اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCIAO: Cache Interference-Aware Throughput-Oriented Architecture and Scheduling for GPUs
95
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A modern GPU aims to simultaneously execute more warps for higher Thread-Level Parallelism (TLP) and performance. When generating many memory requests, however, warps contend for limited cache space and thrash cache, which in turn severely degrades performance. To reduce such cache thrashing, we may adopt cache locality-aware warp scheduling which gives higher execution priority to warps with higher potential of data locality. However, we observe that warps with high potential of data locality often incurs far more cache thrashing or interference than warps with low potential of data locality. Consequently, cache locality-aware warp scheduling may undesirably increase cache interference and/or unnecessarily decrease TLP. In this paper, we propose Cache Interference-Aware throughput-Oriented (CIAO) on-chip memory architecture and warp scheduling which exploit unused shared memory space and take insight opposite to cache locality-aware warp scheduling. Specifically, CIAO on-chip memory architecture can adaptively redirect memory requests of severely interfering warps to unused shared memory space to isolate memory requests of these interfering warps from those of interfered warps. If these interfering warps still incur severe cache interference, CIAO warp scheduling then begins to selectively throttle execution of these interfering warps. Our experiment shows that CIAO can offer 54% higher performance than prior cache locality-aware scheduling at a small chip cost.
قيم البحث
اقرأ أيضاً
Reliability is a fundamental requirement in any microprocessor to guarantee correct execution over its lifetime. The design rules related to reliability depend on the process technology being used and the expected operating conditions of the device.
To meet reliability requirements, advanced process technologies (28 nm and below) impose highly challenging design rules. Such design-for-reliability rules have become a major burden on the flow of VLSI implementation because of the severe physical constraints they impose. This paper focuses on electromigration (EM), which is one of the major critical factors affecting semiconductor reliability. EM is the aging process of on-die wires and vias and is induced by excessive current flow that can damage wires and may also significantly impact the integrated-circuit clock frequency. EM exerts a comprehensive global effect on devices because it impacts wires that may reside inside the standard or custom logical cells, between logical cells, inside memory elements, and within wires that interconnect functional blocks. The design-implementation flow (synthesis and place-and-route) currently detects violations of EM-reliability rules and attempts to solve them. In contrast, this paper proposes a new approach to enhance these flows by using EM-aware architecture. Our results show that the proposed solution can relax EM design efforts in microprocessors and more than double microprocessor lifetime. This work demonstrates this proposed approach for modern microprocessors, although the principals and ideas can be adapted to other cases as well.
We propose without loss of generality strategies to achieve a high-throughput FPGA-based architecture for a QC-LDPC code based on a circulant-1 identity matrix construction. We present a novel representation of the parity-check matrix (PCM) providing
a multi-fold throughput gain. Splitting of the node processing algorithm enables us to achieve pipelining of blocks and hence layers. By partitioning the PCM into not only layers but superlayers we derive an upper bound on the pipelining depth for the compact representation. To validate the architecture, a decoder for the IEEE 802.11n (2012) QC-LDPC is implemented on the Xilinx Kintex-7 FPGA with the help of the FPGA IP compiler [2] available in the NI LabVIEW Communication System Design Suite (CSDS) which offers an automated and systematic compilation flow where an optimized hardware implementation from the LDPC algorithm was generated in approximately 3 minutes, achieving an overall throughput of 608Mb/s (at 260MHz). As per our knowledge this is the fastest implementation of the IEEE 802.11n QC-LDPC decoder using an algorithmic compiler.
Modern computing systems are embracing non-volatile memory (NVM) to implement high-capacity and low-cost main memory. Elevated operating voltages of NVM accelerate the aging of CMOS transistors in the peripheral circuitry of each memory bank. Aggress
ive device scaling increases power density and temperature, which further accelerates aging, challenging the reliable operation of NVM-based main memory. We propose HEBE, an architectural technique to mitigate the circuit aging-related problems of NVM-based main memory. HEBE is built on three contributions. First, we propose a new analytical model that can dynamically track the aging in the peripheral circuitry of each memory bank based on the banks utilization. Second, we develop an intelligent memory request scheduler that exploits this aging model at run time to de-stress the peripheral circuitry of a memory bank only when its aging exceeds a critical threshold. Third, we introduce an isolation transistor to decouple parts of a peripheral circuit operating at different voltages, allowing the decoupled logic blocks to undergo long-latency de-stress operations independently and off the critical path of memory read and write accesses, improving performance. We evaluate HEBE with workloads from the SPEC CPU2017 Benchmark suite. Our results show that HEBE significantly improves both performance and lifetime of NVM-based main memory.
Advanced Driver Assistance Systems (ADAS) and Autonomous Driving (AD) bring unprecedented performance requirements for automotive systems. Graphic Processing Unit (GPU) based platforms have been deployed with the aim of meeting these requirements, be
ing NVIDIA Jetson TX2 and its high-performance successor, NVIDIA AGX Xavier, relevant representatives. However, to what extent high-performance GPU configurations are appropriate for ADAS and AD workloads remains as an open question. This paper analyzes this concern and provides valuable insights on this question by modeling two recent automotive NVIDIA GPU-based platforms, namely TX2 and AGX Xavier. In particular, our work assesses their microarchitectural parameters against relevant benchmarks, identifying GPU setups delivering increased performance within a similar cost envelope, or decreasing hardware costs while preserving original performance levels. Overall, our analysis identifies opportunities for the optimization of automotive GPUs to further increase system efficiency.
In recent years, machine intelligence (MI) applications have emerged as a major driver for the computing industry. Optimizing these workloads is important but complicated. As memory demands grow and data movement overheads increasingly limit performa
nce, determining the best GPU caching policy to use for a diverse range of MI workloads represents one important challenge. To study this, we evaluate 17 MI applications and characterize their behaviors using a range of GPU caching strategies. In our evaluations, we find that the choice of caching policy in GPU caches involves multiple performance trade-offs and interactions, and there is no one-size-fits-all GPU caching policy for MI workloads. Based on detailed simulation results, we motivate and evaluate a set of cache optimizations that consistently match the performance of the best static GPU caching policies.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
