اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCoronal magnetic field and the plasma beta determined from radio and multiple satellite observations
321
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We derived the coronal magnetic field, plasma density, and temperature from the observation of polarization and intensity of radio thermal free-free emission using the Nobeyama Radioheliograph (NoRH) and extreme ultraviolet (EUV) observations. We observed a post-flare loop on the west limb 11 April 2013. The line-of-sight magnetic field was derived from the circularly polarized free-free emission observed by NoRH. The emission measure and temperature were derived from the Atmospheric Imaging Assembly (AIA) onboard Solar Dynamics Observatory (SDO). The derived temperature was used to estimate the emission measure from the NoRH radio free-free emission observations. The derived density from NoRH was larger than that determined using AIA, which can be explained by the fact that the low temperature plasma is not within the temperature coverage of the AIA filters used in this study. We also discuss the other observation of the post-flare loops by the EUV Imager onboard the Solar Terrestrial Relations Observatory (STEREO), which can be used in future studies to reconstruct the coronal magnetic field strength. The derived plasma parameters and magnetic field were used to derive the plasma beta, which is a ratio between the magnetic pressure and the plasma pressure. The derived plasma beta is about 5.7*10^(-4) to 7.6*10^(-4) at the loop top region.
قيم البحث
اقرأ أيضاً
We estimated the accuracy of coronal magnetic fields derived from radio observations by comparing them to potential field calculations and the DEM measurements using EUV observations. We derived line of sight component of the coronal magnetic field f
rom polarization observations of the thermal bremsstrahlung in the NOAA active region 11150, observed around 3:00 UT on February 3, 2011 using the Nobeyama Radioheliograph at 17 GHz. Because the thermal bremsstrahlung intensity at 17 GHz includes both chromospheric and coronal components, we extracted only the coronal component by measuring the coronal emission measure in EUV observations. In addition, we derived only the radio polarization component of the corona by selecting the region of coronal loops and weak magnetic field strength in the chromosphere along the line of sight. The upper limit of the coronal longitudinal magnetic fields were determined as 100 - 210 G. We also calculated the coronal longitudinal magnetic fields from the potential field extrapolation using the photospheric magnetic field obtained from the Helioseismic and Magnetic Imager (HMI). However, the calculated potential fields were certainly smaller than the observed coronal longitudinal magnetic field. This discrepancy between the potential and the observed magnetic field strengths can be explained consistently by two reasons; (a) the underestimation of the coronal emission measure resulting from the limitation of the temperature range of the EUV observations, (b) the underestimation of the coronal magnetic field resulting from the potential field assumption.
Magnetism defines the complex and dynamic solar corona. Coronal mass ejections (CMEs) are thought to be caused by stresses, twists, and tangles in coronal magnetic fields that build up energy and ultimately erupt, hurling plasma into interplanetary s
pace. Even the ever-present solar wind possesses a three-dimensional morphology shaped by the global coronal magnetic field, forming geoeffective corotating interaction regions. CME evolution and the structure of the solar wind depend intimately on the coronal magnetic field, so comprehensive observations of the global magnetothermal atmosphere are crucial both for scientific progress and space weather predictions. Although some advances have been made in measuring coronal magnetic fields locally, synoptic measurements of the global coronal magnetic field are not yet available. We conclude that a key goal for 2050 should be comprehensive, ongoing 3D synoptic maps of the global coronal magnetic field. This will require the construction of new telescopes, ground and space-based, to obtain complementary, multiwavelength observations sensitive to the coronal magnetic field. It will also require development of inversion frameworks capable of incorporating multi-wavelength data, and forward analysis tools and simulation testbeds to prioritize and establish observational requirements on the proposed telescopes.
This work deals with the study of an erupting prominence embedded in the core of a CME and focuses on the derivation of the prominence plasma filling factor. We explore two methods to measure the prominence plasma filling factor that are based on the
combination of visible-light and ultraviolet spectroscopic observations. Theoretical relationships for resonant scattering and collisional excitation are used to evaluate the intensity of the H I Lyman-{alpha} and Lyman-{beta} lines, in two prominence points where simultaneous and cospatial LASCO-C2 and UVCS data were available. Thermodynamic and geometrical parameters assumed for the calculation are provided by both observations and the results of a detailed 1D non-LTE radiative-transfer model of the prominence, developed in our previous work (Heinzel 2016). The filling factor is derived from the comparison between the calculated and the measured intensities of the two lines. The results are then checked against the non-LTE model in order to verify the reliability of the methods. The resulting filling factors are consistent with the model in both the prominence points when the separation of the radiative and collisional components of the total intensity, required to estimate the filling factor, is performed using both the line intensities. An exploration of the parameter space shows that the results are weakly sensitive to the plasma velocity, but they depends more strongly on the assumed kinetic temperatures. The combination of visible-light and ultraviolet Lyman-{alpha} and Lyman-{beta} data can be used to approximately estimate the geometrical filling factor in erupting prominences, but the proposed techniques are reliable only for emission that is optically thin in the lines considered, condition that is not in general representative of prominence plasma.
We present observations and magnetic field models of an intermediate filament present on the Sun in August 2012, associated with a polarity inversion line that extends from AR 11541 in the east into the quiet sun at its western end. A combination of
SDO/AIA, SDO/HMI, and GONG H alpha data allow us to analyse the structure and evolution of the filament from 2012 August 4 23:00 UT to 2012 August 6 08:00 UT when the filament was in equilibrium. By applying the flux rope insertion method, nonlinear force-free field models of the filament are constructed using SDO/HMI line-of-sight magnetograms as the boundary condition at the two times given above. Guided by observed filament barbs, both modelled flux ropes are split into three sections each with a different value of axial flux to represent the non-uniform photospheric field distribution. The flux in the eastern section of the rope increases by 4$times$10$^{20}$ Mx between the two models, which is in good agreement with the amount of flux cancelled along the internal PIL of AR 11541, calculated to be 3.2$times$10$^{20}$ Mx. This suggests that flux cancellation builds flux into the filaments magnetic structure. Additionally, the number of field line dips increases between the two models in the locations where flux cancellation, the formation of new filament threads and growth of the filament is observed. This suggests that flux cancellation associated with magnetic reconnection forms concave-up magnetic field that lifts plasma into the filament. During this time, the free magnetic energy in the models increases by 0.2$times$10$^{31}$ ergs.
The Type-II solar radio burst recorded on 13 June 2010 by the radio spectrograph of the Hiraiso Solar Observatory was employed to estimate the magnetic-field strength in the solar corona. The burst was characterized by a well pronounced band-splittin
g, which we used to estimate the density jump at the shock and Alfven Mach number using the Rankine-Hugoniot relations. The plasma frequency of the Type-II bursts is converted into height [R] in solar radii using the appropriate density model, then we estimated the shock speed [Vs], coronal Alfven velocity [Va], and the magnetic-field strength at different heights. The relative bandwidth of the band-split is found to be in the range 0.2 -- 0.25, corresponding to the density jump of X = 1.44 -- 1.56, and the Alfven Mach number of MA = 1.35 -- 1.45. The inferred mean shock speed was on the order of V ~ 667 km/s. From the dependencies V(R) and MA(R) we found that Alfven speed slightly decreases at R ~ 1.3 -- 1.5. The magnetic-field strength decreases from a value between 2.7 and 1.7 G at R ~ 1.3 -- 1.5 Rs depending on the coronal-density model employed. We find that our results are in good agreement with the empirical scaling by Dulk and McLean (Solar Phys. 57, 279, 1978) and Gopalswamy et al. (Astrophys. J. 744, 72, 2012). Our result shows that Type-II band splitting method is an important tool for inferring the coronal magnetic field, especially when independent measurements were made from white light observations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
