اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMYSTIC: Michigan Young STar Imager at CHARA
110
0
0.0
(
0
)
تأليف
John D. Monnier
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present the design for MYSTIC, the Michigan Young STar Imager at CHARA. MYSTIC will be a K-band, cryogenic, 6-beam combiner for the Georgia State University CHARA telescope array. The design follows the image-plane combination scheme of the MIRC instrument where single-mode fibers bring starlight into a non-redundant fringe pattern to feed a spectrograph. Beams will be injected in polarization-maintaining fibers outside the cryogenic dewar and then be transported through a vacuum feedthrough into the ~220K cold volume where combination is achieved and the light is dispersed. We will use a C-RED One camera (First Light Imaging) based on the eAPD SAPHIRA detector to allow for near-photon-counting performance. We also intend to support a 4-telescope mode using a leftover integrated optics component designed for the VLTI-GRAVITY experiment, allowing better sensitivity for the faintest targets. Our primary science driver motivation is to image disks around young stars in order to better understand planet formation and how forming planets might influence disk structures.
قيم البحث
اقرأ أيضاً
MIRC-X (Michigan InfraRed Combiner-eXeter) is a new highly-sensitive six-telescope interferometric imager installed at the CHARA Array that provides an angular resolution equivalent of up to a 330 m diameter baseline telescope in J and H band wavelen
gths ($tfrac{lambda}{2B}sim0.6$ milli-arcseconds). We upgraded the original MIRC (Michigan InfraRed Combiner) instrument to improve sensitivity and wavelength coverage in two phases. First, a revolutionary sub-electron noise and fast-frame rate C-RED ONE camera based on a SAPHIRA detector was installed. Second, a new-generation beam combiner was designed and commissioned to (i) maximize sensitivity, (ii) extend the wavelength coverage to J-band, and (iii) enable polarization observations. A low-latency and fast-frame rate control software enables high-efficiency observations and fringe tracking for the forthcoming instruments at CHARA Array. Since mid-2017, MIRC-X has been offered to the community and has demonstrated best-case H-band sensitivity down to 8.2 correlated magnitude. MIRC-X uses single-mode fibers to coherently combine light of six telescopes simultaneously with an image-plane combination scheme and delivers a visibility precision better than 1%, and closure phase precision better than $1^circ$. MIRC-X aims at (i) imaging protoplanetary disks, (ii) detecting exoplanets with precise astrometry, and (iii) imaging stellar surfaces and star-spots at an unprecedented angular resolution in the near-infrared. In this paper, we present the instrument design, installation, operation, and on-sky results, and demonstrate the imaging and astrometric capability of MIRC-X on the binary system $iota$ Peg. The purpose of this paper is to provide a solid reference for studies based on MIRC-X data and to inspire future instruments in optical interferometry.
MIRC-X is a six telescope beam combiner at the CHARA array that works in J and H wavelength bands and provides an angular resolution equivalent to a $B$=331m diameter telescope. The legacy MIRC combiner has delivered outstanding results in the fields
of stellar astrophysics and binaries. However, we required higher sensitivity to make ambitious scientific measurements of faint targets such as young stellar objects, binary systems with exoplanets, and active galactic nuclei. For that purpose, MIRC-X is built and is offered to the community since mid-2017. MIRC-X has demonstrated up to two magnitudes of improved faint magnitude sensitivity with the best-case H <= 8. Here we present a review of the instrument and present early science results, and highlight some of our ongoing science programs.
We introduce the Michigan Infrared Test Thermal ELT N-band (MITTEN) Cryostat, a new facility for testing infrared detectors with a focus on mid-infrared (MIR) wavelengths (8-13 microns). New generations of large format, deep well, fast readout MIR de
tectors are now becoming available to the astronomical community. As one example, Teledyne Imaging Sensors (TIS) has introduced a long-wave Mercury-Cadmium-Telluride (MCT) array, GeoSnap, with high quantum efficiency (> 65 %) and improved noise properties compared to previous generation Si:As blocked impurity band (BIB) detectors. GeoSnap promises improved sensitivities, and efficiencies, for future background-limited MIR instruments, in particular with future extremely large telescopes (ELTs). We describe our new test facility suitable for measuring characteristics of these detectors, such as read noise, dark current, linearity, gain, pixel operability, quantum efficiency, and point source imaging performance relative to a background scene, as well as multiple point sources of differing contrast. MITTEN has an internal light source, and soon an accompanying filter wheel and aperture plate, reimaged onto the detector using an Offner relay. The baseline temperature of the cryostat interior is maintained < 40 K and the optical bench maintains a temperature of 16 K using a two-stage pulse-tube cryocooler package from Cryomech. No measurable background radiation from the cryostat interior has yet been detected.
CHARA/SPICA (Stellar Parameters and Images with a Cophased Array) is currently being developed at Observatoire de la C^ote dAzur. It will be installed at the visible focus of the CHARA Array by the end of 2021. It has been designed to perform a large
survey of fundamental stellar parameters with, in the possible cases, a detailed imaging of the surface or environment of stars. To reach the required precision and sensitivity, CHARA/SPICA combines a low spectral resolution mode R = 140 in the visible and single-mode fibers fed by the AO stages of CHARA. This setup generates additional needs before the interferometric combination: the compensation of atmospheric refraction and longitudinal dispersion, and the fringe stabilization. In this paper, we present the main features of the 6-telescopes fibered visible beam combiner (SPICA-VIS) together with the first laboratory and on-sky results of the fringe tracker (SPICA-FT). We describe also the new fringe-tracker simulator developed in parallel to SPICA-FT.
The Planet Formation Imager (PFI, www.planetformationimager.org) is a next-generation infrared interferometer array with the primary goal of imaging the active phases of planet formation in nearby star forming regions. PFI will be sensitive to warm d
ust emission using mid-infrared capabilities made possible by precise fringe tracking in the near-infrared. An L/M band combiner will be especially sensitive to thermal emission from young exoplanets (and their disks) with a high spectral resolution mode to probe the kinematics of CO and H2O gas. In this paper, we give an overview of the main science goals of PFI, define a baseline PFI architecture that can achieve those goals, point at remaining technical challenges, and suggest activities today that will help make the Planet Formation Imager facility a reality.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
