اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدProfile measurements in the plasma edge of MAST using a ball pen probe
155
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The ball pen probe (BPP) technique is used successfully to make profile measurements of plasma potential, electron temperature and radial electric field on the Mega Amp Spherical Tokamak (MAST). The potential profile measured by the BPP is shown to significantly differ from the floating potential both in polarity and profile shape. By combining the BPP potential and the floating potential the electron temperature can be measured, which is compared with the Thomson scattering (TS) diagnostic. Excellent agreement between the two diagnostics is obtained when secondary electron emission is accounted for in the floating potential. From the BPP profile an estimate of the radial electric field is extracted which is shown to be of the order ~1kV/m and increases with plasma current. Corrections to the BPP measurement, constrained by the TS comparison, introduce uncertainty into the ER measurements. The uncertainty is most significant in the electric field well inside the separatrix. The electric field is used to estimate toroidal and poloidal rotation velocities from ExB motion. This paper further demonstrates the ability of the ball pen probe to make valuable and important measurements in the boundary plasma of a tokamak.
قيم البحث
اقرأ أيضاً
General conditions of stability of a very dense deuterium-tritium plasma ball are discussed. It is shown that the decrease in the size of a plasma ball (increase in the plasma density) can be expected only when the temperature and the pressure in the
plasma ball are kept high enough for all the particles, the nuclei and the delocalized electrons, to be described by classical statistics.
Type-I Edge Localised Modes (ELMs) have been mitigated in MAST through the application of n = 3, 4 and 6 resonant magnetic perturbations (RMPs). For each toroidal mode number of the non-axisymmetric applied fields, the frequency of the ELMs has been
increased significantly, and the peak heat flux on the divertor plates reduced commensurately. This increase in ELM frequency occurs despite a significant drop in the edge pressure gradient, which would be expected to stabilise the peeling-ballooning modes thought to be responsible for type-I ELMs. Various mechanisms which could cause a destabilisation of the peeling-ballooning modes are presented, including pedestal widening, plasma rotation braking, three dimensional corrugation of the plasma boundary and the existence of radially extended lobe structures near to the X-point. This leads to a model aimed at resolving the apparent dichotomy of ELM control, that is to say ELM suppression occurring due to the pedestal pressure reduction below the peeling-ballooning stability boundary, whilst the reduction in pressure can also lead to ELM mitigation, which is ostensibly a destabilisation of peeling-ballooning modes. In the case of ELM mitigation, the pedestal broadening, 3d corrugation or lobes near the X-point degrade ballooning stability so much that the pedestal recovers rapidly to cross the new stability boundary at lower pressure more frequently, whilst in the case of suppression, the plasma parameters are such that the particle transport reduces the edge pressure below the stability boundary which is only mildly affected by negligible rotation braking, small edge corrugation or short, broad lobe structures.
We have explored the thermodynamics of compressed magnetized plasmas in laboratory experiments and we call these studies magnetothermodynamics. The experiments are carried out in the Swarthmore Spheromak eXperiment device. In this device, a magnetize
d plasma source is located at one end and at the other end, a closed conducting can is installed. We generate parcels of magnetized plasma and observe their compression against the end wall of the conducting cylinder. The plasma parameters such as plasma density, temperature, and magnetic field are measured during compression using HeNe laser interferometry, ion Doppler spectroscopy and a linear $dot{B}$ probe array, respectively. To identify the instances of ion heating during compression, a PV diagram is constructed using measured density, temperature, and a proxy for the volume of the magnetized plasma. Different equations of state are analyzed to evaluate the adiabatic nature of the compressed plasma. A 3D resistive magnetohydrodynamic code (NIMROD) is employed to simulate the twisted Taylor states and show stagnation against the end wall of the closed conducting can. The simulation results are consistent to what we observe in our experiments.
Edge turbulent structures are commonly observed in fusion devices and are generally believed to be responsible for confinement degradation. Among their origin Drift-Alfven turbulence is one of the most commonly suggested. Drift-Alfven paradigm allows
the existence of localized vortex-like structures observed also in various systems. Here we present the evidence of the presence of drift-Alfven vortices in the edge region of RFX-Mod RFP device, showing how these structures are responsible for electromagnetic turbulence at the edge and its intermittent nature.
For a two week period during the Joint European Torus (JET) 2012 experimental campaign, the same high confinement plasma was repeated 151 times. The dataset was analysed to produce a probability density function (pdf) for the waiting times between ed
ge-localised plasma instabilities (ELMS). The result was entirely unexpected. Instead of a smooth single peaked pdf, a succession of 4-5 sharp maxima and minima uniformly separated by 7-8 millisecond intervals was found. Here we explore the causes of this newly observed phenomenon, and conclude that it is either due to a self-organised plasma phenomenon or an interaction between the plasma and a real-time control system. If the maxima are a result of resonant frequencies at which ELMs can be triggered more easily, then future ELM control techniques can, and probably will, use them. Either way, these results demand a deeper understanding of the ELMing process.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
