اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStressor-Layer-Induced Elastic Strain Sharing in SrTiO3 Complex Oxide Sheets
118
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A precisely selected elastic strain can be introduced in submicron-thick single-crystal SrTiO3 sheets using a silicon nitride stressor layer. A conformal stressor layer deposited using plasma-enhanced chemical vapor deposition produces an elastic strain in the sheet consistent with the magnitude of the nitride residual stress. Synchrotron x-ray nanodiffraction reveals that the strain introduced in the SrTiO3 sheets is on the order of 10 4, matching the predictions of an elastic model. This approach to elastic strain sharing in complex oxides allows the strain to be selected within a wide and continuous range of values, an effect not achievable in heteroepitaxy on rigid substrates.
قيم البحث
اقرأ أيضاً
Piezoelectricity is inherent only in noncentrosymmetric materials, but a piezoelectric response can also be obtained in centrosymmetric crystals if subjected to inhomogeneous deformation. This phenomenon, known as flexoelectricity, affects the functi
onal properties of insulators, particularly thin films of high permittivity materials. We have measured strain-gradient-induced polarization in single crystals of paraelectric SrTiO$_3$ as a function of temperature and orientation down to and below the 105 K phase transition. Estimates were obtained for all the components of the flexoelectric tensor, and calculations based on these indicate that local polarization around defects in SrTiO$_3$ may exceed the largest ferroelectric polarizations. A sign reversal of the flexoelectric response detected below the phase transition suggests that the ferroelastic domain walls of SrTiO$_3$ may be polar.
Mastery of order-disorder processes in highly non-equilibrium nanostructured oxides has significant implications for the development of emerging energy technologies. However, we are presently limited in our ability to quantify and harness these proce
sses at high spatial, chemical, and temporal resolution, particularly in extreme environments. Here we describe the percolation of disorder at the model oxide interface LaMnO$_3$ / SrTiO$_3$, which we visualize during in situ ion irradiation in the transmission electron microscope. We observe the formation of a network of disorder during the initial stages of ion irradiation and track the global progression of the system to full disorder. We couple these measurements with detailed structural and chemical probes, examining possible underlying defect mechanisms responsible for this unique percolative behavior.
Charge density waves are ubiquitous phenomena in metallic transition metal dichalcogenides. In NbSe$_2$, a triangular $3times3$ structural modulation is coupled to a charge modulation. Recent experiments reported evidence for a triangular-stripe tran
sition at the surface, due to strain or accidental doping and associated to a $4times4$ modulation. We employ textit{ab-initio} calculations to investigate the strain-induced structural instabilities in a pristine single layer and analyse the energy hierarchy of the structural and charge modulations. Our results support the observation of phase separation between triangular and stripe phases in 1H-NbSe$_2$, relating the stripe phase to compressive isotropic strain, favouring the $4times4$ modulation. The observed wavelength of the charge modulation is also reproduced with good accuracy.
The discovery of two-dimensional electron gases (2DEGs) in SrTiO3-based heterostructures provides new opportunities for nanoelectronics. Herein, we create a new type of oxide 2DEG by the epitaxial-strain-induced polarization at an otherwise nonpolar
perovskite-type interface of CaZrO3/SrTiO3. Remarkably, this heterointerface is atomically sharp, and exhibits a high electron mobility exceeding 60,000 cm2V-1s-1 at low temperatures. The 2DEG carrier density exhibits a critical dependence on the film thickness, in good agreement with the polarization induced 2DEG scheme.
Youngs modulus determines the mechanical loads required to elastically stretch a material, and also, the loads required to bend it, given that bending stretches one surface while compressing the opposite one. Flexoelectric materials have the addition
al property of becoming electrically polarized when bent. While numerous studies have characterized this flexoelectric coupling, its impact on the mechanical response, due to the energy cost of polarization upon bending, is largely unexplored. This intriguing contribution of strain gradient elasticity is expected to become visible at small length scales where strain gradients are geometrically enhanced, especially in high permittivity insulators. Here we present nano-mechanical measurements of freely suspended SrTiO3 membrane drumheads. We observe a striking non-monotonic thickness dependence of Youngs modulus upon small deflections. Furthermore, the modulus inferred from a predominantly bending deformation is three times larger than that of a predominantly stretching deformation for membranes thinner than 20 nm. In this regime we extract a giant strain gradient elastic coupling of ~2.2e-6 N, which could be used in new operational regimes of nano-electro-mechanics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
