ترغب بنشر مسار تعليمي؟ اضغط هنا

Ultra-broadband photodetectors based on epitaxial graphene quantum dots

89   0   0.0 ( 0 )
 نشر من قبل Paola Barbara
 تاريخ النشر 2017
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Graphene is an ideal material for hot-electron bolometers, due to its low heat capacity and weak electron-phonon coupling. Nanostructuring graphene with quantum dot constrictions yields detectors with extraordinarily high intrinsic responsivity, higher than 1x10^9 V/W at 3K. The sensing mechanism is bolometric in nature: the quantum confinement gap causes a strong dependence of the electrical resistance on the electron temperature. Here we show that this quantum confinement gap does not impose a limitation on the photon energy for light detection and these quantum dot bolometers work in a very broad spectral range, from terahertz, through telecom to ultraviolet radiation, with responsivity independent of wavelength. We also measure the power dependence of the response. Although the responsivity decreases with increasing power, it stays higher than 1x10^8 V/W in a wide range of absorbed power, from 1 pW to 0.4 nW.



قيم البحث

اقرأ أيضاً

Series connection of four quantum Hall effect (QHE) devices based on epitaxial graphene films was studied for realization of a quantum resistance standard with an up-scaled value. The tested devices showed quantum Hall plateaux RH,2 at filling factor i = 2 starting from relatively low magnetic field (between 4 T and 5 T) when temperature was 1.5 K. Precision measurements of quantized Hall resistance of four QHE devices connected by triple series connections and external bonding wires were done at B = 7 T and T = 1.5 K using a commercial precision resistance bridge with 50 microA current through the QHE device. The results showed that the deviation of the quantized Hall resistance of the series connection of four graphene-based QHE devices from the expected value of 4*RH,2 = 2h/e^2 was smaller than the relative standard uncertainty of the measurement (< 1*10^-7) limited by the used resistance bridge.
244 - H. G. Zhang , H. Hu , Y. Pan 2009
Laterally localized electronic states are identified on a single layer of graphene on ruthenium. The individual states are separated by 3 nm and comprise regions of about 90 carbon atoms. This constitutes a quantum dot array, evidenced by quantum wel l resonances that are modulated by the corrugation of the graphene layer. The quantum well resonances are strongest on the isolated hill regions where the graphene is decoupled from the surface. This peculiar nanostructure is expected to become important for single electron physics where it bridges zero-dimensional molecule-like and two-dimensional graphene on a highly regular lattice.
325 - S. Engels , A. Epping , C. Volk 2013
We report on the fabrication and characterization of etched graphene quantum dots (QDs) on hexagonal boron nitride (hBN) and SiO2 with different island diameters. We perform a statistical analysis of Coulomb peak spacings over a wide energy range. Fo r graphene QDs on hBN, the standard deviation of the normalized peak spacing distribution decreases with increasing QD diameter, whereas for QDs on SiO2 no diameter dependency is observed. In addition, QDs on hBN are more stable under the influence of perpendicular magnetic fields up to 9T. Both results indicate a substantially reduced substrate induced disorder potential in graphene QDs on hBN.
Metamaterials have recently established a new paradigm for enhanced light absorption in state-of-the-art photodetectors. Here, we demonstrate broadband, highly efficient, polarization-insensitive, and gate-tunable photodetection at room temperature i n a novel metadevice based on gold/graphene Sierpinski carpet plasmonic fractals. We observed an unprecedented internal quantum efficiency up to 100% from the near-infrared to the visible range with an upper bound of optical detectivity of $10^{11}$ Jones and a gain up to $10^{6}$, which is a fingerprint of multiple hot carriers photogenerated in graphene. Also, we show a 100-fold enhanced photodetection due to highly focused (up to a record factor of $|E/E_{0}|approx20$ for graphene) electromagnetic fields induced by electrically tunable multimodal plasmons, spatially localized in self-similar fashion on the metasurface. Our findings give direct insight into the physical processes governing graphene plasmonic fractal metamaterials. The proposed structure represents a promising route for the realization of a broadband, compact, and active platform for future optoelectronic devices including multiband bio/chemical and light sensors.
103 - D. De Fazio , B. Uzlu , I. Torre 2020
Graphene-based photodetectors have shown responsivities up to 10$^8$A/W and photoconductive gains up to 10$^{8}$ electrons per photon. These photodetectors rely on a highly absorbing layer in close proximity of graphene, which induces a shift of the graphene chemical potential upon absorption, hence modifying its channel resistance. However, due to the semi-metallic nature of graphene, the readout requires dark currents of hundreds of $mu$A up to mA, leading to high power consumption needed for the device operation. Here we propose a novel approach for highly responsive graphene-based photodetectors with orders of magnitude lower dark current levels. A shift of the graphene chemical potential caused by light absorption in a layer of colloidal quantum dots, induces a variation of the current flowing across a metal-insulator-graphene diode structure. Owing to the low density of states of graphene near the neutrality point, the light-induced shift in chemical potential can be relatively large, dramatically changing the amount of current flowing across the insulating barrier, and giving rise to a novel type of gain mechanism. This readout requires dark currents of hundreds of nA up to few $mu$A, orders of magnitude lower than other graphene-based photodetectors, while keeping responsivities of $sim$70A/W in the infrared, almost two orders of magnitude higher compared to established germanium on silicon and indium gallium arsenide infrared photodetectors. This makes the device appealing for applications where high responsivity and low power consumption are required.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا