اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh $n$-type thermoelectric power factor and efficiency in Ba$_{2}$BiAu from a highly dispersive band
53
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Using first-principles density-functional theory calculations, we predict the potential for unprecedented thermoelectric efficiency $zT=5$ at 800 K in $n$-type Ba$_{2}$BiAu full-Heusler compound. Such a high efficiency arises from an intrinsically ultralow lattice thermal conductivity coupled with a very high power factor reaching 7 mW m$^{-1}$ K$^{-2}$ at 500 K. The high power factor originates from a light, sixfold degenerate conduction band pocket along the $Gamma$-X direction. Weak acoustic phonon scattering and sixfold multiplicity combine to yield high mobility and high Seebeck coefficient. In contrast, the flat-and-dispersive (a.k.a. low-dimensional) valence band of Ba$_{2}$BiAu fail to generate a high power factor due to strong acoustic phonon scattering. The Lorenz numbers at optimal doping are smaller than the Wiedemann-Franz value, an integral feature for $zT$ enhancement as electrons are the majority heat carriers.
قيم البحث
اقرأ أيضاً
The thermoelectric and transport properties of a Fe3O4/SiO2/p-Si(100) heterostructure have been investigated between 100 and 300 K. Both Hall and Seebeck coefficients change sign from negative to positive with increasing temperature while the resisti
vity drops sharply due to tunneling of carriers into the p-Si(100). The low resistivity and large Seebeck coefficient of Si give a very high thermoelectric power factor of 25.5mW/K2m at 260K which is an underestimated, lower limit value and is related to the density of states and difference in the work functions of Fe3O4 and Si(100) that create an accumulation of majority holes at the p-Si/SiO2 interface
The current transport and thermoelectric properties of Fe3O4 / SiO2 / p-type Si(001) heterostructures with Fe3O4 thicknesses of 150, 200, and 350 nm have been investigated between 100 and 300 K. We observe a sharp drop of the in-plane resistivity at
200K due to the onset of conduction along the Si / SiO2 interface related to tunneling of electrons from the Fe3O4 into the accumulation layer of holes at the Si / SiO2 interface, whose existence was confirmed by capacitance-voltage measurements and a two band analysis of the Hall effect. This is accompanied by a large increase of the Seebeck coefficient reaching +1000 {mu}V/K at 300K that is related to holes in the p-type Si(001) and gives a power factor of 70 mW/K2m when the Fe3O4 layer thickness is reduced down to 150 nm. We show that most of the current flows in the Fe3O4 layer at 300 K, while the Fe3O4 / SiO2 / p-type Si(001) heterostructures behave like tunneling p-n junctions in the transverse direction.
We present an investigation of the thermoelectric properties of cubic perovskite SrTiO3. The results are derived from a combination of calculated transport functions obtained from Boltzmann transport theory in the constant scattering time approximati
on based on the electronic structure and existing experimental data for La-doped SrTiO3. The figure of merit ZT is modeled with respect to carrier concentration and temperature. The model predicts a relatively high $ZT$ at optimized doping, and suggests that the $ZT$ value can reach 0.7 at T = 1400 K. Thus $ZT$ can be improved from the current experimental values by carrier concentration optimization.
Modulation of the grain boundary properties in thermoelectric materials that have thermally activated electrical conductivity is crucial in order to achieve high performance at low temperatures. In this work, we show directly that the modulation of t
he potential barrier at the grain boundaries in perovskite SrTiO3 changes the low-temperature dependency of the bulk materials electrical conductivity. By sintering samples in a reducing environment of increasing strength, we produced La0.08Sr0.9TiO3 (LSTO) ceramics that gradually change their electrical conductivity behavior from thermally activated to single-crystal-like, with only minor variations in the Seebeck coefficient. Imaging of the surface potential by Kelvin probe force microscopy found lower potential barriers at the grain boundaries in the LSTO samples that had been processed in the more reducing environments. A theoretical model using the band offset at the grain boundary to represent the potential barrier agreed well with the measured grain boundary potential dependency of conductivity. The present work showed an order of magnitude enhancement in electrical conductivity (from 85 to 1287 S cm-1) and power factor (from 143 to 1745 {mu}W m-1 K-2) at 330 K by this modulation of charge transport at grain boundaries. This significant reduction in the impact of grain boundaries on charge transport in SrTiO3 provides an opportunity to achieve the ultimate phonon glass electron crystal by appropriate experimental design and processing.
We examined the electrical transport properties of densified LaOBiS2-xSex, which constitutes a new family of thermoelectric materials. The power factor increased with increasing concentration of Se, i.e., Se substitution led to an enhanced electrical
conductivity, without suppression of the Seebeck coefficient. Hall measurements indicated that the low electrical resistivity resulted from increases in the carrier mobility, and the decrease in carrier concentration led to large absolute values of the Seebeck coefficient of the system.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
