ترغب بنشر مسار تعليمي؟ اضغط هنا

On the validity of tidal turbine array configurations obtained from steady-state adjoint optimisation

69   0   0.0 ( 0 )
 نشر من قبل Christian Jacobs
 تاريخ النشر 2016
والبحث باللغة English




اسأل ChatGPT حول البحث

Extracting the optimal amount of power from an array of tidal turbines requires an intricate understanding of tidal dynamics and the effects of turbine placement on the local and regional scale flow. Numerical models have contributed significantly towards this understanding, and more recently, adjoint-based modelling has been employed to optimise the positioning of the turbines in an array in an automated way and improve on simple, regular man-made configurations. Adjoint-based optimisation of high-resolution and ideally 3D transient models is generally a very computationally expensive problem. As a result, existing work on the adjoint optimisation of tidal turbine placement has been mostly limited to steady-state simulations in which very high, non-physical values of the background viscosity are required to ensure that a steady-state solution exists. However, such compromises may affect the reliability of the modelled turbines, their wakes and interactions, and thus bring into question the validity of the computed optimal turbine positions. This work considers a suite of idealised simulations of flow past tidal turbine arrays in a 2D channel. It compares four regular array configurations, detailed by Divett et al. (2013), with the configuration found through adjoint optimisation in a steady-state, high-viscosity setup. The optimised configuration produces considerably more power. The same configurations are then used to produce a suite of transient simulations that do not use constant high-viscosity, and instead use large eddy simulation (LES) to parameterise the resulting turbulent structures. It is shown that the LES simulations produce less power than that predicted by the constant high-viscosity runs. Nevertheless, they still follow the same trends in the power curve throughout time, with optimised layouts continuing to perform significantly better than simplified configurations.



