اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA two-band approach to n$lambda$ phase error corrections with LBTIs PHASECam
404
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
PHASECam is the Large Binocular Telescope Interferometers (LBTI) phase sensor, a near-infrared camera which is used to measure tip/tilt and phase variations between the two AO-corrected apertures of the Large Binocular Telescope (LBT). Tip/tilt and phase sensing are currently performed in the H (1.65 $mu$m) and K (2.2 $mu$m) bands at 1 kHz, and the K band phase telemetry is used to send tip/tilt and Optical Path Difference (OPD) corrections to the system. However, phase variations outside the range [-$pi$, $pi$] are not sensed, and thus are not fully corrected during closed-loop operation. PHASECams phase unwrapping algorithm, which attempts to mitigate this issue, still occasionally fails in the case of fast, large phase variations. This can cause a fringe jump, in which case the unwrapped phase will be incorrect by a wavelength or more. This can currently be manually corrected by the observer, but this is inefficient. A more reliable and automated solution is desired, especially as the LBTI begins to commission further modes which require robust, active phase control, including controlled multi-axial (Fizeau) interferometry and dual-aperture non-redundant aperture masking interferometry. We present a multi-wavelength method of fringe jump capture and correction which involves direct comparison between the K band and currently unused H band phase telemetry.
قيم البحث
اقرأ أيضاً
We present a new approach to simulating mixtures of gas and dust in smoothed particle hydrodynamics (SPH). We show how the two-fluid equations can be rewritten to describe a single-fluid mixture moving with the barycentric velocity, with each particl
e carrying a dust fraction. We show how this formulation can be implemented in SPH while preserving the conservation properties (i.e. conservation of mass of each phase, momentum and energy). We also show that the method solves two key issues with the two fluid approach: it avoids over-damping of the mixture when the drag is strong and prevents a problem with dust particles becoming trapped below the resolution of the gas. We also show how the general one-fluid formulation can be simplified in the limit of strong drag (i.e. small grains) to the usual SPH equations plus a diffusion equation for the evolution of the dust fraction that can be evolved explicitly and does not require any implicit timestepping. We present tests of the simplified formulation showing that it is accurate in the small grain/strong drag limit. We discuss some of the issues we have had to solve while developing this method and finally present a preliminary application to dust settling in protoplanetary discs.
We study the central part of Lambda N and Lambda Lambda potential by considering the correlated and uncorrelated two-meson exchange besides the omega exchange contribution. The correlated two-meson is evaluated in a chiral unitary approach. We find t
hat a short range repulsion is generated by the correlated two-meson potential which also produces an attraction in the intermediate distance region. The uncorrelated two-meson exchange produces a sizeable attraction in all cases which is counterbalanced by omega exchange contribution.
With the unprecedented photometric precision of the Kepler Spacecraft, significant systematic and stochastic errors on transit signal levels are observable in the Kepler photometric data. These errors, which include discontinuities, outliers, systema
tic trends and other instrumental signatures, obscure astrophysical signals. The Presearch Data Conditioning (PDC) module of the Kepler data analysis pipeline tries to remove these errors while preserving planet transits and other astrophysically interesting signals. The completely new noise and stellar variability regime observed in Kepler data poses a significant problem to standard cotrending methods such as SYSREM and TFA. Variable stars are often of particular astrophysical interest so the preservation of their signals is of significant importance to the astrophysical community. We present a Bayesian Maximum A Posteriori (MAP) approach where a subset of highly correlated and quiet stars is used to generate a cotrending basis vector set which is in turn used to establish a range of reasonable robust fit parameters. These robust fit parameters are then used to generate a Bayesian Prior and a Bayesian Posterior Probability Distribution Function (PDF) which when maximized finds the best fit that simultaneously removes systematic effects while reducing the signal distortion and noise injection which commonly afflicts simple least-squares (LS) fitting. A numerical and empirical approach is taken where the Bayesian Prior PDFs are generated from fits to the light curve distributions themselves.
PHASECam is the fringe tracker for the Large Binocular Telescope Interferometer (LBTI). It is a near-infrared camera which is used to measure both tip/tilt and fringe phase variations between the two adaptive optics (AO) corrected apertures of the La
rge Binocular Telescope (LBT). Tip/tilt and phase sensing are currently performed in the $H$ (1.65 $mu$m) and $K$ (2.2 $mu$m) bands at 1 kHz, but only the $K$-band phase telemetry is used to send corrections to the system in order to maintain fringe coherence and visibility. However, due to the cyclic nature of the fringe phase, only the phase, modulo 360 deg, can be measured. PHASECams phase unwrapping algorithm, which attempts to mitigate this issue, occasionally fails in the case of fast, large phase variations or low signal-to-noise ratio. This can cause a fringe jump, in which case the OPD correction will be incorrect by a wavelength. This can currently be manually corrected by the operator. However, as the LBTI commissions further modes which require robust, active phase control and for which fringe jumps are harder to detect, including multi-axial (Fizeau) interferometry and dual-aperture non-redundant aperture masking interferometry, a more reliable and automated solution is desired. We present a multi-wavelength method of fringe jump capture and correction which involves direct comparison between the $K$-band and $H$-band phase telemetry. We demonstrate the method utilizing archival PHASECam telemetry, showing it provides a robust, reliable way of detecting fringe jumps which can potentially recover a significant fraction of the data lost to them.
Most current high contrast imaging point spread function (PSF) subtraction algorithms use some form of a least-squares noise minimization to find exoplanets that are, before post-processing, often hidden below the instrumental speckle noise. In the c
urrent standard PSF subtraction algorithms, a set of reference images is derived from the target image sequence to subtract each target image, using Angular and/or Simultaneous Spectral Differential Imaging (ADI, SSDI, respectively). However, to avoid excessive exoplanet self-subtraction, ADI and SSDI (in the absence of a strong spectral feature) severely limit the available number of reference images at small separations. This limits the performance of the least-squares algorithm, resulting in lower sensitivity to exoplanets at small angular separations. Possible solutions are to use additional reference images by acquiring longer sequences, use SSDI if the exoplanet is expected to show strong spectral features, or use images acquired on other targets. The latter option, known as Reference Star Differential Imaging (RSDI), which relies on the use of reference images that are highly correlated to the target image, has been ineffective in previous ground-based high contrast imaging surveys. We present the results of work to optimize PSF subtraction with the GPIES reference library using a least-squares algorithm designed to minimize speckle noise and maximize planet throughput, thus maximizing the planet signal to noise ratio (SNR). Using December 2014 51 Eri GPI data in the inner 100 mas to 300 mas annulus, we find no apparent improvement in SNR when using RSDI and/or our optimization scheme. This result, while still being investigated, seems to show that current algorithms on ADI+SSDI data sets are optimized, and that limited gains can be achieved by using a PSF archive.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
