اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn the nature of the core of $alpha$ Centauri A: the impact of the metallicity mixture
120
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Forward asteroseismic modelling plays an important role towards a complete understanding of the physics taking place in deep stellar interiors. With a dynamical mass in the range over which models develop convective cores while in the main sequence, the solar-like oscillator $alpha$ Centauri A presents itself as an interesting case study. We address the impact of varying the metallicity mixture on the determination of the energy transport process at work in the core of $alpha$ Centauri A. We find that $gtrsim$ 70$%$ of models reproducing the revised dynamical mass of $alpha$ Centauri A have convective cores, regardless of the metallicity mixture adopted. This is consistent with the findings of Nsamba et al., where nuclear reaction rates were varied instead. Given these results, we propose that $alpha$ Centauri A be adopted in the calibration of stellar model parameters when modelling solar-like stars with convective cores.
قيم البحث
اقرأ أيضاً
Understanding the physical process responsible for the transport of energy in the core of $alpha$ Centauri A is of the utmost importance if this star is to be used in the calibration of stellar model physics. Adoption of different parallax measuremen
ts available in the literature results in differences in the interferometric radius constraints used in stellar modelling. Further, this is at the origin of the different dynamical mass measurements reported for this star. With the goal of reproducing the revised dynamical mass derived by Pourbaix & Boffin, we modelled the star using two stellar grids varying in the adopted nuclear reaction rates. Asteroseismic and spectroscopic observables were complemented with different interferometric radius constraints during the optimisation procedure. Our findings show that best-fit models reproducing the revised dynamical mass favour the existence of a convective core ($gtrsim$ 70% of best-fit models), a result that is robust against changes to the model physics. If this mass is accurate, then $alpha$ Centauri A may be used to calibrate stellar model parameters in the presence of a convective core.
Chromospheres and coronae are common phenomena on solar-type stars. Understanding the energy transfer to these heated atmospheric layers requires direct access to the relevant empirical data. Study of these structures has, by and large, been limited
to the Sun thus far. The region of the temperature reversal can be directly observed only in the far infrared and submm. We aim at the determination of the characteristics of the atmosphere in the region of the temperature minimum of the solar sister star alpha Cen A. For the nearby binary system alpha Centauri, stellar parameters are known with high accuracy from measurements. For the basic model parameters Teff, log g and [Fe/H], we interpolate in the grid of GAIA/PHOENIX stellar model atmospheres and compute the corresponding model for the G2 V star alpha Cen A. Comparison with photometric measurements shows excellent agreement between observed photospheric data in the optical and infrared. For longer wavelengths, the modelled spectral energy distribution is compared to MIPS, PACS, SPIRE and LABOCA photometry. A specifically tailored Uppsala model based on the MARCS code and extending further in wavelength is used to gauge the emission characteristics of alpha Cen A in the FIR. Similar to the Sun, the FIR emission of alpha Cen A originates in the minimum temperature region above the stellar photosphere in the visible. However, in comparison with the solar case, the FIR photosphere of alpha Cen A appears marginally cooler, Tmin=T160mu=3920+/-375 K. Beyond the minimum near 160mu, the brightness temperatures increase and this radiation likely originates in warmer regions of the chromosphere of alpha Cen A. To the best of our knowledge this is the first time a temperature minimum has been directly measured on a main-sequence star other than the Sun.
Omega Centauri is a peculiar Globular Cluster formed by a complex stellar population. To shed light on this, we studied 172 stars belonging to the 5 SGBs that we can identify in our photometry, in order to measure their [Fe/H] content as well as esti
mate their age dispersion and the age-metallicity relation. The first important result is that all of these SGBs has a distribution in metallicity with a spread that exceeds the observational errors and typically displays several peaks that indicate the presence of several sub-populations. We were able to identified at least 6 of them based on their mean [Fe/H] content. These metallicity-based sub-populations are seen to varying extents in each of the 5 SGBs. Taking advantage of the age-sensitivity of the SGB we showed that, first of all, at least half of the sub-populations have an age spread of at least 2 Gyrs. Then we obtained an age-metallicity relation that is the most complete up to date for this cluster. The interpretation of the age-metallicity relation is not straightforward, but it is possible that the cluster (or what we can call its progenitor) was initially composed of two populations having different metallicities. Because of their age, it is very unlikely that the most metal-rich derives from the most metal-poor by some kind of chemical evolution process, so they must be assumed as two independent primordial objects or perhaps two separate parts of a single larger object, that merged in the past to form the present-day cluster.
We present models of alpha Centauri A and B implementing an entropy calibration of the mixing-length parameter alpha_MLT, recently developed and successfully applied to the Sun (Spada et al. 2018, ApJ, 869, 135). In this technique the value of alpha_
MLT in the 1D stellar evolution code is calibrated to match the adiabatic specific entropy derived from 3D radiation-hydrodynamics simulations of stellar convective envelopes, whose effective temperature, surface gravity, and metallicity are selected consistently along the evolutionary track. The customary treatment of convection in stellar evolution models relies on a constant, solar-calibrated alpha_MLT. There is, however, mounting evidence that this procedure does not reproduce the observed radii of cool stars satisfactorily. For instance, modelling alpha Cen A and B requires an ad-hoc tuning of alpha_MLT to distinct, non-solar values. The entropy-calibrated models of alpha Cen A and B reproduce their observed radii within 1% (or better) without externally adjusted parameters. The fit is of comparable quality to that of models with freely adjusted alpha_MLT for alpha Cen B (within 1 sigma), while it is less satisfactory for alpha Cen A (within ~ 2.5 sigma). This level of accuracy is consistent with the intrinsic uncertainties of the method. Our results demonstrate the capability of the entropy calibration method to produce stellar models with radii accurate within 1%. This is especially relevant in characterising exoplanet-host stars and their planetary systems accurately.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
