ترغب بنشر مسار تعليمي؟ اضغط هنا

Ultrafast Charge Transfer in Atomically Thin MoS2/WS2 Heterostructures

169   0   0.0 ( 0 )
 نشر من قبل Xiaoping Hong
 تاريخ النشر 2014
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Van der Waals heterostructures have recently emerged as a new class of materials, where quantum coupling between stacked atomically thin two-dimensional (2D) layers, including graphene, hexagonal-boron nitride, and transition metal dichalcogenides (MX2), give rise to fascinating new phenomena. MX2 heterostructures are particularly exciting for novel optoelectronic and photovoltaic applications, because 2D MX2 monolayers can have an optical bandgap in the near-infrared to visible spectral range and exhibit extremely strong light-matter interactions. Theory predicts that many stacked MX2 heterostructures form type-II semiconductor heterojunctions that facilitate efficient electron-hole separation for light detection and harvesting. Here we report the first experimental observation of ultrafast charge transfer in photo-excited MoS2/WS2 heterostructures using both photoluminescence mapping and femtosecond (fs) pump-probe spectroscopy. We show that hole transfer from the MoS2 layer to the WS2 layer takes place within 50 fs after optical excitation, a remarkable rate for van der Waals coupled 2D layers. Such ultrafast charge transfer in van der Waals heterostructures can enable novel 2D devices for optoelectronics and light harvesting.



قيم البحث

اقرأ أيضاً

It is important to study the van der Waals interface in emerging vertical heterostructures based on layered two-dimensional (2D) materials. Being atomically thin, 2D materials are susceptible to significant strains as well as charge transfer doping a cross the interfaces. Here we use Raman and photoluminescence (PL) spectroscopy to study the interface between monolayer graphene/MoS2 heterostructures prepared by mechanical exfoliation and layer-by-layer transfer. By using correlation analysis between the Raman modes of graphene and MoS2 we show that both layers are subjected to compressive strain and charge transfer doping following mechanical exfoliation and thermal annealing. Furthermore, we show that both strain and carrier concentration can be modulated in the heterostructures with additional thermal annealing. Our study highlights the importance of considering both mechanical and electronic coupling when characterizing the interface in van der Waals heterostructures, and demonstrates a method to tune their electromechanical properties.
Real-world quantum applications, eg. on-chip quantum networks and quantum cryptography, necessitate large scale integrated single-photon sources with nanoscale footprint for modern information technology. While on-demand and high fidelity implantatio n of atomic scale single-photon sources in conventional 3D materials suffer from uncertainties due to the crystals dimensionality, layered 2D materials can host point-like centers with inherent confinement to a sub-nm plane. However, previous attempts to truly deterministically control spatial position and spectral homogeneity while maintaining the 2D character have not been realized. Here, we demonstrate the on-demand creation and precise positioning of single-photon sources in atomically thin MoS2 with very narrow ensemble broadening and near-unity fabrication yield. Focused ion beam irradiation creates 100s to 1000s of mono-typical atomistic defects with anti-bunched emission lines with sub-10 nm lateral and 0.7 nm axial positioning accuracy. Our results firmly establish 2D materials as a scalable platform for single-photon emitters with unprecedented control of position as well as photophysical properties owing to the all-interfacial nature.
Electrons hopping in two-dimensional honeycomb lattices possess a valley degree of freedom in addition to charge and spin. In the absence of inversion symmetry, these systems were predicted to exhibit opposite Hall effects for electrons from differen t valleys. Such valley Hall effects have been achieved only by extrinsic means, such as substrate coupling, dual gating, and light illuminating. Here, we report the first observation of intrinsic valley Hall transport without any extrinsic symmetry breaking in the non-centrosymmetric monolayer and trilayer MoS2, evidenced by considerable nonlocal resistance that scales cubically with local resistance. Such a hallmark survives even at room temperature with a valley diffusion length at micron scale. By contrast, no valley Hall signal is observed in the centrosymmetric bilayer MoS2. Our work elucidates the topological quantum origin of valley Hall effects and marks a significant step towards the purely electrical control of valley degree of freedom in topological valleytronics.
Van-der-Waals heterostructures show many intriguing phenomena including ultrafast charge separation following strong excitonic absorption in the visible spectral range. However, despite the enormous potential for future applications in the field of o ptoelectronics, the underlying microscopic mechanism remains controversial. Here we use time- and angle-resolved photoemission spectroscopy combined with microscopic many-particle theory to reveal the relevant microscopic charge transfer channels in epitaxial WS$_2$/graphene heterostructures. We find that the timescale for efficient ultrafast charge separation in the material is determined by direct tunneling at those points in the Brillouin zone where WS$_2$ and graphene bands cross, while the lifetime of the charge separated transient state is set by defect-assisted tunneling through localized sulphur vacanices. The subtle interplay of intrinsic and defect-related charge transfer channels revealed in the present work can be exploited for the design of highly efficient light harvesting and detecting devices.
We measured the work of separation of single and few-layer MoS2 membranes from a SiOx substrate using a mechanical blister test, and found a value of 220 +- 35 mJ/m^2. Our measurements were also used to determine the 2D Youngs modulus of a single MoS 2 layer to be 160 +- 40 N/m. We then studied the delamination mechanics of pressurized MoS2 bubles, demonstrating both stable and unstable transitions between the bubbles laminated and delaminated states as the bubbles were inflated. When they were deflated, we observed edge pinning and a snap-in transition which are not accounted for by the previously reported models. We attribute this result to adhesion hysteresis and use our results to estimate the work of adhesion of our membranes to be 42 +- 20 mJ/m^2.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا