اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOrigin of the low critical observing temperature of the quantum anomalous Hall effect in V-doped (Bi, Sb)2Te3 film
63
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The experimental realization of the quantum anomalous Hall (QAH) effect in magnetically-doped (Bi, Sb)2Te3 films stands out as a landmark of modern condensed matter physics. However, ultra-low temperatures down to few tens of mK are needed to reach the quantization of Hall resistance, which is two orders of magnitude lower than the ferromagnetic phase transition temperature of the films. Here, we systematically study the band structure of V-doped (Bi, Sb)2Te3 thin films by angle-resolved photoemission spectroscopy (ARPES) and show unambiguously that the bulk valence band (BVB) maximum lies higher in energy than the surface state Dirac point. Our results demonstrate clear evidence that localization of BVB carriers plays an active role and can account for the temperature discrepancy.
قيم البحث
اقرأ أيضاً
To realize the quantum anomalous Hall effect (QAHE) at elevated temperatures, we adopted the approach of magnetic proximity effect (MPE) to break time reversal symmetry in topological insulator (Bi,Sb)2Te3 (BST) based heterostructure with a ferromagn
etic insulator like europium iron garnet (EuIG) of perpendicular magnetic anisotropy. Here we demonstrated phenomenally large anomalous Hall resistance (RAHE) as high as 8 {Omega} at 300 K, and sustained to 400 K in 35 BST/EuIG samples, surpassing the past record (0.28 {Omega}) by nearly thirty times. These striking results are attributed to an atomically abrupt interface between BST and EuIG being Fe rich. Importantly, the gate dependence of AHE loop showed no sign change with varying chemical potential, thus the MPE induced AHE is less likely originated from the extrinsic effect. For gate-biased 4 nm BST on EuIG, pronounced topological Hall effect coexisting with AHE were observed at the negative top gate voltage up to 15 K.
The influence of Sb content, substrate type and cap layers on the quantum anomalous Hall effect observed in V-doped (Bi,Sb)$_2$Te$_3$ magnetic topological insulators is investigated. Thin layers showing excellent quantization are reproducibly deposit
ed by molecular beam epitaxy at growth conditions effecting a compromise between controlled layer properties and high crystalline quality. The Sb content can be reliably determined from the in-plane lattice constant measured by X-ray diffraction, even in thin layers. This is the main layer parameter to be optimized in order to approach charge neutrality. Within a narrow range at about 80% Sb content, the Hall resistivity shows a maximum of about 10 k$Omega$ at 4 K and quantizes at mK temperatures. Under these conditions, thin layers grown on Si(111) or InP(111) and with or without a Te cap exhibit quantization. The quantization persists independently of the interfaces between cap, layer and substrate, the limited crystalline quality, and the degradation of the layer proving the robustness of the quantum anomalous Hall effect.
The quantum anomalous Hall effect has recently been observed experimentally in thin films of Cr doped (Bi,Sb)$_2$Te$_3$ at a low temperature ($sim$ 30mK). In this work, we propose realizing the quantum anomalous Hall effect in more conventional dilut
ed magnetic semiconductors with doped InAs/GaSb type II quantum wells. Based on a four band model, we find an enhancement of the Curie temperature of ferromagnetism due to band edge singularities in the inverted regime of InAs/GaSb quantum wells. Below the Curie temperature, the quantum anomalous Hall effect is confirmed by the direct calculation of Hall conductance. The parameter regime for the quantum anomalous Hall phase is identified based on the eight-band Kane model. The high sample quality and strong exchange coupling make magnetically doped InAs/GaSb quantum wells good candidates for realizing the quantum anomalous Hall insulator at a high temperature.
The quantum anomalous Hall effect (QAHE) realizes dissipationless longitudinal resistivity and quantized Hall resistance without the need of an external magnetic field. However, when reducing the device dimensions or increasing the current density, a
n abrupt breakdown of the dissipationless state occurs with a relatively small critical current, limiting the applications of the QAHE. We investigate the mechanism of this breakdown by studying multi-terminal devices and identified that the electric field created between opposing chiral edge states lies at the origin. We propose that electric-field-driven percolation of two-dimensional charge puddles in the gapped surface states of compensated topological-insulator films is the most likely cause of the breakdown.
We have studied the charge to spin conversion in Bi$_{1-x}$Sb$_x$/CoFeB heterostructures. The spin Hall conductivity (SHC) of the sputter deposited heterostructures exhibits a high plateau at Bi-rich compositions, corresponding to the topological ins
ulator phase, followed by a decrease of SHC for Sb-richer alloys, in agreement with the calculated intrinsic spin Hall effect of Bi$_{1-x}$Sb$_x$ alloy. The SHC increases with increasing thickness of the Bi$_{1-x}$Sb$_x$ alloy before it saturates, indicating that it is the bulk of the alloy that predominantly contributes to the generation of spin current; the topological surface states, if present in the films, play little role. Surprisingly, the SHC is found to increase with increasing temperature, following the trend of carrier density. These results suggest that the large SHC at room temperature, with a spin Hall efficiency exceeding 1 and an extremely large spin current mobility, is due to increased number of Dirac-like, thermally-excited electrons in the $L$ valley of the narrow gap Bi$_{1-x}$Sb$_x$ alloy.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
