اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEigendecomposition-Based Partial FFT Demodulation for Differential OFDM in Underwater Acoustic Communications
165
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Differential orthogonal frequency division multiplexing (OFDM) is practically attractive for underwater acoustic communications since it has the potential to obviate channel estimation. However, similar to coherent OFDM, it may suffer from severe inter-carrier interference over time-varying channels. To alleviate the induced performance degradation, we adopt the newly-emerging partial FFT demodulation technique in this paper and propose an eigendecomposition-based algorithm to compute the combining weights. Compared to existing adaptive methods, the new algorithm can avoid error propagation and eliminate the need for parameter tuning. Moreover, it guarantees global optimality under the narrowband Doppler assumption, with the optimal weight vector of partial FFT demodulation achieved by the eigenvector associated with the smallest eigenvalue of the pilot detection error matrix. Finally, the algorithm can also be extended straightforwardly to perform subband-wise computation to counteract wideband Doppler effects.
قيم البحث
اقرأ أيضاً
The extremely long underwater channel delay spread causes severe inter-symbol interference (ISI) for underwater acoustic communications. Passive time reversal processing (PTRP) can effectively reduce the channel time dispersion in a simple way via co
nvolving the received packet with a time reversed probe signal. However the probe signal itself may introduce extra noise and interference (self-correlation of the probe signal). In this paper, we propose a virtual time reversal processing (VTRP) for single input single output (SISO) Orthogonal Frequency Division Multiplexing (OFDM) systems. It convolves the received packet with the reversed estimated channel, instead of the probe signal to reduce the interference. Two sparse channel estimation methods, matching pursuit (MP), and basis pursuit de-noising (BPDN), are adopted to estimate the channel impulse response (CIR). We compare the performance of VTRP with the PTRP and without any time reversal processing through MATLAB simulations and the pool experiments. The results reveal that VTRP has outstanding performance over time-invariant channels.
In this paper, we consider an eavesdropping attack on a multi-hop, UnderWater Acoustic Sensor Network (UWASN) that consists of $M+1$ underwater sensors which report their sensed data via Orthogonal Frequency Division Multiplexing (OFDM) scheme to a s
ink node on the water surface. Furthermore, due to the presence of a passive malicious node in nearby vicinity, the multi-hop UnderWater Acoustic (UWA) channel between a sensor node and the sink node is prone to eavesdropping attack on each hop. Therefore, the problem at hand is to do (helper/relay) node selection (for data forwarding onto the next hop) as well as power allocation (across the OFDM sub-carriers) in a way that the secrecy rate is maximized at each hop. To this end, this problem of Node Selection and Power Allocation (NSPA) is formulated as a mixed binary-integer optimization program, which is then optimally solved via decomposition approach, and by exploiting duality theory along with the Karush-Kuhn-Tucker conditions. We also provide a computationally-efficient, sub-optimal solution to the NSPA problem, where we reformulate it as a mixed-integer linear program and solve it via decomposition and geometric approach. Moreover, when the UWA channel is multipath (and not just line-of-sight), we investigate an additional, machine learning-based approach to solve the NSPA problem. Finally, we compute the computational complexity of all the three proposed schemes (optimal, sub-optimal, and learning-based), and do extensive simulations to compare their performance against each other and against the baseline schemes (which allocate equal power to all the sub-carriers and do depth-based node selection). In a nutshell, this work proposes various (optimal and sub-optimal) methods for providing information-theoretic security at the physical layer of the protocol stack through resource allocation.
We present a comparative study of the influence of dispersion induced phase noise for CO-OFDM systems using Tx channel multiplexing and Rx matched filter (analogue hardware based); and FFT multiplexing/IFFT demultiplexing techniques (software based).
An RF carrier pilot tone is used to mitigate the phase noise influence. From the analysis, it appears that the phase noise influence for the two OFDM implementations is very similar. The software based system provides a method for a rigorous evaluation of the phase noise variance caused by Common Phase Error (CPE) and Inter-Carrier Interference (ICI) and this, in turns, leads to a BER specification. Numerical results focus on a CO-OFDM system with 1GS/s QPSK channel modulation. Worst case BER results are evaluated and compared to the BER of a QPSK system with the same capacity as the OFDM implementation. Results are evaluated as a function of transmission distance, and for the QPSK system the influence of equalization enhanced phase noise (EEPN) is included. For both types of systems, the phase noise variance increases significantly with increasing transmission distance. An important and novel observation is that the two types of systems have very closely the same BER as a function of transmission distance for the same capacity. For the high capacity QPSK implementation, the increase in BER is due to EEPN, whereas for the OFDM approach it is due to the dispersion caused walk-off of the RF pilot tone relative to the OFDM signal channels. For a total capacity of 400 Gb/s, the transmission distance to have the BER < 10-4 is less than 277 km.
We present a study of the influence of dispersion induced phase noise for CO-OFDM systems using FFT multiplexing/IFFT demultiplexing techniques (software based). The software based system provides a method for a rigorous evaluation of the phase noise
variance caused by Common Phase Error (CPE) and Inter-Carrier Interference (ICI) including - for the first time to our knowledge - in explicit form the effect of equalization enhanced phase noise (EEPN). This, in turns, leads to an analytic BER specification. Numerical results focus on a CO-OFDM system with 10-25 GS/s QPSK channel modulation. A worst case constellation configuration is identified for the phase noise influence and the resulting BER is compared to the BER of a conventional single channel QPSK system with the same capacity as the CO-OFDM implementation. Results are evaluated as a function of transmission distance. For both types of systems, the phase noise variance increases significantly with increasing transmission distance. For a total capacity of 400 (1000) Gbit/s, the transmission distance to have the BER < 10^-2 for the worst case CO-OFDM design is less than 800 and 460 km, respectively, whereas for a single channel QPSK system it is less than 1400 and 560 km.
Visible light communications (VLC) have recently attracted a growing interest and can be a potential solution to realize indoor wireless communication with high bandwidth capacity for RF-restricted environments such as airplanes and hospitals. Optica
l based orthogonal frequency division multiplexing (OFDM) systems have been proposed in the literature to combat multipath distortion and intersymbol interference (ISI) caused by multipath signal propagation. In this paper, we present a robust timing synchronization scheme suitable for asymmetrically clipped (AC) OFDM based optical intensity modulated direct detection (IM/DD) wireless systems. Our proposed method works perfectly for ACO-OFDM, Pulse amplitude modulated discrete multitone (PAM-DMT) and discrete Hartley transform (DHT) based optical OFDM systems. In contrast to existing OFDM timing synchronization methods which are either not suitable for AC OFDM techniques due to unipolar nature of output signal or perform poorly, our proposed method is suitable for AC OFDM schemes and outperforms all other available techniques. Both numerical and experimental results confirm the accuracy of the proposed method. Our technique is also computationally efficient as it requires very few computations as compared to conventional methods in order to achieve good accuracy.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