قيم البحث

اقرأ أيضاً

159 - Aliza Abraham , Teja Dasari , 2019
Super-large-scale particle image velocimetry (SLPIV) using natural snowfall is used to investigate the influence of nacelle and tower generated flow structures on the near-wake of a 2.5 MW wind turbine at the EOLOS field station. The analysis is base d on the data collected in a field campaign on March 12th, 2017, with a sample area of 125 m (vertical) x 70 m (streamwise) centred on the plane behind the turbine support tower. The SLPIV measurement provides the velocity field over the entire rotor span, revealing a region of accelerated flow around the hub caused by the reduction in axial induction at the blade roots. The in-plane turbulent kinetic energy field shows an increase in turbulence in the regions of large shear behind the blade tips and the hub, and a reduction in turbulence behind the tower where the large-scale turbulent structures in the boundary layer are broken up. Snow voids reveal coherent structures shed from the blades, nacelle, and tower. The hub wake meandering frequency is quantified and found to correspond to the vortex shedding frequency of an Ahmed body (St=0.06). Persistent hub wake deflection is observed and shown to be connected with the turbine yaw error. In the region below the hub, strong interaction between the tower- and blade-generated structures is observed. The temporal characteristics of this interaction are quantified by the co-presence of two dominant frequencies, one corresponding to the blade vortex shedding at the blade pass frequency and the other corresponding to tower vortex shedding at St=0.2. This study highlights the influence of the tower and nacelle on the behaviour of the near-wake, informing model development and elucidating the mechanisms that influence wake evolution.
In the past few years, the interest towards the implementation of design-for-demise measures has increased steadily. Most mid-sized satellites currently launched and already in orbit fail to comply with the casualty risk threshold of 0.0001. Therefor e, satellites manufacturers and mission operators need to perform a disposal through a controlled re-entry, which has a higher cost and increased complexity. Through the design-for-demise paradigm, this additional cost and complexity can be removed as the spacecraft is directly compliant with the casualty risk regulations. However, building a spacecraft such that most of its parts will demise may lead to designs that are more vulnerable to space debris impacts, thus compromising the reliability of the mission. In fact, the requirements connected to the demisability and the survivability are in general competing. Given this competing nature, trade-off solutions can be found, which favour the implementation of design-for-demise measures while still maintaining the spacecraft resilient to space debris impacts. A multi-objective optimisation framework has been developed by the authors in previous works. The frameworks objective is to find preliminary design solutions considering the competing nature of the demisability and the survivability of a spacecraft since the early stages of the mission design. In this way, a more integrated design can be achieved. The present work focuses on the improvement of the multi-objective optimisation framework by including constraints. The paper shows the application of the constrained optimisation to two relevant examples: the optimisation of a tank assembly and the optimisation of a typical satellite configuration.
The present investigation provides the first field characterization of the influence of turbulent inflow on the blade structural response of a utility-scale wind turbine (2.5MW), using the unique facility available at the Eolos Wind Energy Research S tation of the University of Minnesota. A representative one-hour dataset under a stable atmosphere is selected for the characterization, including the inflow turbulent data measured from the meteorological tower, high-resolution blade strain measurement at different circumferential and radiation positions along the blade, and the wind turbine operational conditions. The results indicate that the turbulent inflow modulates the turbine blade structural response in three representative frequency ranges: a lower frequency range (corresponding to modulations due to large eddies in the atmosphere), a higher frequency range (corresponding to flow structures in scales smaller than the rotor diameter), and an intermediate-range in between. The blade structure responds strongly to the turbulent inflow in the lower and intermediate ranges, while it is primarily dominated by the rotation effect and other high-frequency characteristics of wind turbines in the higher frequency range. Moreover, the blade structural behaviors at different azimuth angles, circumferential and radial locations along the blade are also compared, suggesting the comparatively high possibility of structural failure at certain positions. Further, the present study also uncovers the linkage between the turbulent inflow and blade structural response using temporal correlation. The derived findings provide insights into the development of advanced control strategies or blade design to mitigate the structural impact and increase blade longevity for the safer and more efficient operation of large-scale wind turbines.
This paper provides a review of the general experimental methodology of snow-powered flow visualization and super-large-scale particle imaging velocimetry (SLPIV), the corresponding field deployments and major scientific findings from our work on a 2 .5 MW utility-scale wind turbine at the Eolos field station. The field measurements were conducted to investigate the incoming flow in the induction zone and the near-wake flows from different perspectives. It has been shown that these snow-powered measurements can provide sufficient spatiotemporal resolution and fields of view to characterize both qualitatively and quantitatively the incoming flow, all the major coherent structures generated by the turbine (e.g., blade, nacelle and tower vortices, etc.) as well as the development and interaction of these structures in the near wake. Our work has further revealed several interesting behaviors of near-wake flows (e.g., wake contraction, dynamic wake modulation, and meandering and deflection of nacelle wake, etc.), and their connections with constantly-changing inflows and turbine operation, which are uniquely associated with utility-scale turbines. These findings have demonstrated that the near wake flows, though highly complex, can be predicted with substantial statistical confidence using SCADA and structural response information readily available from the current utility-scale turbines. Such knowledge can be potentially incorporated into wake development models and turbine controllers for wind farm optimization in the future.
We investigate the ability of discontinuous Galerkin (DG) methods to simulate under-resolved turbulent flows in large-eddy simulation. The role of the Riemann solver and the subgrid-scale model in the prediction of a variety of flow regimes, includin g transition to turbulence, wall-free turbulence and wall-bounded turbulence, are examined. Numerical and theoretical results show the Riemann solver in the DG scheme plays the role of an implicit subgrid-scale model and introduces numerical dissipation in under-resolved turbulent regions of the flow. This implicit model behaves like a dynamic model and vanishes for flows that do not contain subgrid scales, such as laminar flows, which is a critical feature to accurately predict transition to turbulence. In addition, for the moderate-Reynolds-number turbulence problems considered, the implicit model provides a more accurate representation of the actual subgrid scales in the flow than state-of-the-art explicit eddy viscosity models, including dynamic Smagorinsky, WALE and Vreman. The results in this paper indicate new best practices for subgrid-scale modeling are needed with high-order DG methods.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا