اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSearch for neutral-current induced single photon production at the ND280 near detector in T2K
86
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Neutrino neutral-current induced single photon production is a sub-leading order process for accelerator-based neutrino beam experiments including T2K. It is, however, an important process to understand because it is a background for electron (anti)neutrino appearance oscillation experiments. Here, we performed the first search of this process below 1 GeV using the fine-grained detector at the T2K ND280 off-axis near detector. By reconstructing single photon kinematics from electron-positron pairs, we achieved 95% pure gamma ray sample from 5.738$times 10^{20}$ protons-on-targets neutrino mode data. We do not find positive evidence of neutral current induced single photon production in this sample. We set the model-dependent upper limit on the cross-section for this process, at 0.114$times 10^{-38}$ cm$^2$ (90% C.L.) per nucleon, using the J-PARC off-axis neutrino beam with an average energy of $left<E_ uright>sim 0.6$ GeV. This is the first limit on this process below 1 GeV which is important for current and future oscillation experiments looking for electron neutrino appearance oscillation signals.
قيم البحث
اقرأ أيضاً
This paper reports on the search for heavy neutrinos with masses in the range $140 < M_N < 493$ MeV/c$^2$ using the off-axis near detector ND280 of the T2K experiment. These particles can be produced from kaon decays in the standard neutrino beam and
then subsequently decay in ND280. The decay modes under consideration are $N to ell^{pm}_{alpha} pi^{mp}$ and $N to ell^+_{alpha} ell^-_{beta} u (bar u)$ ($alpha,beta=e,mu$). A search for such events has been made using the Time Projection Chambers of ND280, where the background has been reduced to less than two events in the current dataset in all channels. No excess has been observed in the signal region. A combined Bayesian statistical approach has been applied to extract upper limits on the mixing elements of heavy neutrinos to electron-, muon- and tau- flavoured currents ($U_e^2$, $U_{mu}^2$, $U_{tau}^2$) as a function of the heavy neutrino mass, e.g. $U_e^2 < 10^{-9}$ at $90%$ C.L. for a mass of $390$ MeV/c$^2$. These constraints are competitive with previous experiments.
We report the measurements of single and double differential cross section of muon neutrino charged-current interactions on carbon with a single positively charged pion in the final state at the T2K off-axis near detector using $5.56times10^{20}$ pro
tons on target. The analysis uses data control samples for the background subtraction and the cross section signal, defined as a single negatively charged muon and a single positively charged pion exiting from the target nucleus, is extracted using an unfolding method. The model dependent cross section, integrated over the T2K off-axis neutrino beam spectrum peaking at $0.6$~GeV, is measured to be $sigma = (11.76 pm 0.44 text{(stat)} pm 2.39 text{(syst)}) times 10^{-40} text{cm}^2$~$text{nucleon}^{-1}$. Various differential cross sections are measured, including the first measurement of the Adler angles for single charged pion production in neutrino interactions with heavy nuclei target.
The electron (anti-)neutrino component of the T2K neutrino beam constitutes the largest background in the measurement of electron (anti-)neutrino appearance at the far detector. The electron neutrino scattering is measured directly with the T2K off-a
xis near detector, ND280. The selection of the electron (anti-)neutrino events in the plastic scintillator target from both neutrino and anti-neutrino mode beams is discussed in this paper. The flux integrated single differential charged-current inclusive electron (anti-)neutrino cross-sections, $dsigma/dp$ and $dsigma/dcos(theta)$, and the total cross-sections in a limited phase-space in momentum and scattering angle ($p > 300$ MeV/c and $theta leq 45^{circ}$) are measured using a binned maximum likelihood fit and compared to the neutrino Monte Carlo generator predictions, resulting in good agreement.
The cross section of neutrino-induced neutral-current coherent $pi^0$ production on a carbon-dominated target is measured in the NOvA near detector. This measurement uses a narrow-band neutrino beam with an average neutrino energy of 2.7,GeV, which i
s of interest to ongoing and future long-baseline neutrino oscillation experiments. The measured, flux-averaged cross section is $sigma = 13.8pm0.9 (text{stat})pm2.3 (text{syst}) times 10^{-40},text{cm}^2/text{nucleus}$, consistent with model prediction. This result is the most precise measurement of neutral-current coherent $pi^0$ production in the few-GeV neutrino energy region.
The T2K experiment studies oscillations of an off-axis muon neutrino beam between the J-PARC accelerator complex and the Super-Kamiokande detector. Special emphasis is placed on measuring the mixing angle theta_13 by observing electron neutrino appea
rance via the sub-dominant muon neutrino to electron neutrino oscillation, and searching for CP violation in the lepton sector. The experiment includes a sophisticated, off-axis, near detector, the ND280, situated 280 m downstream of the neutrino production target in order to measure the properties of the neutrino beam and to understand better neutrino interactions at the energy scale below a few GeV. The data collected with the ND280 are used to study charged- and neutral-current neutrino interaction rates and kinematics prior to oscillation, in order to reduce uncertainties in the oscillation measurements by the far detector. A key element of the near detector is the ND280 electromagnetic calorimeter (ECal), consisting of active scintillator bars sandwiched between lead sheets and read outwith multi-pixel photon counters (MPPCs). The ECal is vital to the reconstruction of neutral particles, and the identification of charged particle species. The ECal surrounds the Pi-0 detector (P0D) and the tracking region of the ND280, and is enclosed in the former UA1/NOMAD dipole magnet. This paper describes the design, construction and assembly of the ECal, as well as the materials from which it is composed. The electronic and data acquisition (DAQ) systems are discussed, and performance of the ECal modules, as deduced from measurements with particle beams, cosmic rays, the calibration system, and T2K data, is described.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
