ترغب بنشر مسار تعليمي؟ اضغط هنا

Bifurcation and control of chaos in Induction motor drives

143   0   0.0 ( 0 )
 نشر من قبل Krishnendu Chakrabarty Dr.
 تاريخ النشر 2014
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

The induction motor controlled by Indirect Field Oriented Control (IFOC) is known to have high performance and better stability. This paper reports the dynamical behavior of an indirect field oriented control (IFOC) induction motor drive in the light of bifurcation theory. The speed of high performance induction motor drive is controlled by IFOC method. The knowledge of qualitative change of the behavior of the motor such as equilibrium points, limit cycles and chaos with the change of motor parameters and load torque are essential for proper control of the motor. This paper provides a numerical approach to understand better the dynamical behavior of an indirect field oriented control of a current-fed induction motor. The focus is on bifurcation analysis of the IFOC motor, with a particular emphasis on the change that affects the dynamics and stability under small variations of Proportional Integral controller (PI) parameters, load torque and k, the ratio of the rotor time constant and its estimate etc. Bifurcation diagrams are computed. This paper also attempts to discuss various types of the transition to chaos in the induction motor. The results of the obtained bifurcation simulations give useful guidelines for adjusting both motor model and PI controller parameters. It is also important to ensure desired operation of the motor when the motor shows chaotic behavior. Infinite numbers of unstable periodic orbits are embedded in a chaotic attractor. Any unstable periodic orbit can be stabilized by proper control algorithm. The delayed feedback control method to control chaos has been implemented in this system.



قيم البحث

اقرأ أيضاً

The loss of stability of induction motor controlled by Indirect Field Oriented Control (IFOC) is a matter of great concern of operators and design engineers. This paper reports indices to detect and predict stability problem such as system oscillatio ns. Oscillations as a result of loss of stability, due to Hopf bifurcation, for different parameter values of IFOC motor are studied using the proposed indices.
Discrete fractional order chaotic systems extends the memory capability to capture the discrete nature of physical systems. In this research, the memristive discrete fractional order chaotic system is introduced. The dynamics of the system was studie d using bifurcation diagrams and phase space construction. The system was found chaotic with fractional order $0.465<n<0.562$. The dynamics of the system under different values makes it useful as a switch. Controllers were developed for the tracking control of the two systems to different trajectories. The effectiveness of the designed controllers were confirmed using simulations
The paper presents bifurcation behavior of a single phase induction motor. This paper also attempts to discuss the bifurcation behavior of the system based on the evolution of different state variables. The bifurcation diagrams drawn looking at diffe rent state variables are different in terms of periodicity and route to chaos. The knowledge of the dynamics of the system obtained from bifurcation diagrams give useful guidelines to control the operation of the induction motor depending on the need of an application for better performance.
STATCOMs is used widely in power systems these days. Traditionally, this converter was controlled using a double-loop control or Direct Output Voltage (DOV) controller. But DOV controller do not function properly during a three-phase fault and has a lot of overshoot. Also, the number of PI controllers used in double-loop control is high, which led to complexities when adjusting the coefficients. Therefore, in this paper, an improved DOV method is proposed which, in addition to a reduced number of PI controllers, has a higher speed, lower overshoots and a higher stability in a wider range. By validating the proposed DOV method for controlling the STATCOMs, it has been attempted to improve the dynamical behaviors of induction motor using Matlab/Simulink, and the results indicate a better performance of the proposed method as compared to the other methods.
59 - Marcin Daszkiewicz 2017
In this article we synchronize by active control method all 19 identical Sprott systems provided in paper [10]. Particularly, we find the corresponding active controllers as well as we perform (as an example) the numerical synchronization of two Sprott-A models.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا