity of fabricated composites were compared with measurements of the parameters of bulk nonlinear strain waves in them. Variations of wave velocity and decay decrement correlated with observed enhancement of materials nonlinearity.
تحميل البحث