اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFreestanding loadbearing structures with Z-shaped particles
52
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Architectural structures such as masonry walls or columns exhibit a slender verticality, in contrast to the squat, sloped forms obtained with typical unconfined granular materials. Here we demonstrate the ability to create freestanding, weight-bearing, similarly slender and vertical structures by the simple pouring of suitably shaped dry particles into a mold that is subsequently removed. Combining experiments and simulations we explore a family of particle types that can entangle through their non-convex, hooked shape. We show that Z-shaped particles produce granular aggregates which can either be fluid and pourable, or solid and rigid enough to maintain vertical interfaces and build freestanding columns of large aspect ratio (>10) that support compressive loads without external confinement. We investigate the stability of such columns with uniaxial compression, bending, and vibration tests and compare with other particle types including U-shaped particles and rods. We find a pronounced anisotropy in the internal stress propagation together with strong strain-stiffening, which stabilizes rather than destabilizes the structures under load.
قيم البحث
اقرأ أيضاً
We study steady-state properties of a suspension of active, nonchiral and chiral, Brownian particles with polar alignment and steric interactions confined within a ring-shaped (annulus) confinement in two dimensions. Exploring possible interplays bet
ween polar interparticle alignment, geometric confinement and the surface curvature, being incorporated here on minimal levels, we report a surface-population reversal effect, whereby active particles migrate from the outer concave boundary of the annulus to accumulate on its inner convex boundary. This contrasts the conventional picture, implying stronger accumulation of active particles on concave boundaries relative to the convex ones. The population reversal is caused by both particle alignment and surface curvature, disappearing when either of these factors is absent. We explore the ensuing consequences for the chirality-induced current and swim pressure of active particles and analyze possible roles of system parameters, such as the mean number density of particles and particle self-propulsion, chirality and alignment strengths.
Entropic forces in colloidal suspensions and in polymer-colloid systems are of long-standing and continuing interest. Experiments show how entropic forces can be used to control the self-assembly of colloidal particles. Significant advances in colloi
dal synthesis made in the past two decades have enabled the preparation of high quality nano-particles with well-controlled sizes, shapes, and compositions, indicating that such particles can be utilized as artificial atoms to build new materials. To elucidate the effects of the shape of particles upon the magnitude of entropic interaction, we analyse the entropic interactions of two cut-spheres. We show that the solvent induces a strong directional depletion attraction among flat faces of the cut-spheres. Such an effect highlights the possibility of using the shape of particles to control directionality and strength of interaction.
We analyze the dynamics of an active tracer particle embedded in a thermal lattice gas. All particles are subject to exclusion up to third nearest neighbors on the square lattice, which leads to slow dynamics at high densities. For the case with no r
otational diffusion of the tracer, we derive an analytical expression for the resulting drift velocity v of the tracer in terms of non-equilibrium density correlations involving the tracer particle and its neighbors, which we verify using numerical simulations. We show that the properties of the passive system alone do not adequately describe even this simple system of a single non-rotating active tracer. For large activity and low density, we develop an approximation for v. For the case where the tracer undergoes rotational diffusion independent of its neighbors, we relate its diffusion coefficient to the thermal diffusion coefficient and v. Finally we study dynamics where the rotation of the tracer is limited by the presence of neighboring particles. We find that the effect of this rotational locking may be quantitatively described in terms of a reduction of the rotation rate.
Phase separation in binary mixtures in the presence of Janus particles has been studied in terms of a Cahn-Hilliard model coupled to the Langevin equations describing the particle dynamics. We demonstrate that the phase separation process is arrested
leading to unexpected regular stripe patterns in the concentration field. The underlying pattern forming mechanism has been elucidated: The twofold absorption properties on the surface of Janus particles with respect to the two components of a binary mixture trigger in their neighborhood spatial concentration variations. They result in an effective interaction between the particles mediated by the binary mixture. Our findings open a route to design composite materials with nanoscale lamellar morphologies where the pattern wavelength can be tuned by changing the wetting properties of the Janus particles.
We study the fundamental magnetic states of disc-shaped ferromagnetic particles with a uniaxial anisotropy along the symmetry axis. Besides the monodomain, a bidomain state is also identified and studied both numerically and theoretically. This bidom
ain state consists of two coaxial oppositely magnetized cylindrically symmetric domains and remains stable even at zero bias field, unlike magnetic bubbles in ferromagnetic films. For a given disc thickness we find the critical radius above which the magnetization configuration falls into the bidomain bubble state. The critical radius depends strongly on the film thickness especially for ultrathin films. The effect of an external field is also studied and the bidomain state is found to remain stable over a range of field strengths.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
