ترغب بنشر مسار تعليمي؟ اضغط هنا

Thermo-magnetic properties of the magnetocaloric layered materials based upon FeMnAsP: a Green function-method approach

57   0   0.0 ( 0 )
 نشر من قبل Osvaldo Schilling
 تاريخ النشر 2015
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

The compounds FeMnAsxP1-x are very promising as far as commercial applications of the magnetocaloric effect are concerned. However, the theoretical literature on magnetocaloric materials still adopts simple molecular-field models in the description of important properties like the entropy variation that accompanies applied isothermal magnetic field cycling, for instance. We apply a Green function theoretical treatment for such analysis. The advantages of such approach are well-known since the details of the crystal structure are incorporated in the model, as well as a precise description of correlations between spins of the transition metal ions can be obtained. For the sake of simplcity we adopt a simple one-exchange parameter Heisenberg model, and the observed first-order phase transitions are reproduced by the introduction of a biquadratic term in the hamiltonian. Good agreement with experimental magnetocaloric data for FeMnAsxP1-x compounds is obtained, as well as an agreement with the magnetic field dependence for these properties predicted from the Landau theory of continuous phase transitions.



قيم البحث

اقرأ أيضاً

113 - Kun Xu , Zhe Li , Yuan-Lei Zhang 2015
Taking into account the phase fraction during transition for the first-order magnetocaloric materials, an improved isothermal entropy change determination has been put forward based on the Clausius-Clapeyron (CC) equation. It was found that the isoth ermal entropy change value evaluated by our method is in excellent agreement with those determined from the Maxwell-relation (MR) for Ni-Mn-Sn Heusler alloys, which usually presents a weak field-induced phase transforming behavior. In comparison with MR, this method could give rise to a favorable result derived from few thermomagnetic measurements. More importantly, we can eliminate the isothermal entropy change overestimation derived from MR, which always exists in the cases of Ni-Co-Mn-In and MnAs systems with a prominent field-induced transition. These results confirmed that such a CC-equation-based method is quite practical and superior to the MR-based ones in eliminating the spurious spike and reducing measuring cost.
277 - Miao Wang , Songhua Cai , Chen Pan 2018
Van der Waals heterostructure based on layered two-dimensional (2D) materials offers unprecedented opportunities to create materials with atomic precision by design. By combining superior properties of each component, such heterostructure also provid es possible solutions to address various challenges of the electronic devices, especially those with vertical multilayered structures. Here, we report the realization of robust memristors for the first time based on van der Waals heterostructure of fully layered 2D materials (graphene/MoS2-xOx/graphene) and demonstrate a good thermal stability lacking in traditional memristors. Such devices have shown excellent switching performance with endurance up to 107 and a record-high operating temperature up to 340oC. By combining in situ high-resolution TEM and STEM studies, we have shown that the MoS2-xOx switching layer, together with the graphene electrodes and their atomically sharp interfaces, are responsible for the observed thermal stability at elevated temperatures. A well-defined conduction channel and a switching mechanism based on the migration of oxygen ions were also revealed. In addition, the fully layered 2D materials offer a good mechanical flexibility for flexible electronic applications, manifested by our experimental demonstration of a good endurance against over 1000 bending cycles. Our results showcase a general and encouraging pathway toward engineering desired device properties by using 2D van der Waals heterostructures.
We report the fabrication of ErAl2 magnetocaloric wires by a powder-in-tube method (PIT) and the evaluation of magnetic entropy change through magnetization measurements. The magnetic entropy change of ErAl2 PIT wires exhibits similar behavior to the bulk counterpart, while its magnitude is reduced by the decrease in the volume fraction of ErAl2 due to the surrounding non-magnetic sheaths. We find that another effect reduces the magnetic entropy change of the ErAl2 PIT wires around the Curie temperature, and discuss its possible origin in terms of a correlation between magnetic properties of ErAl2 and mechanical properties of sheath material.
138 - D. M. Liu , Z.L.Zhang , S. L. Zhou 2014
Magnetocaloric materials can be useful in magnetic refrigeration applications, but to be practical the magneto-refrigerant needs to have a very large magnetocaloric effect (MCE) near room temperature for modest applied fields (<2 Tesla) with small hy steresis and magnetostriction, and should have a complete magnetic transition, be inexpensive, and environmentally friendly. One system that may fulfill these requirements is MnxFe2-xP1-yGey, where a combined first-order structural and magnetic transition occurs between the high temperature paramagnetic and low temperature ferromagnetic phase. We have used neutron diffraction, differential scanning calorimetry, and magnetization measurements to study the effects of Mn and Ge location in the structure on the ordered magnetic moment, MCE, and hysteresis for a series of compositions of the system near optimal doping. The diffraction results indicate that the Mn ions located on the 3f site enhance the desirable properties, while those located on the 3g sites are detrimental. The entropy changes measured directly by calorimetry can exceed 40 J/kg-K. The phase fraction that transforms, hysteresis of the transition, and entropy change can be controlled by both the compositional homogeneity and the particle size, and an annealing procedure has been developed that substantially improves the performance of all three properties of the material. On the basis of these results we have identified a pathway to optimize the MCE properties of this system for magnetic refrigeration applications.
62 - N. Mingo , Liu Yang 2003
An approach is presented for the atomistic study of phonon transport in real dielectric nanowires via Green functions. The formalism is applied to investigate the phonon flow through nanowires coated by an amorphous material. Examples for a simple mo del system, and for real Si nanowires coated by silica are given. New physical results emerge for these systems, regarding the character of the transition from ballistic to diffusive transport, the low temperature thermal conductance, and the influence of the wire-coating interface on the thermal transport. An efficient treatment of phonon scattering by the amorphous coating is also developed, representing a valuable tool for the investigation of thermal conduction through amorphous-coated nanowires.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا