اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFSK-based Simultaneous Wireless Information and Power Transfer in Inductively Coupled Resonant Circuits Exploiting Frequency Splitting
70
0
0.0
(
0
)
تأليف
Peter A. Hoeher
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Inductively coupled resonant circuits are affected by the so-called frequency splitting phenomenon at short distances. In the area of power electronics, tracking of one of the peak frequencies is state-of-the-art. In the data transmission community, however, the frequency splitting effect is often ignored. Particularly, modulation schemes have not yet been adapted to the bifurcation phenomenon. We argue that binary frequency shift keying (2-ary FSK) is a low-cost modulation scheme which well matches the double-peak voltage transfer function $H(s)$, particularly when the quality factor $Q$ is large, whereas most other modulation schemes suffer from the small bandwidths of the peaks. Additionally we show that a rectified version of 2-ary FSK, coined rectified FSK (RFSK), is even more attractive from output power and implementation points of view. Analytical and numerical contributions include the efficiency factor, the impulse response, and the bit error performance. A low-cost incoherent receiver is proposed. Theoretical examinations are supported by an experimental prototype.
قيم البحث
اقرأ أيضاً
In the Internet of Things, learning is one of most prominent tasks. In this paper, we consider an Internet of Things scenario where federated learning is used with simultaneous transmission of model data and wireless power. We investigate the trade-o
ff between the number of communication rounds and communication round time while harvesting energy to compensate the energy expenditure. We formulate and solve an optimization problem by considering the number of local iterations on devices, the time to transmit-receive the model updates, and to harvest sufficient energy. Numerical results indicate that maximum ratio transmission and zero-forcing beamforming for the optimization of the local iterations on devices substantially boost the test accuracy of the learning task. Moreover, maximum ratio transmission instead of zero-forcing provides the best test accuracy and communication round time trade-off for various energy harvesting percentages. Thus, it is possible to learn a model quickly with few communication rounds without depleting the battery.
Simultaneous wireless information and power transfer (SWIPT) is an appealing research area because both information and energy can be delivered to wireless devices simultaneously. In this paper, we propose a diplexer-based receiver architecture that
can utilizes both the doubling frequency and baseband signals after the mixer. The baseband signals are used for information decoding and the doubling frequency signals are converted to direct current for energy harvesting. We analyze the signal in the receiver and find that the power of the energy harvested is equal to that of information decoded. Therefore, the diplexer can be used as a power splitter with a power splitting factor of 0.5. Specifically, we consider a multiuser multi-input single-output (MISO) system, in which each user is equipped with the newly proposed receiver. The problem is formulated as an optimization problem that minimizes the total transmitted power subject to some constraints on each users quality of service and energy harvesting demand. We show that the problem thus formulated is a non-convex quadratically constrained quadratic program (QCQP), which can be solved by semi-definite relaxation.
Simultaneous lightwave information and power transfer (SLIPT) has been regarded as a promising technology to deal with the ever-growing energy consumption and data-rate demands in the Internet of Things (IoT). We propose a resonant beam based SLIPT s
ystem (RB-SLIPT), which deals with the conflict of high deliverable power and mobile receiver positioning with the existing SLIPT schemes. At first, we establish a mobile transmission channel model and depict the energy distribution in the channel. Then, we present a practical design and evaluate the energy/data transfer performance within the moving range of the RB-SLIPT. Numerical evaluation demonstrates that the RB-SLIPT can deliver 5 W charging power and enable 1.5 Gbit/s achievable data rate with the moving range of 20-degree field of view (FOV) over 3 m distance. Thus, RB-SLIPT can simultaneously provide high-power energy and high-rate data transfer, and mobile receiver positioning capability.
Integrating the wireless power transfer (WPT) technology into the wireless communication system has been important for operational cost saving and power-hungry problem solving of electronic devices. In this paper, we propose a resonant beam simultane
ous wireless information and power transfer (RB-SWIPT) system, which utilizes a gain medium and two retro-reflecting surfaces to enhance and retro-reflect energy, and allows devices to recharge their batteries and exchange information from the resonant beam wirelessly. To reveal the SWIPT mechanism and evaluate the SWIPT performance, we establish an analytical end-to-end (E2E) transmission model based on a modular approach and the electromagnetic field propagation. Then, the intra-cavity power intensity distribution, transmission loss, output power, and E2E efficiency can be obtained. The numerical evaluation illustrates that the exemplary RB-SWIPT system can provide about 4.20W electric power and 12.41bps/Hz spectral efficiency, and shorter transmission distance or larger retro-reflecting surface size can lead to higher E2E efficiency. The RB-SWIPT presents a new way for high-power, long-range WPT, and high-rate communication.
Powering mobiles using microwave emph{power transfer} (PT) avoids the inconvenience of battery recharging by cables and ensures uninterrupted mobile operation. The integration of PT and emph{information transfer} (IT) allows wireless PT to be realize
d by building on the existing infrastructure for IT and also leads to compact mobile designs. As a result, emph{simultaneous wireless information and power transfer} (SWIPT) has emerged to be an active research topic that is also the theme of this paper. In this paper, a practical SWIPT system is considered where two multi-antenna stations perform separate PT and IT to a multi-antenna mobile to accommodate their difference in ranges. The mobile dynamically assigns each antenna for either PT or IT. The antenna partitioning results in a tradeoff between the MIMO IT channel capacity and the PT efficiency. The optimal partitioning for maximizing the IT rate under a PT constraint is a NP-hard integer program, and the paper proposes solving it via efficient greedy algorithms with guaranteed performance. To this end, the antenna-partitioning problem is proved to be one that optimizes a sub-modular function over a matroid constraint. This structure allows the application of two well-known greedy algorithms that yield solutions no smaller than the optimal one scaled by factors $(1-1/e)$ and 1/2, respectively.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
