اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUsing FUV to IR Variability to Probe the Star-Disk Connection in the Transitional Disk of GM Aur
244
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We analyze 3 epochs of ultraviolet (UV), optical and near-infrared (NIR) observations of the Taurus transitional disk GM Aur using the Hubble Space Telescope Imaging Spectrograph (STIS) and the Infrared Telescope Facility SpeX spectrograph. Observations were separated by one week and 3 months in order to study variability over multiple timescales. We calculate accretion rates for each epoch of observations using the STIS spectra and find that those separated by one week had similar accretion rates (~1E-8 solar masses/yr) while the epoch obtained 3 months later had a substantially lower accretion rate (~4E-9 solar masses/yr). We find that the decline in accretion rate is caused by lower densities of material in the accretion flows, as opposed to a lower surface coverage of the accretion columns. During the low accretion rate epoch we also observe lower fluxes at both far UV (FUV) and IR wavelengths, which trace molecular gas and dust in the disk, respectively. We find that this can be explained by a lower dust and gas mass in the inner disk. We attribute the observed variability to inhomogeneities in the inner disk, near the corotation radius, where gas and dust may co-exist near the footprints of the magnetospheric flows. These FUV--NIR data offer a new perspective on the structure of the inner disk, the stellar magnetosphere, and their interaction.
قيم البحث
اقرأ أيضاً
Here we analyze the first simultaneous X-ray, ultraviolet, optical, infrared, and centimeter observations of a T Tauri star (TTS). We present three epochs of simultaneous Spitzer and VLA data of GM Aur separated by ~1 wk. These data are compared to p
reviously published HST and Chandra observations from which mass accretion rates ($dot M$) and X-ray luminosities, respectively, were measured. The mid-infrared emission increases along with $dot M$, and we conclude that this is due to an increase in the mass in the inner disk. The cm emission, which probes the jet, also appears to increase as $dot M$ increases, and the changes in the cm flux are consistent with the variability in $dot M$ assuming the mass-loss rate is ~10% $dot M$. The 3 cm emission morphology also appears changed compared with observations taken three years previously, suggesting that for the first time, we may be tracking changes in the jet morphology of a TTS. The X-ray luminosity is constant throughout the three epochs, ruling out variable high-energy stellar radiation as the cause for the increases in the mid-infrared or cm emission. Tying together the multiwavelength variability observed, we conclude that an increase in the surface density in the inner disk resulted in more mass loading onto the star and therefore a higher $dot M$, which led to a higher mass-loss rate in the jet. These results stress the importance of coordinated multiwavelength work to better understand the star-disk-jet connection.
We have imaged GM Aur with HST, detected its disk in scattered light at 1400A and 1650A, and compared these with observations at 3300A, 5550A, 1.1 microns, and 1.6 microns. The scattered light increases at shorter wavelengths. The radial surface brig
htness profile at 3300A shows no evidence of the 24AU radius cavity that has been previously observed in sub-mm observations. Comparison with dust grain opacity models indicates the surface of the entire disk is populated with sub-micron grains. We have compiled an SED from 0.1 microns to 1 mm, and used it to constrain a model of the star+disk system that includes the sub-mm cavity using the Monte Carlo Radiative Transfer code by Barbara Whitney. The best-fit model image indicates that the cavity should be detectable in the F330W bandpass if the cavity has been cleared of both large and small dust grains, but we do not detect it. The lack of an observed cavity can be explained by the presence of sub-microns grains interior to the sub-mm cavity wall. We suggest one explanation for this which could be due to a planet of mass <9 Jupiter masses interior to 24 AU. A unique cylindrical structure is detected in the FUV data from the Advanced Camera for Surveys/Solar Blind Channel. It is aligned along the system semi-minor axis, but does not resemble an accretion-driven jet. The structure is limb-brightened and extends 190 +/- 35 AU above the disk midplane. The inner radius of the limb-brightening is 40 +/- 10 AU, just beyond the sub-millimeter cavity wall.
We present high-contrast H-band polarized intensity (PI) images of the transitional disk around the young solar-like star GM Aur. The near-infrared direct imaging of the disk was derived by polarimetric differential imaging using the Subaru 8.2-m Tel
escope and HiCIAO. An angular resolution and an inner working angle of 0.07 and r~0.05, respectively, were obtained. We clearly resolved a large inner cavity, with a measured radius of 18+/-2 au, which is smaller than that of a submillimeter interferometric image (28 au). This discrepancy in the cavity radii at near-infrared and submillimeter wavelengths may be caused by a 3-4M_Jup planet about 20 au away from the star, near the edge of the cavity. The presence of a near-infrared inner is a strong constraint on hypotheses for inner cavity formation in a transitional disk. A dust filtration mechanism has been proposed to explain the large cavity in the submillimeter image, but our results suggest that this mechanism must be combined with an additional process. We found that the PI slope of the outer disk is significantly different from the intensity slope obtained from HST/NICMOS, and this difference may indicate the grain growth process in the disk.
The disk around AB Aur was imaged and resolved at 24.6,$mu$m using the Cooled Mid-Infrared Camera and Spectrometer on the 8.2m Subaru Telescope. The gaussian full-width at half-maximum of the source size is estimated to be 90 $pm$ 6 AU, indicating th
at the disk extends further out at 24.6,$mu$m than at shorter wavelengths. In order to interpret the extended 24.6,$mu$m image, we consider a disk with a reduced surface density within a boundary radius $R_c$, which is motivated by radio observations that suggest a reduced inner region within about 100 AU from the star. Introducing the surface density reduction factor $f_c$ for the inner disk, we determine that the best match with the observed radial intensity profile at 24.6,$mu$m is achieved with $R_c$=88 AU and $f_c$=0.01. We suggest that the extended emission at 24.6,$mu$m is due to the enhanced emission from a wall-like structure at the boundary radius (the inner edge of the outer disk), which is caused by a jump in the surface density at $R_c$. Such reduced inner disk and geometrically thick outer disk structure can also explain the more point-like nature at shorter wavelengths. We also note that this disk geometry is qualitatively similar to a pre-transitional disk, suggesting that the AB Aur disk is in a pre-transitional disk phase.
Our understanding of protoplanetary disks is rapidly departing from the classical view of a smooth, axisymmetric disk. This is in part thanks to the high angular resolution that (sub)mm observations can provide. Here we present the combined results o
f ALMA (0.9 mm) and VLA (7 mm) dust continuum observations toward the protoplanetary disk around the solar analogue GM Aur. Both images clearly resolve the $sim$35 au inner cavity. The ALMA observations also reveal a fainter disk that extends up to $sim250$ au. We model our observations using two approaches: an analytical fit to the observed deprojected visibilities, and a physical disk model that fits the SED as well as the VLA and ALMA observations. Despite not being evident in the deconvolved images, the VLA and ALMA visibilities can only be fitted with two bright rings of radii $sim$40 and $sim$80 au. Our physical model indicates that this morphology is the result of an accumulation or trapping of large dust grains, probably due to the presence of two pressure bumps in the disk. Even though alternative mechanisms cannot be discarded, the multiple rings suggest that forming planets may have cleared at least two gaps in the disk. Finally, our analysis suggests that the inner cavity might display different sizes at 0.9 mm and 7 mm. This discrepancy could be caused by the presence of free-free emission close to the star at 7 mm, or by a more compact accumulation of the large dust grains at the edge of the cavity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
