اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOptimal frequency conversion in the nonlinear stage of modulation instability
364
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigate multi-wave mixing associated with the strongly pump depleted regime of induced modulation instability (MI) in optical fibers. For a complete transfer of pump power into the sideband modes, we theoretically and experimentally demonstrate that it is necessary to use a much lower seeding modulation frequency than the peak MI gain value. Our analysis shows that a record 95 % of the input pump power is frequency converted into the comb of sidebands, in good quantitative agreement with analytical predictions based on the simplest exact breather solution of the nonlinear Schrodinger equation.
قيم البحث
اقرأ أيضاً
The nonlinear stage of modulational instability in optical fibers induced by a wide and easily accessible class of localized perturbations is studied using the nonlinear Schrodinger equation. It is showed that the development of associated spatio-tem
poral patterns is strongly affected by the shape and the parameters of the perturbation. Different scenarios are presented that involve an auto-modulation developing in a characteristic wedge, possibly coexisting with breathers which lie inside or outside the wedge.
We report on the experimental and numerical observation of polarization modulation instability (PMI) in a nonlinear fiber Kerr resonator. This phenomenon is phased-matched through the relative phase detuning between the intracavity fields associated
with the two principal polarization modes of the cavity. Our experimental investigation is based on a 12-m long fiber ring resonator in which a polarization controller is inserted to finely control the level of intra-cavity birefringence. Depending on the amount of birefringence, the temporal patterns generated via PMI are found to be either stationary or to exhibit a period-doubled dynamics. Experimental results are in good agreement with numerical simulations based on an Ikeda map for the two orthogonally polarized modes. Our study provides new insights into the control of modulation instability in multimode Kerr resonators. Modulation instability (MI) is a nonlinear phenomenon characterized by the exponential growth and evolution of periodic perturbations on top of an intense continuous-wave (cw) laser beam [1, 2]. Underpinned by a nonlinearly phase-matched parametric process, it is associated with a transfer of energy from a narrow pump frequency component to a pair of sidebands arranged symmetrically around the pump. In single-pass optical fiber propagation, MI can be naturally phase-matched through a balance between anomalous group-velocity dispersion and Kerr nonlinearity [1, 2]. In contrast, more general phase-matching conditions are possible in the context of passive Kerr resonators, such as fiber ring cavities, because of the crucial role played by the systems boundary conditions [3-5]. Various configurations of MI have been investigated in that context, including MI in the normal dispersion regime, MI via bichromatic or incoherent driving, as well as competition between MI and Faraday or period-doubled (P2) instabilities [6--12]. Moreover, at variance with single-pass propagation, MI in Kerr resonators can lead to the emergence of stationary periodic (Turing) patterns; such patterns are now understood to be intimately related to temporal cavity solitons and microresonator optical frequency combs [13--16]. Birefringence, and nonlinear coupling between the polarization components of light, is also known to contribute to the phase-matching of parametric processes. This leads to polarization MI (PMI) and the emergence of vector temporal patterns [17-19]. In driven resonators, PMI has only been investigated theoretically so far [20-22], but recent demonstrations of orthogonally-polarized dual comb generation in microresonators are sparking a renewed interest in this process [23]. In this Letter, we report on the direct experimental observation of PMI in a passive Kerr resonator. Our experimental test-bed is based on a normally dispersive fiber ring cavity that incorporates a polarization controller for adjustment of the intra-cavity birefringence. This localized birefringence gives rise to a relative phase detuning between the two orthogonal polarization modes of the cavity, which in turn affects the frequency shift of the PMI sidebands. We also find that birefringence can lead to period-doubled (P2) dynamics, characterized by a two round-trip cycle. Our experimental results are in good agreement with theoretical predictions and numerical simulations based on an iterative two-component Ikeda map. The experimental setup is displayed in Fig. 1(a). It consists of a L = 12-m long passive fiber ring cavity with a finesse F of about 27, mainly built out of spun fiber. To avoid competition with scalar MI [2], we have built a cavity with normal group-velocity dispersion estimated to 2 = 47 ps 2 /km, a value large enough to neglect third-order dispersion. Also, the use of a spun fiber (nearly isotropic) avoids group-velocity mismatch between the polarization components. Additionally, to prevent any additional source of bending-induced birefringence, the fiber was carefully off-spooled and wound directly on our experimental board with a large 50-cm diameter. We estimate that this causes a birefringence $Delta$n no greater than 10 --8 [24], which can be neglected in our study.
Kerr optical frequency combs generated in a coherently driven Kerr nonlinear resonator has the potential for a wide range of applications. However, in a single cavity which is a widely adopted configuration for Kerr optical frequency combs generation
, modulation instability is suppressed in normal dispersion regime and the pump-to-comb conversion efficiency is extremely low for a single dissipative Kerr soliton in anomalous dispersion regime. Dual-coupled cavities have been proposed to generate Kerr optical frequency combs in normal dispersion regime, and have potential to remarkably increase conversion efficiency for Kerr optical frequency combs. Here, we investigate modulation instability and Kerr optical frequency-comb formation in dual-coupled cavities. Based on solutions of the continuous-wave steady state, we obtain a quadric algebraic equation describing the modulation instability gain, and we find that it is intensely influenced by the group velocity mismatch between the two cavities. Our numerical simulations demonstrate that platicons can be generated via pump scanning scheme for the case that both the two cavities possess normal dispersion, and a single dissipative Kerr soliton can be generated in the cavity with anomalous dispersion while the dispersion of the other cavity is normal. Our analysis of modulation instability provides a powerful tool for Kerr optical frequency-comb generation via pump modulation and cavity detuning tuning scheme in dual-coupled cavities.
Geometrical dimensionality plays a fundamentally important role in the topological effects arising in discrete lattices. While direct experiments are limited by three spatial dimensions, the research topic of synthetic dimensions implemented by the f
requency degree of freedom in photonics is rapidly advancing. The manipulation of light in such artificial lattices is typically realized through electro-optic modulation, yet their operating bandwidth imposes practical constraints on the range of interactions between different frequency components. Here we propose and experimentally realize all-optical synthetic dimensions involving specially tailored simultaneous short- and long-range interactions between discrete spectral lines mediated by frequency conversion in a nonlinear waveguide. We realize triangular chiral-tube lattices in three-dimensional space and explore their four-dimensional generalization. We implement a synthetic gauge field with nonzero magnetic flux and observe the associated multidimensional dynamics of frequency combs, all within one physical spatial port. We anticipate that our method will provide a new means for the fundamental study of high-dimensional physics and act as an important step towards using topological effects in optical devices operating in the time and frequency domains.
Vector beams (VBs) are widely investigated for its special intensity and polarization distributions, which is useful for optical micromanipulation, optical micro-fabrication, optical communication, and single molecule imaging. To date, it is still a
challenge to realize nonlinear frequency conversion (NFC) and manipulation of such VBs because of the polarization sensitivity in most of nonlinear processes. Here, we report an experimental realization of NFC and manipulation of VBs which can be used to expand the available frequency band. The main idea of our scheme is to introduce a Sagnac loop to solve the polarization dependence of NFC in nonlinear crystals. Furthermore, we find that a linearly polarized vector beam should be transformed to an exponential form before performing the NFC. The experimental results are well agree with our theoretical model. The present method is also applicable to other wave bands and second order nonlinear processes, and may also be generalized to the quantum regime for single photons.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
