اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSurface phonons in two-layer thin films of GeSe
265
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This paper presents ab inition calculations of the surface phonon spectra of GeSe layered semiconductor compound, based on the Density Functional Perturbation Theory (DFPT). The surface has been imitated by a structure of periodically arranged slabs of two layers of GeSe crystal separated from other identical layers by the layers of vacuum sufficiently wide to ignore the effect of the upper boundary of the double-layer upon its lower boundary. We discuss the character of the surface modes located in the gaps, in the pockets, and in the area of allowed phonon states for the bulk GeSe crystals, as well as outside (above and below) the boundaries of the bulk phonon states.
قيم البحث
اقرأ أيضاً
Understanding microscopic heat conduction in thin films is important for nano/micro heat transfer and thermal management for advanced electronics. As the thickness of thin films is comparable to or shorter than a phonon wavelength, phonon dispersion
relations and transport properties are significantly modulated, which should be taken into account for heat conduction in thin films. Although phonon confinement and depletion effects have been considered, it should be emphasized that surface-localized phonons (surface phonons) arise whose influence on heat conduction may not be negligible due to the high surface-to-volume ratio. However, the role of surface phonons in heat conduction has received little attention thus far. In the present work, we performed anharmonic lattice dynamics calculations to investigate the thickness and temperature dependence of in-plane thermal conductivity of silicon thin films with sub-10-nm thickness in terms of surface phonons. Through systematic analysis of the influences of surface phonons, we found that anharmonic coupling between surface and internal phonons localized in thin films significantly suppresses overall in-plane heat conduction in thin films. We also discovered that specific low-frequency surface phonons significantly contribute to surface--internal phonon scattering and heat conduction suppression. Our findings are beneficial for the thermal management of electronics and phononic devices and may lead to surface phonon engineering for thermal conductivity control.
Two-dimensional (2D) surface of the topological materials is an attractive channel for the electrical conduction reflecting the linearly-dispersive electronic bands. By applying a reliable systematic thickness t dependent measurement of sheet conduct
ance, here we elucidate the dimensionality of the electrical conduction paths of a Weyl semimetal Co3Sn2S2. Under the ferromagnetic phase, the 2D conduction path clearly emerges in Co3Sn2S2 thin films, indicating a formation of the Fermi arcs projected from Weyl nodes. Comparison between 3D conductivity and 2D conductance provides the effective thickness of the surface conducting region being estimated to be approximately 20 nm, which is rather thicker than 5 nm in topological insulator Bi2Se3. This large value may come from the narrow gap at Weyl point and relatively weak spin-orbit interaction of the Co3Sn2S2. The emergent surface conduction will provide a pathway to activate quantum and spintronic transport features stemming from a Weyl node in thin-film-based devices.
We report experiments to determine the effect of radiation damage on the phonon spectra of the most common nuclear fuel, UO$_2$. We have irradiated thin ($sim$ 300 nm) epitaxial films of UO$_2$ with 2.1 MeV He$^{2+}$ ions to 0.15 dpa and a lattice sw
elling of $Delta$a/a $sim$ 0.6 %, and then used grazing-incidence inelastic X-ray scattering to measure the phonon spectrum. We succeeded to observe the acoustic modes, both transverse and longitudinal, across the Brillouin zone. The phonon energies, in both the pristine and irradiated samples, are unchanged from those observed in bulk material. On the other hand, the phonon linewidths (inversely proportional to the phonon lifetimes), show a significant broadening when comparing the pristine and irradiated samples. This effect is shown to increase with phonon energy across the Brillouin zone. The decreases in the phonon lifetimes of the acoustic modes are roughly consistent with a 50 % reduction in the thermal conductivity.
Graphene is a 2D material that displays excellent electronic transport properties with prospective applications in many fields. Inducing and controlling magnetism in the graphene layer, for instance by proximity of magnetic materials, may enable its
utilization in spintronic devices. This paper presents fabrication and detailed characterization of single-layer graphene formed on the surface of epitaxial FeRh thin films. The magnetic state of the FeRh surface can be controlled by temperature, magnetic field or strain due to interconnected order parameters. Characterization of graphene layers by X-ray Photoemission and X-ray Absorption Spectroscopy, Low-Energy Ion Scattering, Scanning Tunneling Microscopy, and Low-Energy Electron Microscopy shows that graphene is single-layer, polycrystalline and covers more than 97% of the substrate. Graphene displays several preferential orientations on the FeRh(001) surface with unit vectors of graphene rotated by 30{deg}, 15{deg}, 11{deg}, and 19{deg} with respect to FeRh substrate unit vectors. In addition, the graphene layer is capable to protect the films from oxidation when exposed to air for several months. Therefore, it can be also used as a protective layer during fabrication of magnetic elements or as an atomically thin spacer, which enables incorporation of switchable magnetic layers within stacks of 2D materials in advanced devices.
The use of oxide materials in oxide electronics requires their controlled epitaxial growth. Recently, it was shown that Reflection High Energy Electron Diffraction (RHEED) allows to monitor the growth of oxide thin films even at high oxygen pressure.
Here, we report the sub-unit cell molecular or block layer growth of the oxide materials Sr2RuO4, MgO, and magnetite using Pulsed Laser Deposition (PLD) from stoichiometric targets. Whereas for perovskites such as SrTiO3 or doped LaMnO3 a single RHEED intensity oscillation is found to correspond to the growth of a single unit cell, in materials where the unit cell is composed of several molecular layers or blocks with identical stoichiometry, a sub-unit cell molecular or block layer growth is established resulting in several RHEED intensity oscillations during the growth of a single unit-cell.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
