اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStructural, and Magnetic properties of flux free large FeTe Single crystal
159
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report synthesis of non superconducting parent compound of iron chalcogenide, i.e., FeTe single crystal by self flux method. The FeTe single crystal is crystallized in tetragonal structure with the P4/nmm space group. The detailed SEM (scanning electron microscopy) results showed that the crystals are formed in slab like morphology and are near (slight deficiency of Te) stoichiometric with homogenous distribution of Fe and Te. The coupled structural and magnetic phase transition is seen at around 70K in both electrical resistivity and magnetization measurements, which is hysteric (deltaT = 5K) in nature with cooling and warming cycles. Magnetic susceptibility (chi-T) measurements showed the magnetic transition to be of antiferromagnetic nature, which is substantiated by isothermal magnetization (M-H) plots as well. The temperature dependent electrical resistivity measured in 10kOe field in both in plane and out of plane field directions showed that the hysteric width nearly becomes double to deltaT = 10K, and is maximum for the out of plane field direction for the studied FeTe single crystal. We also obtained a sharp spike like peak in heat capacity Cp(T) measurement due to the coupled structural and magnetic order phase transitions.
قيم البحث
اقرأ أيضاً
We report mainly the heat capacity and Mossbauer study of self flux grown FeTe single crystal, which is ground state compound of the Fe chalcogenides superconducting series, i.e., FeTe1-x(Se/S)x. The as grown FeTe single crystal is large enough to th
e tune of few cm and the same crystallizes in tetragonal structure having space group of P4/nmm. FeTe shows the structural/magnetic phase transition at 70K in both magnetic and resistivity measurements. Heat capacity measurement also confirms the coupled structural/magnetic transition at the same temperature. The Debye model fitting of low temperature (below 70K) heat capacity exhibited Debye temperature to be 324K. MOssbauer spectra are performed at 300K and 5K. The 300K spectra showed two paramagnetic doublets and the 5K spectra exhibited hyperfine magnetic sextet with an average hyperfine field of 10.6Tesla matching with the results of Yoshikazu Mizuguchi et al.
We report successful growth of flux free large single crystals of superconducting FeSe1/2Te1/2 with typical dimensions of up to few cm. The AC and DC magnetic measurements revealed the superconducting transition temperature (Tc) value of around 11.5K
and the iso-thermal MH showed typical type-II superconducting behavior. The lower critical field being estimated by measuring the low field iso-thermal magnetization in superconducting regime is found to be above 200 Oe at 0K.
We report the synthesis of a new quasi one-dimensional (1D) iron selenide. Ba9Fe3Se15 was synthesized at high temperature and high pressure of 5.5 GPa and systematically studied via structural, magnetic and transport measurements at ambient and at hi
gh-pressures. Ba9Fe3Se15 crystallizes in a monoclinic structure and consists of face-sharing FeSe6 octahedral chains along the c axis. At ambient pressure it exhibits an insulating behavior with a band gap ~460 meV and undergoes a ferrimagnet-like phase transition at 14 K. Under high pressure, a complete metallization occurs at ~29 GPa, which is accompanied by a spin state crossover from high spin (HS) state to low spin (LS) state. The LS appears for pressures P >36 GPa.
Since the discovery of high-temperature superconductivity in the thin-film FeSe/SrTiO$_3$ system, iron selenide and its derivates have been intensively scrutinized. Using ab initio density functional theory calculations we review the electronic struc
tures that could be realized in iron-selenide if the structural parameters could be tuned at liberty. We calculate the momentum-dependence of the susceptibility and investigate the symmetry of electron pairing within the random phase approximation. Both the susceptibility and the symmetry of electron pairing depend on the structural parameters in a nontrivial way. These results are consistent with the known experimental behavior of binary iron chalcogenides and, at the same time, reveal two promising new ways of tuning superconducting transition temperatures in these materials. On the one hand by expanding the iron lattice of FeSe at constant iron-selenium distance and, on the other hand, by increasing the iron-selenium distance with unchanged iron lattice.
Single crystals of the LnFeAsO (Ln1111, Ln = Pr, Nd, and Sm) family with lateral dimensions up to 1 mm were grown from NaAs and KAs flux at high pressure. The crystals are of good structural quality and become superconducting when O is partially subs
tituted by F (PrFeAsO1-xFx and NdFeAsO1-xFx) or when Fe is substituted by Co (SmFe1-xCoxAsO). From magnetization measurements, we estimate the temperature dependence and anisotropy of the upper critical field and the critical current density of underdoped PrFeAsO0.7F0.3 crystal with Tc = 25 K. Single crystals of SmFe1-xCoxAsO with maximal Tc up to 16.3 K for x = 0.08 were grown for the first time. From transport and magnetic measurements we estimate the critical fields and their anisotropy, and find these superconducting properties to be quite comparable to the ones in SmFeAsO1-xFx with a much higher Tc of = 50 K. The magnetically measured critical current densities are as high as 109 A/m2 at 2 K up to 7 T, with indication of the usual fishtail effect. The upper critical field estimated from resistivity measurements is anisotropic with slopes of -8.7 T/K (H // ab-plane) and -1.7 T/K (H // c-axis). This anisotropy (= 5) is similar to that in other Ln1111 crystals with various higher Tc s.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
