اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn measurement of the isotropy of the speed of light
237
0
0.0
(
0
)
تأليف
B. Wojtsekhowski
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Three experimental concepts investigating possible anisotropy of the speed of light are presented. They are based on i) beam deflection in a 180 degree magnetic arc, ii) narrow resonance production in an electron-positron collider, and iii) the ratio of magnetic moments of an electron and a positron moving in opposite directions.
قيم البحث
اقرأ أيضاً
In this paper we extend a new method to measure possible variation of the speed of light by using Baryon Acoustic Oscillations and the Hubble function presented in our earlier paper [V. Salzano, M. P. Dc{a}browski, and R. Lazkoz, Phys. Rev. D93, 0635
21 (2016)] onto an inhomogeneous model of the universe. The method relies on the fact that there is a simple relation between the angular diameter distance $(D_{A})$ maximum and the Hubble function $(H)$ evaluated at the same maximum-condition redshift, which includes speed of light $c$. One limit of such method was the assumption of null spatial curvature (even if we showed that even a non-zero curvature would have negligible effects). Here, we move one step further: we explicitly assume a model with intrinsic non-null curvature, and calculate the exact relation between $D_{A}$ and $H$ in this case. Then, we evaluate if current or future missions such as SKA can be sensitive enough to detect any such kind of spatial variation of $c$ which can perhaps be related to the recently observed spatial variation of the fine structure constant (an effect known as $alpha$-dipole).
The UV LED mission demonstrates the precise control of the potential of electrically isolated test masses that is essential for the operation of space accelerometers and drag free sensors. Accelerometers and drag free sensors were and remain at the c
ore of geodesy, aeronomy, and precision navigation missions as well as gravitational science experiments and gravitational wave observatories. Charge management using photoelectrons generated by the 254 nm UV line of Hg was first demonstrated on Gravity Probe B and is presently part of the LISA Pathfinder technology demonstration. The UV LED mission and prior ground testing demonstrates that AlGaN UV LEDs operating at 255 nm are superior to Mercury vapor lamps because of their smaller size, lower draw, higher dynamic range, and higher control authority. We show flight data from a small satellite mission on a Saudi Satellite that demonstrates AC charge control (UV LEDs and bias are AC modulated with adjustable relative phase) between a spherical test mass and its housing. The result of the mission is to bring the UV LED device Technology Readiness Level (TRL) to TRL 9 and the charge management system to TRL 7. We demonstrate the ability to control the test mass potential on an 89 mm diameter spherical test mass over a 20 mm gap in a drag free system configuration. The test mass potential was measured with an ultra high impedance contact probe. Finally, the key electrical and optical characteristics of the UV LEDs showed less than 7.5 percent change in performance after 12 months in orbit.
In this letter we describe a new method to use Baryon Acoustic Oscillations (BAO) to derive a constraint on the possible variation of the speed of light. The method relies on the fact that there is a simple relation between the angular diameter dista
nce $(D_{A})$ maximum and the Hubble function $(H)$ evaluated at the same maximum-condition redshift, which includes speed of light $c$. We note the close analogy of the BAO probe with a laboratory experiment: here we have $D_{A}$ which plays the role of a standard (cosmological) ruler, and $H^{-1}$, with the dimension of time, as a (cosmological) clock. We evaluate if current or future missions such as Euclid can be sensitive enough to detect any variation of $c$.
We report on a test of Lorentz invariance performed by comparing the resonance frequencies of one stationary optical resonator and one continuously rotating on a precision air bearing turntable. Special attention is paid to the control of rotation in
duced systematic effects. Within the photon sector of the Standard Model Extension, we obtain improved limits on combinations of 8 parameters at a level of a few parts in $10^{-16}$. For the previously least well known parameter we find $tilde kappa_{e-}^{ZZ} =(-1.9 pm 5.2)times 10^{-15}$. Within the Robertson-Mansouri-Sexl test theory, our measurement restricts the isotropy violation parameter $beta -delta -frac 12$ to $(-2.1pm 1.9)times 10^{-10}$, corresponding to an eightfold improvement with respect to previous non-rotating measurements.
This paper shows a novel method to precisely measure the laser power using an optomechanical system. By measuring a mirror displacement caused by the reflection of an amplitude modulated laser beam, the number of photons in the incident continuous-wa
ve laser can be precisely measured. We have demonstrated this principle by means of a prototype experiment uses a suspended 25 mg mirror as an mechanical oscillator coupled with the radiation pressure and a Michelson interferometer as the displacement sensor. A measurement of the laser power with an uncertainty of less than one percent (1 sigma) is achievable.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
