اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHeat flux sensing by anomalous Nernst effect in Fe-Al thin films on a flexible substrate
68
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We performed a numerical analysis of the material parameters required for realizing a heat flux sensor exploiting the anomalous Nernst effect (ANE). The results showed the importance of high thermopower of ANE ($S_{text{ANE}}$) and small saturation magnetization. This motivated us to investigate the effect of Al substitution of Fe on ANE and found $S_{text{ANE}} =$ 3.4 $mu$V/K in Fe$_{81}$Al$_{19}$ because of the dominant intrinsic mechanism. Using this material, we made a prototype ANE-based heat flux sensor on a thin flexible polyimide sheet and demonstrated accurate sensing with it. This study gives important information for enhancing sensor sensitivity.
قيم البحث
اقرأ أيضاً
BiFeO3 thin films have been deposited on Pt/sapphire and Pt/Ti/SiO2/Si substrates with pulsed laser deposition using the same growth conditions, respectively. Au was sputtered as the top electrode. The microscopic structure of the thin film varies by
changing the underlying substrate. Thin films on Pt/sapphire are not resistively switchable due to the formation of Schottky contacts at both the top and the bottom interface. However, thin films on Pt/Ti/SiO2/Si exhibit an obvious resistive switching behavior under forward bias. The conduction mechanisms in BiFeO3 thin films on Pt/sapphire and Pt/Ti/SiO2/Si substrates are discussed to understand the different resistive switching behaviors.
We study Hall effect in sputtered NixPt1-x thin films with different Ni concentrations. Temperature, magnetic field and angular dependencies are analyzed and the phase diagram of NiPt thin films is obtained. It is found that films with sub-critical N
i concentration exhibit cluster-glass behavior at low temperatures with a perpendicular magnetic anisotropy below the freezing temperature. Films with over-critical Ni concentration are ferromagnetic with parallel anisotropy. At the critical concentration the state of the film is strongly frustrated. Such films demonstrate canted magnetization with the easy axis rotating as a function of temperature. The magnetism appears via consecutive paramagnetic - cluster glass - ferromagnetic transitions, rather than a single second-order phase transition. But most remarkably, the extraordinary Hall effect changes sign at the critical concentration. We suggest that this is associated with a reconstruction of the electronic structure of the alloy at the normal metal - ferromagnet quantum phase transition.
We report a scalable approach to synthesize a large-area (up to 4 mm) thin black phosphorus (BP) film on a flexible substrate. We first deposited a red phosphorus (RP) thin-film on a flexible polyester substrate, followed by its conversion to BP in a
high-pressure multi-anvil cell at room temperature. Raman spectroscopy and transmission electron microscopy measurements confirmed the formation of a nano-crystalline BP thin-film with a thickness of around 40 nm. Optical characterization indicates a bandgap of around 0.28 eV in the converted BP, similar to the bandgap measured in exfoliated thin-films. Thin-film BP transistors exhibit a field-effect mobility of around 0.5 cm2/Vs, which can probably be further enhanced by the optimization of the conversion process at elevated temperatures. Our work opens the avenue for the future demonstration of large-scale, high quality thin-film black phosphorus.
We demonstrated a flexible thermoelectric (TE) sheet based on the longitudinal spin Seebeck effect (LSSE) that is especially suitable for heat-flow sensing applications. This TE sheet contained a Ni0.2Zn0.3Fe2.5O4 film which was formed on a flexible
plastic sheet using a spray-coating method known as ferrite plating. The experimental results suggest that the ferrite-plated film, which has a columnar crystal structure aligned perpendicular to the film plane, functions as a unique one-dimensional spin-current conductor suitable for bendable LSSE-based sensors.
In this paper we used Raman spectroscopy to investigate the optical properties of vanadium dioxide (VO2) thin films during the thermally induced insulating to metallic phase transition. We observed a significant difference in transition temperature i
n similar VO2 films grown on quartz and sapphire substrates: the film grown on quartz displayed the phase transition at a lower temperature (Tc=50C) compared a film grown on sapphire (Tc=68C). We also investigated differences in the detected Raman signal for different wavelengths and polarizations of the excitation laser. We found that for either substrate, a longer wavelength (in our case 785 nm) yielded the clearest VO2 Raman spectra, with no polarization dependence.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
