اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLow Complexity Receiver for Uplink SCMA System via Expectation Propagation
52
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Sparse code multiple access (SCMA) scheme is considered to be one promising non-orthogonal multiple access technology for the future fifth generation (5G) communications. Due to the sparse nature, message passing algorithm (MPA) has been used as the receiver to achieve close to maximum likelihood (ML) detection performance with much lower complexity. However, the complexity order of MPA is still exponential with the size of codebook and the degree of signal superposition on a given resource element. In this paper, we propose a novel low complexity iterative receiver based on expectation propagation algorithm (EPA), which reduces the complexity order from exponential to linear. Simulation results demonstrate that the proposed EPA receiver achieves nearly the same block error rate (BLER) performance as the conventional message passing algorithm (MPA) receiver with orders less complexity.
قيم البحث
اقرأ أيضاً
Large-scale antenna (LSA) has gained a lot of attention recently since it can significantly improve the performance of wireless systems. Similar to multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) or MIMO-OFDM,
LSA can be also combined with OFDM to deal with frequency selectivity in wireless channels. However, such combination suffers from substantially increased complexity proportional to the number of antennas in LSA systems. For the conventional implementation of LSA-OFDM, the number of inverse fast Fourier transforms (IFFTs) increases with the antenna number since each antenna requires an IFFT for OFDM modulation. Furthermore, zero-forcing (ZF) precoding is required in LSA systems to support more users, and the required matrix inversion leads to a huge computational burden. In this paper, we propose a low-complexity recursive convolutional precoding to address the issues above. The traditional ZF precoding can be implemented through the recursive convolutional precoding in the time domain so that only one IFFT is required for each user and the matrix inversion can be also avoided. Simulation results show that the proposed approach can achieve the same performance as that of ZF but with much lower complexity.
Sparse code multiple access (SCMA) is a promising multiuser communication technique for the enabling of future massive machine-type networks. Unlike existing codebook design schemes assuming uniform power allocation, we present a novel class of SCMA
codebooks which display power imbalance among different users for downlink transmission. Based on the Star-QAM mother constellation structure and with the aid of genetic algorithm, we optimize the minimum Euclidean distance (MED) and the minimum product distance (MPD) of the proposed codebooks. Numerical simulation results show that our proposed codebooks lead to significantly improved error rate performances over Gaussian channels and Rayleigh fading channels.
This paper proposes a joint transmitter-receiver design to minimize the weighted sum power under the post-processing signal-to-interference-and-noise ratio (post-SINR) constraints for all subchannels. Simulation results demonstrate that the algorithm
can not only satisfy the post-SINR constraints but also easily adjust the power distribution among the users by changing the weights accordingly. Hence the algorithm can be used to alleviates the adjacent cell interference by reducing the transmitting power to the edge users without performance penalty.
The performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems is limited by the sparse nature of propagation channels and the restricted number of radio frequency (RF) chains at transceivers. The introduction of reconfigur
able antennas offers an additional degree of freedom on designing mmWave MIMO systems. This paper provides a theoretical framework for studying the mmWave MIMO with reconfigurable antennas. Based on the virtual channel model, we present an architecture of reconfigurable mmWave MIMO with beamspace hybrid analog-digital beamformers and reconfigurable antennas at both the transmitter and the receiver. We show that employing reconfigurable antennas can provide throughput gain for the mmWave MIMO. We derive the expression for the average throughput gain of using reconfigurable antennas in the system, and further derive the expression for the outage throughput gain for the scenarios where the channels are (quasi) static. Moreover, we propose a low-complexity algorithm for reconfiguration state selection and beam selection. Our numerical results verify the derived expressions for the throughput gains and demonstrate the near-optimal throughput performance of the proposed low-complexity algorithm.
Despite of the known gap from the Shannons capacity, several standards are still employing QAM or star shape constellations, mainly due to the existing low complexity detectors. In this paper, we investigate the low complexity detection for a family
of QAM isomorphic constellations. These constellations are known to perform very close to the peak-power limited capacity, outperforming the DVB-S2X standard constellations. The proposed strategy is to first remap the received signals to the QAM constellation using the existing isomorphism and then break the log likelihood ratio computations to two one dimensional PAM constellations. Gains larger than 0.6 dB with respect to QAM can be obtained over the peak power limited channels without any increase in detection complexity. Our scheme also provides a systematic way to design constellations with low complexity one dimensional detectors. Several open problems are discussed at the end of the paper.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
