اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectrical-transport characteristics of as-grown and oxygen-reduced La$_{0.7}$Ce$_{0.3}$MnO$_3$ films: calculation of hopping energies, Mn valences, and carrier localization lengths
398
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Presently, cerium-doped LaMnO$_3$ is vividly discussed as an electron-doped counterpart prototype to the well-established hole-doped mixed-valence manganites. Here, La$_{0.7}$Ce$_{0.3}$MnO$_3$ thin films of different thicknesses, degrees of CeO$_2$ phase segregation, and oxygen deficiency, grown on SrTiO$_3$ single crystal substrates, are compared with respect to their resistance-vs.-temperature (R vs. T) behavior from 300~K down to 90~K. While the variation of the film thickness (and thus the degree of epitaxial strain) in the range between 10~nm and 100~nm has only a weak impact on the electrical transport, the degree of oxygen deficiency as well as the existence of CeO$_2$ clusters can completely change the type of hopping mechanism. This is shown by fitting the respective textit{R-T} curves with three different transport models (adiabatic polaron hopping, Mott variable-range hopping, Efros-Shklovskii variable-range hopping), which are commonly used for the mixed-valence manganites. Several characteristic transport parameters, such as the hopping energies, the carrier localization lengths, as well as the Mn valences are derived from the fitting procedures.
قيم البحث
اقرأ أيضاً
Films of cerium-doped LaMnO$_3$, which has been intensively discussed as an electron-doped counterpart to hole-doped mixed-valence lanthanum manganites during the past decade, were analyzed by x-ray photoemission spectroscopy with respect to their ma
nganese valence under photoexcitation. The comparative analysis of the Mn 3s exchange splitting of La$_{0.7}$Ce$_{0.3}$MnO$_3$ (LCeMO) films in the dark and under illumination clearly shows that both oxygen reduction and illumination are able to decrease the Mn valence towards a mixed 2$+$/3$+$ state, independently of the film thickness and the degree of CeO$_2$ segregation. Charge injection from the photoconductive SrTiO$_3$ substrate into the Mn e$_g$ band with carrier lifetimes in the range of tens of seconds and intrinsic generation of electron-hole pairs within the films are discussed as two possible sources of the Mn valence shift and the subsequent electron doping.
La$_{0.7}$Ce$_{0.3}$MnO$_3$ thin films of different thicknesses, degrees of CeO$_2$-phase segregation and oxygen deficiency, grown on SrTiO$_3$ single crystal substrates, were comparatively investigated with respect to both their spectral and tempera
ture-dependent photoconductivity (PC) and their magnetoresistance (MR) behaviour under photoexcitation. While as-grown films were insensitive to optical excitation, oxygen reduction appeared to be an effective way to decrease the film resistance, but the film thickness was found to play a minor role. However, from the evaluation of the spectral behaviour of the PC and the comparison of the MR of the LCeMO/substrate-samples with a bare substrate under illumination we find that the photoconductivity data reflects not only contributions from (i) photogenerated charge carriers in the film and (ii) carriers injected from the photoconductive substrate (as concluded from earlier works), but also (iii) a decisive parallel photoconduction in the SrTiO$_3$ substrate. Furthermore -- also by analyzing the MR characteristics -- the unexpected occurence of a strong electroresistive effect in the sample with the highest degree of CeO$_2$ segregation and oxygen deficiency could be attributed to the electroresistance of the SrTiO$_3$ substrate as well. The results suggest a critical reconsideration and possibly a reinterpretation of several previous photoconductivity and electroresistance investigations of manganite thin films on SrTiO$_3$.
Superlattices composed of ferromagnetics, namely La$_{0.7}$Ca$_{0.3}$MnO$_3$ (LCMO), and ferroelectrics, namely, BaTiO$_3$(BTO) were grown on SrTiO$_3$ at 720$^o$C by pulsed laser deposition process. While the out-of-plane lattice parameters of the s
uperlattices, as extracted from the X-ray diffraction studies, were found to be dependent on the BTO layer thickness, the in-plane lattice parameter is almost constant. The evolution of the strains, their nature, and their distribution in the samples, were examined by the conventional sin$^2psi $ method. The effects of structural variation on the physical properties, as well as the possible role of the strain on inducing the multiferroism in the superlattices, have also been discussed.
Cerium-doped manganite thin films were grown epitaxially by pulsed laser deposition at $720 ^circ$C and oxygen pressure $p_{O_2}=1-25 $Pa and were subjected to different annealing steps. According to x-ray diffraction (XRD) data, the formation of CeO
$_2$ as a secondary phase could be avoided for $p_{O_2}ge 8 $Pa. However, transmission electron microscopy shows the presence of CeO$_2$ nanoclusters, even in those films which appear to be single phase in XRD. With O$_2$ annealing, the metal-to-insulator transition temperature increases, while the saturation magnetization decreases and stays well below the theoretical value for electron-doped La$_{0.7}$Ce$_{0.3}$MnO$_3$ with mixed Mn$^{3+}$/Mn$^{2+}$ valences. The same trend is observed with decreasing film thickness from 100 to 20 nm, indicating a higher oxygen content for thinner films. Hall measurements on a film which shows a metal-to-insulator transition clearly reveal holes as dominating charge carriers. Combining data from x-ray photoemission spectroscopy, for determination of the oxygen content, and x-ray absorption spectroscopy (XAS), for determination of the hole concentration and cation valences, we find that with increasing oxygen content the hole concentration increases and Mn valences are shifted from 2+ to 4+. The dominating Mn valences in the films are Mn$^{3+}$ and Mn$^{4+}$, and only a small amount of Mn$^{2+}$ ions can be observed by XAS. Mn$^{2+}$ and Ce$^{4+}$ XAS signals obtained in surface-sensitive total electron yield mode are strongly reduced in the bulk-sensitive fluorescence mode, which indicates hole-doping in the bulk for those films which do show a metal-to-insulator transition.
The magnetic dead layers in films a few nanometers thick are investigated for La$_{0.7}$Sr$_{0.3}$MnO$_3$ on (001)-oriented SrTiO$_3$ (STO), LaAlO$_3$ (LAO) and (LaAlO$_3$)$_{0.3}$(Sr$_2$TaAlO$_6$)$_{0.7}$ (LSAT) substrates. An anomalous moment found
to persist above the Curie temperature of the La$_{0.7}$Sr$_{0.3}$MnO$_3$ films is not attributed to the films, but to oxygen vacancies at or near the surface of the substrate. The contribution to the moment from the substrate is as high as 20 $mu$B/nm$^2$ in the case of STO or LSAT. The effect is increased by adding an STO cap layer. Taking this d-zero magnetism into account, extrapolated magnetic dead layer thicknesses of 0.8 nm, 1.5 nm and 3.0 nm are found for the manganite films grown on LSAT, STO and LAO substrates, respectively. An STO cap layer eliminates the LSMO dead layer.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
